Question about Cars & Trucks

Open Question

Sensor magnet location 2001 chrysler sebring 2.4 DOHC

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: Crank sensor and camshaft sensor

The crank sensor is in the top of bell housing of the transmission towards the back of the engine compartment. The cam sensor is built into the distributor.

Posted on Mar 07, 2009

Ad
Molson02536
  • 3854 Answers

SOURCE: camshaft position sensor

This V-6 has a very hard to find/hard to reach CKP - it is directly under the Distributor, about 4 inches below, inwards toward the Transaxle "bell". Almost dead-center in the back of the engine.
Your going to have to take the Air Filter and the air manifold that runs to the engine off. After that, take off the horn assembly to gain very, very limited access to wedge an extended ratchet into the bowels of the engine. 
I think the same socket that undid the horn assembly fit the CKP nut. It takes 10 minutes to undo the bolt a couple ratchet clicks at a time, at least 15 to get the thing to wiggle out, probably 15 minutes to unconnect, reconnect, and snap back to the fram the wire harness, and at least another 10 minutes to ratchet the bolt back in click by click.

Now you know why they say shops charge $500 in to do this - I think they must take the entire engine out... Very painstaking job that requires patience and precision... but quite satisfying to finish it yourself. 

Good luck and hope this helps, 

Posted on Apr 23, 2009

  • 1 Answer

SOURCE: Where is the crankshaft position sensor located?

the crankshaft position senor on the 2.2L is located on the rear right side of the engine block

Posted on Jul 07, 2009

ZJLimited
  • 17970 Answers

SOURCE: how many oxygen sensors in a 2001 chrysler sebring

17c3292.jpg

Fig. Heated Oxygen (HO2S) location (sensor 1)-2.4L engine

db6f426.jpg

Fig. Heated Oxygen (HO2S) location (sensor 2)-2.4L engine

99e413c.jpg

Fig. Heated Oxygen (HO2S) location (bank 1, sensor 2) (bank 2, sensor 2)-2.7L engine

e2a250f.jpg

Fig. Heated Oxygen (HO2S) location (bank 2, sensor 1)-2.7L engine

I hope help you with this (rated this help). Good luck.

Posted on Sep 09, 2009

01fordeb
  • 1033 Answers

SOURCE: oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

Posted on Jan 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Belt routing for 2001 Sebring 2.4 engine


Jeff, Check the attached links for your 2.4 belt routing,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Repair Guides Engine Mechanical Components Accessory Drive Belts 2...
How to Change Serpentine Belt on 2002 Chrysler Sebring
http://www.serpentinebeltdiagram.com/serpentine-belt-diagram-2001-chrysler-sebring-4-cylinder-24-liter-engine-alternator-and-air-conditioner-with-dohc-engine-02236

Jul 31, 2016 | Cars & Trucks

1 Answer

The location of the map sensor on a 1996 chrysler convertible sebring jx 2.4 engine


1996 Chrysler Sebring Convertible 2.4L SFI DOHC 4cyl

The MAP Sensor is located: Under hood, center, lower engine area, passenger side of engine, mounted behind alternator

25852880-d2xccmsr3fz4kuvb3ps3pyax-1-0.jpg

Sep 06, 2015 | Chrysler Cars & Trucks

1 Answer

Location & aprox. price for oxygen sensor bank 1, on a chrysler sebring 2004, 2.4liter, dohc, non-convertible?


A four cyl engine only has one bank. So in your case bank one sensor one is in front of the catalytic converter, and sensor two is after the cat.
The sensor can cost from $25 to $85 dollars depending on which one and your location.
Keep in mind the code 420 can be caused by other factors than the O2 sensors.

Feb 21, 2013 | 2004 Chrysler Sebring

1 Answer

2004 chrysler sebring 2.4l dohc.


Have you ever replaced the timing belt?? If not the problem is likely to be a loose worn out timing belt. A floppy belt will play havoc with the sensor signals and trigger a check engine light and a camshaft sensor code.

Jun 22, 2012 | 2002 Chrysler Sebring

2 Answers

How many oxygen sensors does a 2001 Chrysler Sebring have with the 2.7 liter engine


It has two sensors...

Check the below link for pictures

http://www.fixya.com/cars/t2915557-many_oxygen_sensors_in_2001_chrysler

Aug 30, 2010 | 2001 Chrysler Sebring

2 Answers

Tire specs for 2001 chrysler sebring


HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.


2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16

Jul 06, 2010 | 2001 Chrysler Sebring

2 Answers

How many oxygen sensors in a 2001 chrysler sebring 3.0


17c3292.jpg

Fig. Heated Oxygen (HO2S) location (sensor 1)-2.4L engine

db6f426.jpg

Fig. Heated Oxygen (HO2S) location (sensor 2)-2.4L engine

99e413c.jpg

Fig. Heated Oxygen (HO2S) location (bank 1, sensor 2) (bank 2, sensor 2)-2.7L engine

e2a250f.jpg

Fig. Heated Oxygen (HO2S) location (bank 2, sensor 1)-2.7L engine

I hope help you with this (rated this help). Good luck.

Sep 09, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...