Question about 2001 Chrysler Voyager

1 Answer

Tell when computer is bad - 2001 Chrysler Voyager

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

No power from the pcm

Posted on Jan 17, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ox senser is bad how can i tell witch one bad


plug in sears hand held computer will tell u or go to advance auto parts near u for diagnosses.

Oct 26, 2014 | 2004 Volvo XC90

1 Answer

1991 mitsubishi mighty max 2.4 has no injector pulse why?


It could be that your crank sensor is bad or your ecm. your crank sensor sends a small amount of voltage to your computer telling it that you are trying to start your engine the computer in turn sends a signal to the injectors telling them to pulsate because you are trying to start the engine but if your crank sensor is bad and sends no voltage signal to your computer your computer doesn't know you are trying to start your engine therefore it doesn't send the signal to your injectors telling them to pulsate. If your crank sensor is sending a signal to your computer then your computer is not sending the signal to your injectors more likely a grounding issue through the computer I have seen this before let me know how it goes.

Aug 26, 2014 | Cars & Trucks

1 Answer

What is the symptom of a bad crank shaft sensor


In most case's the vehicle will stall but won't continue to run or just a flat no start the crank sensor tell the computer the firing order and when to firer where the cam or distributor sensor tell the computer where number one cylinder is note that the crank sensor my hold both sensor in one. If you had a distributor less car it can affect both fuel and ignition system where as if you have a distributor it would more likely affect the fuel system only. I have seen bad sensor that just made for a poor run and low power do to a bad out put signal to the computer. Check it with a scope for a clean signal back to the computer.

May 25, 2014 | Audi A3 Cars & Trucks

1 Answer

How can you tell when the onboard computer has gone bad and causesthe car to run bad in a 2003 checvy cavalier?


if you have low compression its not the computer or the timing, most likely its a bad head gasket or a bad valve

Jun 16, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

Car turns over for a minute then dies


Long list of reasons. Fuel pump, bad coil, bad wires and plug, bad sensors, bad computer, short related to computer or any sensor, bad cat if clogged, bad crankshaft sensor, bad fuel pressure, etc, etc. Without narrowing it down some nobody will be able to tell you what it likely is. I recommend testing for spark and listen for the fuel pump hum for a few seconds when you turn the key to On position (not starting). That could narrow down a lot.

Sep 02, 2010 | Chevrolet Corsica Cars & Trucks

1 Answer

Misfire/ communications between computer and cylinder 2


Either there is a bad wire, or the computer is bad. Its time to have a qualified repair shop check it out.

Feb 06, 2010 | 2000 Chevrolet Silverado

1 Answer

When u drive around 60mph car is holding back engine light is on say after cat h2 sensor checked the plugs got a miss on idole and its got a flat spot


Go to any Autozone or Advance Store and they will check your computer on board to see what code is stored in the computer. It sounds like you have a O2 sensor going bad. Theses sensors are screwed into the exhaust manifold to read back to the computer on board to tell the car if it needs more gas or less gas. Also the 2 auto store that I have listed will check you check engine light codes for FREE. Where most car dealerships will charge you 1 shop hour to tell you what sensor is going bad or is bad. Hope this helps.

Dec 06, 2009 | 2002 Volkswagen Golf

1 Answer

How do you tell if the main computer is bad


computers are pretty well bullit proof, a scan should tell you if it is ok,

Nov 04, 2009 | 1991 Chevrolet Corsica

Not finding what you are looking for?
2001 Chrysler Voyager Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...