Question about 1999 Ford Taurus

Open Question

Vacuum line diagram for 2000 ford tarus

I have a vacuum line loose on the left side of the firewall going back toward the center of car.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: 2001 ford taurus . i need the vacuum diagram so i

you can try your local library for a diagram and pictures showing you how you can also try this website:

Posted on Mar 08, 2009

  • 124 Answers

SOURCE: 1987 Ford Ranger 2.0 Liter Vacuum Line Diagram

can you see the diagram under the hood? if not try searching a junkyard for either the diagram or a complete motor

Posted on Mar 23, 2009

  • 91 Answers

SOURCE: 1998+ford van 150+brake lines+diagram

I only replace what is needed they are time consuming and all four breaks will need to be bleed only diagram is what you have under the van cut out the damaged section take it to parts store and get the size you need make sure you get all fitting at this time also good luck

Posted on Apr 28, 2009

SOURCE: emissions/vacuum lines

Check the library,they have books that can need the engine size,manual or automatic trans,and engine calibration number,on the valve cover
(if it is there)

Posted on Oct 07, 2009

  • 168 Answers

SOURCE: vacuum line diagram for 1998 windstar

look on the engine compartment either on the finder or the hood

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel line diagram

you may have the wrong line.. its probably a vent hose..not a supply line..take the hose loose and blow air pressure into the tank.. if no gas comes out, its a vent line..

Dec 25, 2013 | Ford Mustang Cars & Trucks

1 Answer

I have a 2000 F350 ford my defrost and AC works but it stay on defrost it won't blow out my dash vent

You have a vacuum leak..The lines that usually break are on the passenger side under the hood they go toward the firewall..Check that first..If nothing found youll have to back track under the dash

Sep 05, 2011 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Gasoline smell coming from my ac vents 2000 ford tarus

Sounds like you got yourself a gas leak towards the front of the car. Turn the car on and check the supply and return lines in the engine bay. Next check the fuel rails. Finally look around the injectors.

Sep 12, 2010 | 1994 Ford Taurus

1 Answer

Air not coming thought front vents only from top on 2000 ford windstar

ave you had any recent work done under the hood, or with wiper cowl etc.. reason being there is a main vacuum line that goes to a check valve just left and above belt tensioner that would cause loose of main vacuum to your climate control sysem, and fords fails safe is default to defrost, let me know details or how you make out

more details for location left side by serpinttine belt follow belt back from alternator to the tensioner just left is air inlet housing for climate control system and mounted to it is two vacuum lines on goes through firewall and other comes from engine area

Jul 25, 2010 | 2000 Ford Windstar

2 Answers

Where is the mass air flow sensor p0171 code

Hi Friend:

Your Mass Air Sensor is Located on the Back Side of your Engine ,Theres a Tube or Hose that runs almost center of your Engine back side of Intake, And Down Toward your Transmission Bell Housing, I'm Going to Put a Diagram here so you can See.What i'm Talking About:

Look to the Left of Diagram You'll see it.

Let me Know If and How I've Helped you by Voting and a Small Testamony would be Appreciated.

Thank You for Using FIZYA From d_hubbs

Jul 11, 2010 | 2000 Mercury Sable

1 Answer

Water collecting in driver side pass. compmnt - AC cndnsr drain?

Clogged AC drain hose.

You can see it by opening the hood and looking towards the back firewall.
Its a short black drain hose and will have a good rust spot under it.
To see it in the car you need to remove you dash. Lower your dash. Remove the screw on the right side and you can pull your dash out. The drain hose is located in the upper left side near the center hub and right near the engine firewall. Its a 6 inch black hose with a few bends and stubs out through a hole into the engine compartment. You can easily pull it out. and stick a short screwdriver up into the drain pan to clean it out.

Aug 17, 2009 | Toyota Camry Cars & Trucks

1 Answer

Need firing order diagram for a 1982 ford f350

On the straight 4.9 liter 6 cylinder the firing order is 1-5-3-6-2-4 The cylinder from the radiator to the firewall is 1-2-3-4-5-6  The distributor rotates clock wise, (to the right) #1 is towards the brake booster and going clockwise to the right is #5 Ect
On the 6.6 liter V8 the firing order is 1-3-7-2-6-5-4-8 The cylinder on the passenger side radiator to firewall 1-2-3-4 The cylinder on the drivers side radiator to the firewall 5-6-7-8 The distributor rotates anti clockwise (to the left) #1 is towards the cylinder #5 going anti clockwise #3 to the left and towards cylinder #1 Ect.
Good luck and keep me posted, be glad to help. 

Jun 25, 2009 | 1982 Ford F 350

1 Answer

Can not find low pressure service port, found two on high side ?

follow the lines coming out of the compressor the bigger line going from the compressor to the firewall is the low side,it may be on the compressor or back toward the firewall

Apr 28, 2009 | 2000 Jeep Wrangler

2 Answers

How to add freon in 2002 Ford Tarus? Where is the low pressure port loacated"

hi bighobo,

first, locate the bigger hose that comes out of your compressor that goes to your firewall towards the evaporator, that is the suction hose. look for some fittings that comes out of that pipe and covered by a plastic cap. that is the pressure port where you can add freon.

i hope i solve your problem..
tnx pls rate me


Jul 19, 2008 | 2002 Ford Explorer Sport

Not finding what you are looking for?
1999 Ford Taurus Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides