Question about 2005 Ford Five Hundred

1 Answer

My ford five hundred ignition switch need to be replaced and i lose my key and need to move it how can i get the gear shift in drive is there a way to to it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 14,204 Answers

Click here to see,Click here to see how to remove cylinder.

Posted on Jan 17, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Posted on Mar 16, 2009

localwonder
  • 6784 Answers

SOURCE: Replacing the ignition switch in a 96 ford mustang cobra svt

Follow these steps carefully. this will help you achieve this replacement.



  1. Disconnect the negative battery cable from the terminal on the battery. Remove the upper and lower steering column covers by unscrewing them.

  2. Remove the steering wheel by lifting off the center cover, disconnecting the horn wire and removing the retaining nut and washer. Make a mark on the steering wheel spline and the wheel itself so you can line it back up precisely. Pull the steering wheel straight back to remove from the shaft.

  3. Take off windshield wiper and turn signal switches by pulling them off as you did the steering wheel and disconnect the wiring. Slide the spacer sleeve off of the steering column.

  4. Unscrew the ignition switch mounting screws. Pull out the ignition switch. Disconnect the wiring connector from back of the ignition switch. Simply loosen the tabs and pull it out.

  5. Insert your key into the ignition. Turn the ignition switch to the locked position. Depress the retaining pin with a small screwdriver and turn the key to the Off position to free the cylinder. Once it is free, turn the key to lock position and remove the key and key cylinder.

  6. Install your old key cylinder into the new ignition switch assembly. Make sure the contacts in the cylinder and assembly line up. Reattach wiring to ignition switch, slide it into place, screw in mounting screws and reassemble steering wheel and switches.

Posted on Jun 17, 2009

  • 4 Answers

SOURCE: Rear lights stopped working on my Ford Five Hundred

my 05 has 3 nuts that hold the taillight assembly onto the car. in the trunk, pull the matting back, my be some snaps holding or cargo hooks. unscrew or pull, then take the 3 nuts off and entire tail light assembly should come off. Then twist out the correct but connector.

Posted on Aug 18, 2009

harley9701ha
  • 424 Answers

SOURCE: The gear shift is stuck in park. The wheel moves

Make sure you have brake lamps. The shift interlock solenoid is powered by the brake lamp switch.

Posted on Nov 16, 2009

SOURCE: I have an 07 ford five hundred, first owner of

Trans Solenoid Pack

Posted on Apr 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2006 Ford Five Hundred. It starts and runs just doesn't shift into drive, reverse or low gear.


Inside the 05 Ford 500 CVT transmission - YouTube

? 5:22
https://www.youtube.com/watch?v=_u2V1JrNlIw
Feb 7, 2011 - Uploaded by MrGreasybob
I split the case of the CVT to check the other input shaft seals and to check the condition of the bearings that are ...

2006 Ford Five Hundred Consumer Review ... - Edmunds.com

www.edmunds.com > ... > Consumer Reviews
Edmunds.com Rating: 4.5 - ‎173 reviews
Mar 11, 2011 - My car is no exception to the transmission issues. The car will. ... Be the first to write a review on the 2006 Ford Five Hundred. All Models.

Oct 19, 2015 | Ford Cars & Trucks

1 Answer

How do i to fix a ford five hundred car stuck in park?


If it is locked in park, it could be the brake switch or the shift lock solenoid. You may be able to shift out of park before you turn the key switch to the on position.

Sep 05, 2014 | 2006 Ford Five Hundred

1 Answer

2005 ford five hundred will not start have no engine lights will not shift out of park how do i fix it


Ok, let me see if i understand your question. It must be that you want to engage a different gear but since your car is dead then it will not allow you to shift to another gear without the car being on. If that is the problem that you are trying to move the vehicle by pushing it or something like that then let me say that fords have a an electric plunger on the foot brake that actuates the shift mechanism. The battery must be somewhat charged enough to engage this by placing the key in the courtesy setting (turn key just before the engine turns over) But since your engine is dead I will asume that you dont have any juice on the battery, If so let me know if this helped you. Once you have juice in the battery then depress the brake and the shift column should move freely after that. G.E.

Aug 28, 2014 | 2005 Ford Five Hundred

2 Answers

When I turn the ignition switch to start the vehicle I often cannot shift the stick shift out of Park. If I immediately try to switch gears after starting the engine it usually works but if I leave it more...


ok the safety feature on an auto gearbox is that the gear select has a solinoid lock on the shift & you norm have to start engine first before you can select drive now if the engine is running & not allowing you to select a drive then for some reason the solinoid is losing its signal or going faulty or even the shaft needing a little lube IE: wd40 now my volvo won't even allow me to take the key out untill its in park hope this helps

Aug 16, 2014 | 2008 Ford Escape

1 Answer

When I put my gear into Reverse, Netrual and Drive the gear is getting stiff to move. Why is this happening?


If you mean the shifter is getting hard to move, its probably the shift linkage sticking, try a couple squirts of pblaster or other penetrating oil. If the motion of the vehicle is getting hard to drive in reverse and drive the torque converter may be the issue.

Jun 03, 2012 | 2006 Ford Five Hundred

1 Answer

When I put my 2006 ford Five Hundred in Reverse, Netrual and Drive, the gear is getting stiff to move. Why is this happening?


Has Coke or anything that goes sticky been spit around gear shift? I have had this before & had to pull console apart & clean with spray & wipe.

Jun 03, 2012 | 2006 Ford Five Hundred

1 Answer

Key stuck in ignition


We just had this same problem today!!! We have a 2006 Ford Focus and the car would start and we could still drive it, but the key locked in the ignition and would not come out. We tried everything, but what worked was to move the black sleeve (has three plastic rings at top close to handle bar) around the gear shift handle bar, up. It was pushed down about a half inch and it took some pressure to pull upwards, but once we pulled the plastic black sleeve around the gear shift handle bar up, the key came out! Easy as pie!!! Saved hundred of dollars! YAY!!!

Aug 10, 2010 | Ford Fusion Cars & Trucks

3 Answers

Key gets stuck in ignition


My daughter drives a Suzuki, my solution to her is: while the gear shift lever is in park, lightly put pressure on the gear shift lever, through the park position and while pressing the gear shift towards park light rock left to right while trying to remove the key.

The interlock between the transmission and the ignition switch needs to be adjusted/ repaired or replaced.

Oct 04, 2008 | 2006 Suzuki Forenza

Not finding what you are looking for?
2005 Ford Five Hundred Logo

450 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...