Question about 2007 BMW X3 3.0si SAV

Open Question

Relay l;ocations for bmw x3 2005

Rear washer/wiper relay location neither work

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

txkjun
  • 409 Answers

SOURCE: radio, windsheild wipers, power locks

The best thing to do is tuen the key on and teat all the fuses with a 12 volt test light. Replace any fuse that test bad.

Posted on Feb 15, 2009

  • 208 Answers

SOURCE: BMW (E39)520SE 08/2001 Auto Touring. Rear

after making sure your fuses are ok, go in the trunk and behind the access cover where the battery is located. above the battery should be a fuse panel, which may be hidden under the insulation trim, there should be some fuses and relays there. the relay closest to the rear of the car is probably the relay you are looking for. you can try swapping it with another relay in the panel if the relays are the same. bmw always puts a part number on their relays. i would start with checking the fuses and relay first.

Posted on Mar 21, 2009

emissionwiz
  • 75066 Answers

SOURCE: Rear wiper and washer of BMW 5 E39 not working

no way to test without the factory scan tools.

Posted on Mar 19, 2009

  • 1 Answer

SOURCE: Rear wiper and washer of BMW 5 E39 not working

I had the same problem. I thought it was an issue with a blown fuse, but also noticed that the rear wiper was very stiff.
I solved it by opening the rear window (so the wiper is not clicked into the motor) then squirt some WD40 into the wiper mechanism (I put the oil in from the outside). Gently move the wiper from side to side until it starts to free up - after a couple of movements the wiper should be moving freely again. No issues since.

At the same time, check that the washer jet is correctly angled. Mine was squirting directly into the wiper which may have caused it to rust up a bit.


Posted on Sep 13, 2009

  • 1 Answer

SOURCE: need to no where the rear windscreen relay swicth

Where exactly is the rear wiper relay in an X3??

Posted on May 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the rear wiper fuse located for a 2004 BMW X5


F81 20 Amp Rear wiper and washer fuse located in Rear cargo compartment panel on right side.

Also check F41 5 Amp Rear wiper control module fuse location above glove box

Dec 24, 2016 | BMW X5 Series Cars & Trucks

1 Answer

Buick enclave front wipers work only on high speed.


What year ? The relay's are located in the under hood fuse box .
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the underhood fuse block. Refer to Wiper/Washer Schematics. Which wipers are you talking about ? Front or rear . Rear wiper fuse is in the I/P instrument panel fuse box .
Fuse Block - I/P
Under the lower right side of the instrument panel

Nov 19, 2016 | Buick Enclave Cars & Trucks

1 Answer

2009 Saturn Vue. Rear Wiper and Washer both stopped working at same time.


FUSE...RELAY...CIRCUIT BREAKER...OR WIRING! WITH REAR WIPER SQUITER SWITCH ENGAGED,,,CHECK FOR VOLTAGE AT HARNESS CONNECTOR

Feb 09, 2013 | 2009 Saturn VUE

1 Answer

Need to no where the rear windscreen relay swicth


Where exactly is the rear wiper relay in an X3??

Feb 21, 2010 | 2009 BMW X5

3 Answers

My front windscreen wipers on my BMW mini are not working - fuses are fine, back wiper and washers ok too. Just front wipers - is the likely problem a relay?


You actually have a wiper relay this should assist you swap with another see if functions
Service and Repair
The wipers are controlled by two relays, located in the engine compartment fuse box.
These are wired in such a way that one relay will run the wiper when energized, and stall it when de-energized (Front Wiper-Run/Park Relay).
The other will select either fast or slow speed on the wiper motor (Front Wiper-Fast/ Slow Relay).

Jan 03, 2010 | 2001 Mini Cooper

1 Answer

Rear wiper and washer of BMW 5 E39 not working


I had the same problem. I thought it was an issue with a blown fuse, but also noticed that the rear wiper was very stiff.
I solved it by opening the rear window (so the wiper is not clicked into the motor) then squirt some WD40 into the wiper mechanism (I put the oil in from the outside). Gently move the wiper from side to side until it starts to free up - after a couple of movements the wiper should be moving freely again. No issues since.

At the same time, check that the washer jet is correctly angled. Mine was squirting directly into the wiper which may have caused it to rust up a bit.


Jun 01, 2009 | 2001 BMW 5 Series

2 Answers

The rear wiper on my '99 model exped isnt working ,ford global says its the motor and it will cost me P13k . any one who can help me find a mechanic do some repair on this?


what is P13K?

check the fuse first. dealer can hook up NGS Tester and get fault codes to see what is wrong.

Principles of Operation
NOTE: The generic electronic module (GEM) will not activate the rear wiper system if either the liftgate or the liftgate glass is ajar. If either the liftgate or the liftgate glass becomes ajar while the rear wiper is in operation, the GEM will park the rear wiper motor.
There are two distinct modes of wiper operation:
  • Off Mode: In this mode, there is no rear wiper activity, and the wiper motor will be in the PARK position.
  • Interval Mode: This mode is selected when the rear wiper switch is in either the Interval 1 or 2 position. When this mode is selected, the rear wiper motor is driven up onto the glass by activating the rear wiper UP relay. When the wiper motor HIGH/LOW/PARK position input reaches the high position, the UP relay is deactivated and the DOWN relay is activated to reverse the wiper motor direction. When the wiper motor reaches the LOW position, as determined by the HIGH/LOW/PARK position input, the GEM deactivates the DOWN relay and will begin a new wiper cycle 1 to 10 seconds later, depending on the interval position selected.
To engage the rear window washer, rotate the rear window washer selector downward to the WASH position. The rear window wiper will run as long as the WASH position is selected. When the rear window washer selector returns to the OFF, INT 1 or INT 2 position, the washer will stop immediately, but the rear window wiper will continue for two to three sweeps and then return to its previous mode of operation.
The low washer fluid indicator chime warns that the washer fluid level is low. The low washer fluid indicator chime is a single tone with a duration of one second. The chime will sound when the low washer fluid indicator is initially activated.
The low washer fluid indicator warns that the fluid level in the washer reservoir is low. The low washer fluid indicator will illuminate when the washer fluid level is low and the ignition switch is in the RUN position.
The low washer fluid indicator will deactivate when the washer fluid reservoir is filled and the ignition switch has been cycled from RUN to OFF, then to RUN.
Inspection and Verification
  1. The wiper/washer system is a generic electronic module (GEM) controlled system; refer to Section 419-10 .
  1. Verify the customer concern by operating the wiper/washer system.
  1. Visually inspect for obvious signs of mechanical and electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Hoses to windshield washer pump
  • Wiper linkage
  • Fuses 6 (5A), 8 (5A), 15 (5A), and 20 (5A)
  • Wiring harness
  • Loose or corroded connector(s)
  • Relays
  • Motors
  • Multifunction switch
  • Washer fluid level switch


----------------------------------------
  • The wipers are inoperative — rear
  • Fuses 6 (5A), 8 (5A), 15 (5A), and 20 (5A).
  • Circuitry.
  • GEM.
  • Multifunction switch (wiper/washer switch).
  • Rear wiper up relay.
  • Rear wiper down relay.
  • Rear wiper motor.

May 12, 2009 | 1999 Ford Expedition

1 Answer

Rear wiper and washer of BMW 5 E39 not working


no way to test without the factory scan tools.

Mar 19, 2009 | 2001 BMW 5 Series

1 Answer

BMW (E39)520SE 08/2001 Auto Touring. Rear wiper/washer has failed. I have located a replacement wiper motor but understand that 'the relay' is also prone to failure. I've still got the fuses to...


after making sure your fuses are ok, go in the trunk and behind the access cover where the battery is located. above the battery should be a fuse panel, which may be hidden under the insulation trim, there should be some fuses and relays there. the relay closest to the rear of the car is probably the relay you are looking for. you can try swapping it with another relay in the panel if the relays are the same. bmw always puts a part number on their relays. i would start with checking the fuses and relay first.

Mar 17, 2009 | 2001 BMW 5 Series

1 Answer

Windshield wipers


From your owners manual:

Fuse#11 30A , Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

U will also need to check the relays if the fuse is ok, the relay, it is the underhood fuse box
Relay #202 — Front Wiper Run/Park Relay

Dec 18, 2008 | 2001 Lincoln Navigator

Not finding what you are looking for?
2007 BMW X3 3.0si SAV Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...