Question about 2006 Ford Focus

Open Question

How to replace smog air pump and ford focus 2006

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 190 Answers

SOURCE: 2006 Ford Focus making grinding/whining noise in

Check fluid level could be low.

Posted on Jul 08, 2009

Ad
  • 1 Answer

SOURCE: fuel pump replacement on 2005 ford focus

Are you sure that you need to replace the pump? I drive a 54 plate mk2 1.6 zetec that wouldn't always start and I was told it was the fuel pump in the tank but because the fault was intermitant I didn't have it fitted and found out that the car didn't start because the fuel lift pump wasn't priming the system before starting. I found that there was a faulty connection on the relay for the pump that is in the compartment under the glove compartment.

Posted on Oct 26, 2009

  • 1075 Answers

SOURCE: power steering pump Ford Focus 2006 DIY Manual

its quite quite simple;take your pipes of and block them off reconnect them to new pump and replace pump to in line belts.adrian;;;

Posted on Nov 14, 2009

  • 122 Answers

SOURCE: 2006 ford focus reset engine light...

the only way is to connect with a ecu analyzer-programmer to a authorized or specialized service garage to find the cause and reset the ecu.

Posted on May 28, 2010

Runlevel5
  • 15 Answers

SOURCE: Where is the Air Filter Located in a 2006 ford

Actually, the newer ('05+) Duratec motors have a sealed airbox. There is a meter on the side of it (positioned just behind the driver side headlight.) To qualify as a Partial Zero Emission vehicle all emissions parts are required to last for 100k miles. 100k miles is when Ford recommends replacing it. Yes... you replace the ENTIRE airbox. Often times it's more cost effective to replace the unit with a traditional cold air induction kit (~$150) with a more traditional air filter.

Posted on Jul 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Torque specs for Air / Smog Pump Check Valve bolts


have a look here for workshop manual.. http://workshop-manuals.com/chevrolet/

Oct 25, 2017 | Chevrolet Cars & Trucks

1 Answer

How hard is it to change a smog pump on a 2006 Saturn ion?


smog pump ? There is no such thing . What size engine does your ION have ? 2.0 , 2.2 ,2.4 L Has
secondary air injection system .
Secondary Air Injection Pump P0410 P0411 P0412 P0491 P0492

Mar 19, 2017 | 2006 Saturn ION

1 Answer

2005 ford focus obd ll not connecting with smog computer


Check for loose pins or backed out pins in the OBD diagnostic port.

Apr 14, 2016 | 2005 Ford Focus

1 Answer

P0410 secondary air injection system


take it to a dealer warranty should cover the repair ( emission sys )

Mar 05, 2014 | Ford Focus Cars & Trucks

1 Answer

What does it means p2258 code for 2003 Ford Focus , Smog test Failed


P2258 Secondary Air Injection System Control A Circuit High

http://www.motorcraftservice.com/vdi...f/OBDSM505.pdf

Secondary air systems typically utilize an electric air pump as well as one or two electrically controlled check valves to deliver air into the exhaust manifold.

The only vehicle which uses secondary air is the 2.3L PZEV Focus. The Focus uses a system with ported air. This means that airflow is delivered to each individual exhaust port. The secondary air pump is energized soon after start-up while the fuel system is in open loop and icing conditions are not likely. After the O2 sensors warm up, the secondary air pump continues to be energized while the fuel system goes into closed loop fuel. The secondary air system continues to run in closed loop fuel until the air pump is de-energized. The typical time period in which the AIR pump is energized is approximately 12 seconds.

The AIR pump flow check monitors the HO2S signal at idle to determine if secondary air is being delivered into the exhaust system. The air/fuel ratio is commanded open-loop rich, the AIR pump is turned on and the time required for the HO2S signal to go lean is monitored. If the HO2S signal does not go lean within the allowable time limit, a low/no flow malfunction is indicated. (P0411)

The electric air pump draws high current and must be energized through a separate relay. Both the primary and secondary circuits are checked for opens and shorts. First, the output driver within the PCM (primary circuit) is checked for circuit continuity (P0412). This circuit energizes the relay and the vacuum-operated check and control valve(s). Next, a feedback circuit from the secondary side of the relay to the PCM is used to check secondary circuit continuity (P2257, P2258).

Nov 22, 2013 | Cars & Trucks

2 Answers

Where is the Air Filter Located in a 2006 ford focus . And how do you clean the Forever air Filter in the 2006 ford focus


Actually, the newer ('05+) Duratec motors have a sealed airbox. There is a meter on the side of it (positioned just behind the driver side headlight.) To qualify as a Partial Zero Emission vehicle all emissions parts are required to last for 100k miles. 100k miles is when Ford recommends replacing it. Yes... you replace the ENTIRE airbox. Often times it's more cost effective to replace the unit with a traditional cold air induction kit (~$150) with a more traditional air filter.

Jul 01, 2010 | 2006 Ford Focus

2 Answers

Where is the smog pump on a 1997 ford taurus


1997 Ford taurus does not have an air pump or smog pump as it is called.

May 19, 2010 | 1997 Ford Taurus

1 Answer

Power steering pump Ford Focus 2006 DIY Manual


its quite quite simple;take your pipes of and block them off reconnect them to new pump and replace pump to in line belts.adrian;;;

Nov 14, 2009 | 2006 Ford Focus

Not finding what you are looking for?
2006 Ford Focus Logo

Related Topics:

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...