Question about 1997 Subaru Outback

Open Question

Location of voltage regulator in 1997 subaru legacy

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
autodr
  • 260 Answers

SOURCE: 2005 Subaru Legacy: Where are the O2 sensors located (both)

the o2 sensors are locted in the exhaust system. upstream is before cat converter, downstream is after cat converter.

Posted on Nov 22, 2008

Ad
peidavey
  • 14 Answers

SOURCE: 97 Subaru Legacy GT Alternator Voltage Output

Battery is probably on it last legs... alternator sounds normal.

Posted on Dec 26, 2008

mcgyver468
  • 710 Answers

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Posted on Apr 24, 2009

jeffbvegas1
  • 520 Answers

SOURCE: how much should it cost to replace a clutch on a

5 hrs labor (avg 80 per hr) = $400 Parts(including bearing,bushing,disc and cover) $350 ...add tax,shop fees and misc >>$800 total

Posted on Aug 08, 2009

Wolfman304
  • 720 Answers

SOURCE: 1997 subaru legacy outback knock sensor location

Hiya,

Here you go:

2.5L Engine To Remove:

  1. Disconnect the battery ground cable.
  2. Remove the air cleaner housing.
  3. Vehicles with 5-spd transmission: Remove the clutch slave cylinder and set aside.
  4. Disconnect the knock sensor wire harness retainer from the coolant hose.
  5. Disconnect the knock sensor (KS) wire connector.
  6. Remove the mounting bolt and knock sensor from the engine block.
c450de5.gif
Hope this helps...

Cheers,

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?


the only way you can do this is if you can identify the gear ratios from both cars with the transmission codes found on the strut tower plate.
see this list to check for matches, read it carefully its a ton of info
subarugears narod ru

Aug 09, 2014 | 1997 Subaru Legacy

1 Answer

Can you switch a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?


the biggest draw back that you will have to check first is the ratio of the diffs you want to change. If they are not the same but will fit then you will destroy the 3rd diff in the transmission from excessive use.

Aug 09, 2014 | 1997 Subaru Legacy

1 Answer

I have a 1997 Subaru Legacy Outback (Station wagon). The last few times that I've gone home I would press the gas pedal but my car would just slow way down. I'd have to hit the pedal a couple of...


there are a couple of possible causes. I have found many older subaru's end up with poor ground connections for the fuel pump. Have the shop that changed the pump test the connection at the sending unit which is located behind the back seat under an access cover. if the connections are good then check the fuel pressure regulator. it uses rubber seals and they fail with age. lastly if the above items are good i suspect the fuel filter might need changing.

Jan 20, 2018 | 1997 Subaru Legacy

1 Answer

Where ist the thermostat locatd on a 1997 subaru legacy with the 2.2 L engine?


Follow the top radiator hose. That is where it is located. There a housing with two bolts holding it in.

Nov 22, 2010 | 1997 Subaru Legacy

2 Answers

Disconected my battery cables.......lights flash


Regulator is bad or alternator is going out.

Sep 28, 2009 | 1997 Subaru Outback

1 Answer

New battery dead in 1 week.


It sounds like the problem is the voltage regulator. I would check that out first. Hope this helped.

Jul 16, 2009 | 1997 Subaru Legacy

1 Answer

97 Subaru Legacy GT Alternator Voltage Output


Battery is probably on it last legs... alternator sounds normal.

Dec 26, 2008 | 1997 Subaru Outback

1 Answer

Will 1999 subaru engine fit in 1997 subaru legacy?


Yes as long as the Motors are the same. You might need to have the computer out of doner car. Doors are suppose to fit 96 to 99.

Oct 02, 2008 | 1997 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...