Question about 1995 Mitsubishi Mighty Max

1 Answer

Surging I have a 1995 Mighty Max that idles good and when sitting still can give it all the gas you want but when driving (manual transmission) the least amount of acceleration will cause the truck to surge like the gas is going to engine then being cut off to the engine. Any suggestions? Thanks, David

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 297 Answers

A lot.
Fuel cut off valve
Wire harness
Pump.
Etc..

Posted on Apr 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change the transmission fluid on a 1992 Mitsubishi Mighty Max as well as the filter? Is the fuel filter in the gas tank?


(I don't know anything about cars)--Your Statement

It had been sitting for years (that is not good)

Best you take it to a local shop then

Dec 02, 2014 | 1992 Mitsubishi Mighty Max

1 Answer

Mitsubishi Mighty Max 92 needs to be trouble shot. Started up after sitting for an extended period of time, what parts were affected. It dosnt want to shift or drive really


I recommend changing out your transmission fluid, make sure you replace the screen too. After a vehicle have set for a long period of time it s good to flush all the fluids if you did replace them prior to the vehicle being stored.

Dec 02, 2014 | 1992 Mitsubishi Mighty Max

1 Answer

I need a new transmission for my 96 Mighty Max Truck it has a manual transmission what other years are compatable??


If it is grinding you can just get new sincronizers for it,You may have a bent shift fork.

Mar 20, 2013 | 1996 Mitsubishi Mighty Max

1 Answer

1994 Mitsubishi Mighty Max, 2.4 injected. Truck would start but idle way up then down almost stalling. After warmed up it would idle decent and drive, but under load it had no "pull" and...


Hello brian..these are great little trucks, i have a 87 (hitachi carb) with over 300k on it---still going strong and gets good mileage. Sounds like a fuel delivery problem on yours--- You can test the fuel pressure and the pressure regulator with a manual gauge...autozone has loaner tools if you dont have a fuel pressure tester. You should have aprox 36 psi ---remove the vacuum line on the pressure regulator with the engine running, the pressure should come up about 5-10psi, if it dont the regulator is bad. (Make sure there is vacuum on that hose) Make sure the MAF sensor is clean, if dirty clean it with MAF sensor cleaner, don't use brake cleaner.

Check for vacuum leaks around the manifold and emissions hoses...a good way to do this is with carb cleaner...spray it on the areas you are checking, it engine rpm change, you found the leak.
Also check the coolant temperature sensor, if it is out of range it will send a false signal to the engine controller, the controller will not open the injector circuit to squirt enough fuel under a load.

I hope this helps & good luck with your mighty max.

Aug 27, 2011 | 1995 Mitsubishi Mighty Max

1 Answer

Will a chevy s-10 motor work in a 85 mitsubishi mighty max


Not without using the chevy transmission (and transfer case if it's a 4WD Mighty Max), Custom Motor Mounts, Custom Transmission Mount, Wiring Modifications, Driveshaft Modifications (either lengthened or shortened, depending on where the transmission or transfer case is located). Possibly shifter hole modifications (if it's a 5-Speed Manual), or Custom Linkage/Linkage Modifications (If it's an Automatic)

Aug 21, 2011 | 1985 Mitsubishi Mighty Max

1 Answer

Why does the wheel on my mighty max not wanna come off?


Sometimes they just seize a bit I had the same problem with an 05 neon. You just have to get a little aggressive with it give it a good hard tap all around the outer edge of the rim and it should come off.

Feb 05, 2011 | 1995 Mitsubishi Mighty Max

1 Answer

When i start my 1990 mitsubishi mighty max pick up , it will idle , but when i give it gas it bogs down ?


it may be the cataltic converter pluged start it and give it gas for a few minutes and see if it gets cherry red underneath

Dec 29, 2010 | 1990 Mitsubishi Mighty Max

1 Answer

My mighty max idles around 2000 rpm's. I tried adjusting the idle control, the spring on the intake that has a screw and the screw on the top of the unit. It still revs vary high. what else can cause it to...


Not working tachometer,mileage-meter,cruise control,kick down button,speeds have to push manual,model is an TLC-HDJ-81 1HD-T.AT- A442F.Where is computer unit what drive the AT.Is it possible everything comes from it??? Please,help me,i'm from Bulgaria,not so many SUV from this model here.
Comments: Nov 30, 2009 - Dear sir,i don't know where this sender stay.All connectors on AT is well fit it,but where from it comes-don't know.Also engine is start in"D",or"3","2",and "R" position,not only in "N" or "P".When i change gears manually-the car drive very good. Nov 30, 2009 - Engine oil is Polytron 5W40,in 3K km.Have change oil and filter in gear case before 6K km.I don't know where electric unit is stay to see the connectors and check it.Thank you very.

Nov 30, 2009 | 1995 Mitsubishi Mighty Max

1 Answer

What is the ignition timing for a 1995 mitsubishi mighty max?


In your owners manual.
If not about 5 degrees on most cars.
You need a stob light and chalck to check running.
Vacuum and distributor working properly.

Mar 06, 2009 | 1995 Mitsubishi Mighty Max

Not finding what you are looking for?
1995 Mitsubishi Mighty Max Logo

Related Topics:

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...