Question about Cars & Trucks

Open Question

2h edic motor wiring diagram - Cars & Trucks

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a '08 Ford F150 FX4. Recently I had to use my 4 H for a short drive. I had no issues until a couple of days later, when I notice a rattling noise in 2H, which sounded like a rattling noise si

If it isn't a heat shield or something like that,
then your pulling the transfer & taking it apart

Google your transfer mfg case or unit number & see what
problems come up

Call this place
They have a web site


Mar 11, 2014 | Cars & Trucks

1 Answer

4.0 2H HJ 75 land cruiser

diagram of what, inside, outside, mech, vacuum, electrical or what?
complex it is. EFI?, has it
so does the FSM , ebay buy use FSM , factory service manual.

Jan 21, 2014 | 1989 Toyota Land Cruiser

1 Answer

Glow plugs not working hj75 landcrusier after changed alternator to internal.

recheck the connections some connection loose, bad contacts, use the VOM for some wires open or break. with alternator/ignition see the diagram attached. If the problem persist RUN the scanner/computer for easy diagnostic and fix it.
God bless you1296522e-9e5b-4a24-a456-0e10ac38d8f2.jpg

Jul 12, 2013 | Cars & Trucks

1 Answer

Flasher relay on HJ60 24 volt keeps burning

Check for a grounded wire somewhere in that circuit. This happens most often when something was added like an AMP or Alarm and power is tapped from that circuit causing it to have too much current pulled through it.

Nov 20, 2011 | 1986 Toyota Land Cruiser

2 Answers

Edic: the cluster abs, traction lights come on

check to see if the cover is tied or the cover is placed right water or humdity may be going in tape it up

Jan 11, 2010 | 1999 Lexus Gs 300

1 Answer

2004 Navigator stuck in 4wd Low although 2H is selected. Air suspension continuously raising

Most often this is a bad shift motor. Fords are known for this. The shift motor is mounted on the transfer case. It's a pretty easy replacement--usually only 4 bolts. The only bug is that the motor is internally grounded inside the transfer case. So when you install the new motor, you'll have to either move the existing ground wire to the new electrical connector or solder it into the new ground. You can get aftermarket motors for about $125. Relatively easy fix. Something you can do yourself with a shop manual and ordinary metric sockets.

This not my information I found it on another forum, hope it helps

Jan 05, 2009 | 2005 Lincoln Town Car

1 Answer

Cant deactivate d 4wheel gear of nissan exterra frm 4H gear to 2H

check vacuum diagram see if any pit hoes are in it also check hoses that connect to it are broken

Dec 28, 2008 | 2001 Nissan Xterra

4 Answers

Heater blower motor sometimes works

where is the motor as i think its burnt out.

Nov 11, 2008 | 1999 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides