Question about 1997 Nissan Pathfinder
I had a code of P0446 vapor canister, I replaced the canister and cleared the code. I drove my truck 170 miles when check engine light came on. The P0446 code was gone but Im getting two codes P0130 oxygen sensor circuit bank 1 Sensor 1 and P1447 evap purge flow monitor. Anyone experenced these codes and what did you do to repair them,thanks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: O2 sensor and EVAP issues
P0446 is Aux Emission Control
P0132 Fuel Air Metering
The Evap Canister is located in the fender well, if I am not mistaken and the B1S2 is the O2 sensor is the second O2 sensor on the left side of the engine if your looking at it from the front of the motor.
Posted on Aug 23, 2008
A qualified repair shop wil need to check these codes and recommend repairs. a scanner and a manual will be needed for diagnosis.
Posted on Oct 17, 2009
SOURCE: I have a code P1447
My experience with my own 97 Pathfinder was that the EVAP canister internally ruptured, spreading charcoal pellets throughout connected portions of the vacuum system.
The tech replaced the EVAP canister and blew lines out with compressed air, but the P1447 code came back.
A few weeks later I had the tech check why the P1447 code came back, and he determined that the EVAP Canister Purge Volume Control Solenoid Valve had failed, as it did not pass certain resistance measurement tests. He replaced the valve, $288 + labor, blew a few remaining carbon bits out, and the problem seems to be fixed.
I kind of choked at the $288 price though, and took the part home. Two screws to pop it open. Turns out it was filled (surprise) with pulverized charcoal dust and would not operate.
The valve is a little rotating magnet that turns and screws a lipstick-style plunger up and down. I tapped out all the carbon and then started turning the bearings, which were crunchy sounding. However, the carbon eventually gave way to the bearings and they're spinning just fine now. I haven't tested the part, but from the simplicity of it, I have no doubt it would get me down the road many more miles.
Posted on Feb 02, 2011
Tips for a great answer:
Dec 18, 2015 | Cars & Trucks
Feb 03, 2014 | 1998 Chevrolet Chevrolet silverado
May 22, 2011 | 2000 Ford Expedition
Apr 23, 2011 | 2008 GMC Envoy
Aug 16, 2009 | 1998 Lexus Gs 400
Apr 23, 2009 | 2004 Lexus LS 430
Apr 11, 2009 | 2002 Chevrolet Tahoe
Jan 29, 2009 | 1999 Lexus ES 300
76 people viewed this question
Usually answered in minutes!