Question about 1998 Dodge Intrepid

1 Answer

Changed oil but oil light want go off

My engine oil light want go off. i heard that there is a switch/sensor that you can reset but i can't find it where should i look for it so i can reset it cause my light is killin me

Posted by on

  • John Jon May 11, 2010

    What is the mileage on this car ? and is it only on at idle?

  • Meph1234 May 11, 2010

    I am not familiar with this car, however.



    If the light is a "low oil pressure" light, then this may not be cured by changing the oil. If this is a low pressure light, i would urge you see a mechanic soon.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

Is this a2.7 liter .if the oil sending unit is leaking which is common on these the light will come on if not these also have oil pump porblems.

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Have you ever heard of the engine oil reservoir being full and the dipstick reading empty? I just bought an old 1985 toyota pickup truck and it was fine until I had my oil changed. After driving for a...


When your car is low on oil, there is a sensor (sometimes called a switch, as well) that will light up an indicator inside the car to inform you of the low oil level. In some cases, checking the dipstick will show that there is actually oil present, which can be confusing and frustrating because it contradicts the sensor. If this happens to be the case, more than likely the oil pressure switch/sensor is malfunctioning and will need replacing.

Keep us updated.

Nov 15, 2010 | Toyota Pickup Cars & Trucks

Tip

Reset oil change light on 2004 Oldsmobile Alero or Bravada w/o (DIC) Driver...


I see alot of people cant figure out how to reset there oil change light on a 2004 Oldsmobile Alero/ Bravade w/o (DIC) driver information center. To do this follow the steps below.
Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the “CHANGE OIL” light goes out. If the light stays on and no chime is heard, you will need to repeat the reset procedure. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.
and its as easy as that and now you can change your oil on your own and not need a dealership to reset it for you.

on Aug 31, 2010 | Oldsmobile Alero Cars & Trucks

Tip

Oldsmobile service light 1991-01


Alero

2000-01

Turn the ignition to the ON position, engine OFF. Press the RESET button and release. The CHANGE OIL indicator will start flashing
2000: Press and release the RESET button again.
1999: Press and hold the RESET button until an audible chime is heard and then release the button.


Intrigue


2000-01

Turn the ignition to ON without starting the engine. Fully press and release the accelerator pedal three times within five seconds. If the CHANGE OIL SOON indicator flashes two times, the system is resetting. Turn the key off after the the light has finished flashing, then start the vehicle. If the CHANGE OIL SOON indictor comes back on, the engine oil life monitor has not reset. Repeat the procedure again. If the vehicle is equipped with the U20 option code, the vehicle as an oil life low indicator. The oil life low indicator shows an estimate of the oil's remaining useful life. When the oil life index is less than 10 percent, the display will show OIL LIFE LOW. To reset the oil life monitor, press and hold the MODE button until the light appears next to OIL LIFE. Press and hold the trip RESET button until the oil life percentage changes to 99 percent.


Alero,
Intrigue,
Cutlass Supreme


1999,
1998,
1996-9

To reset the "CHANGE OIL" light, turn the ignition switch to the "RUN" position with the engine off. Fully depress and release the accelerator pedal three times in five seconds. The light will flash twice and go out.


Aurora


1995-99

To reset the "OIL LIFE" message, press the "ENG" button with the ignition on until "OIL LIFE PERCENTAGE" is shown. Press the "RESET" button for 5 seconds. "RESET" will appear and then "OIL LIFE" will show 100%


Eighty-Eight,
Ninety-Eight,
Regency


1994-97

When "CHANGE OIL NOW" is displayed, press the "RESET" button. Press "SEL" to display "OIL". Press "SEL" to display oil life. Press and hold "RESET" for 5 seconds. A "RESET" message should display with oil life changed to 100%.


Eighty-Eight,
Ninety-Eight


1992-93,
1991-93

Press and release the "TEST" button on the Driver Information Center. This will illuminate "CHANGE OIL NOW" if it is not already illuminated. Press and release the "OIL" or "OIL INDEX" button. Next, press the "RESET" button and hold for at least 7 seconds.


Toronado,
Trofeo

w/o CRT Display

1991

To reset "OIL LIFE INDEX", press the "2 OPTIONS" button: three times if the vehicle is equipped with a phone and compass, once if equipped with neither. While "OIL LIFE INDEX" is displayed, press and hold the "RESET/ENTER" key at the bottom right of the 15 button switch for 5 seconds.













on Dec 07, 2009 | Oldsmobile Alero Cars & Trucks

1 Answer

How do u reset oil light after changing oil


Hello Jw.
  1. Turn the ignition to ON, with the engine off.
  2. Fully press and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the CHANGE OIL light goes out. However, if the light stays on and no chime is heard, you will need to repeat the reset procedure.
  3. Turn the key to OFF. If the CHANGE OIL light comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.
There you are, thank you for using FixYa.

KL

Nov 10, 2010 | 2004 Pontiac Grand Am

2 Answers

Reset change oil light


hello, here is the instructions on how to reset the light

When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary. A CHANGE ENGINE OIL SOON message will come on. Change the engine oil as soon as possible within the next 600 miles (1000 km). It is possible that, if driving under the best conditions, the oil life may not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset.
If the system is ever reset accidentally, change the engine oil at 3000 miles (5000 km) since last oil change.
To reset the Engine Oil Life System, do the following:
  1. Turn the ignition to ON, with the engine off.
  2. Slowly fully press and release the accelerator pedal 3 times within 5 seconds.
  3. The reset is complete when the chimes sound and the CHANGE OIL lamp goes out. If the lamp stays on and no chime is heard, repeat the reset procedure.
  4. Turn the key to OFF.
If the CHANGE OIL lamp comes back on when the vehicle is started, the engine oil life system has not reset. Repeat the procedure.

Jun 20, 2010 | 2001 Pontiac Grand Am SE

Tip

Chevrolet service light 1991-01


Camaro

1998-01

To reset the "OIL CHANGE" light, press and hold the "TRIP/OIL RESET" button on the instrument panel for 12 seconds. When the light flashes and then goes out, the system is reset.


Corvette


1997-01

To reset the monitor after an oil change, turn the ignition on. Press the "TRIP" button so that the "OIL LIFE" percentage is displayed. Press "RESET" and hold it for two seconds. The word "RESET" should appear on the monitor, then "OIL LIFE 90%".


Impala,
Monte Carlo


2000-01

Turn the ignition to ON without starting the engine. Fully press and release the accelerator three times within five seconds. If the CHG OIL SOON lights two times, the system is resetting. Turn the key to OFF, then start the vehicle. If the CHG OIL SOON light comes back on, the system has not been reset, repeat the procedure. Follow this procedure to reset the GM Oil Life System using the DE 100 Series Radio. Turn the ignition to ACC or ON and the radio off. Press and hold the DISP button on the radio for at least five seconds until SETTINGS is displayed. Press the SEEK up or down arrow to scroll through the main menu. Scroll until OIL LIFE appears on the display. Press the PREV or NEXT button to enter the submenu. RESET will be displayed. Press the DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second. Once the message has been reset, scroll until EXIT appears on the display. Press the DISP button to exit programming. A chime will be heard to exit programming. A chime will be heard to verify the exit.


Impala,
Caprice


1994

To reset the "CHANGE OIL" light, turn the ignition switch to the run position with the engine off. Access the reset button on the end of the instrument panel by the fuse block. Press the switch and hold it for at least 5 seconds.



Lumina,
Monte Carlo,
Impala,
Caprice


1996-00,
1996-99,
1995-96,
1995-96

To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds. The light will flash and go out.


Corvette


1990-96

After an oil change, or when "CHANGE OIL" appears on the Trip Monitor, with the ignition on and engine off, press the "ENG MET" button (located on trip monitor) once. Press the "ENG MET" button again within 5 seconds. Within 5 seconds, press and hold the "RANGE" button (1990-1994) or "GAUGES" button (1995). The light will flash. When it stops flashing and goes out, the system is reset.


Chevrolet Suburban,
GMC Yukon XL,
Chevrolet Silverado,
GMC Trucks Sierra


2000-01,
1999-00

Turn the ignition key to the RUN position. Fully push and release the accelerator pedal 3 times within 5 seconds. If the CHANGE OIL SOON light flashes 2 times, the system is reset. However, if the light comes on and stays on for 5 seconds, the system did not reset. Repeat the procedure if the system does not reset.


Silverado, Sierra Trucks


1991-93

To reset the "CHANGE ENGINE OIL" message, turn the ignition key to the run position. Press and release the accelerator pedal three times within 5 seconds. If the light flashes for 5 seconds, the system is reset. Repeat procedure as needed.















on Dec 07, 2009 | Chevrolet Camaro Cars & Trucks

1 Answer

How do i reset the service the service vehicle soon light? I have changed the oil


Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the “CHANGE OIL” light goes out. If the light stays on and no chime is heard, you will need to repeat the reset procedure. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Mar 30, 2010 | 1998 Oldsmobile Intrigue

1 Answer

Sensor light on dashboard


Press the gas pedal up and down 3 times within 5 seconds WITH THE IGNITION ON--ENGINE OFF. May need to be repeated till cleared. Hope this helps

Apr 28, 2009 | Chevrolet Monte Carlo Cars & Trucks

2 Answers

Check Engine Light on 2000 Prizm


Most likely replacing the O2 sensor will fix this code, but that is not 100%, it could be other issues like a vacuum leak or a MAF sensor. The O2 is the one in front or on the engine side of the catalytic converter.

Nov 13, 2008 | 2000 Chevrolet Prizm

2 Answers

Change oil light


Hi...
Are 2 step to RESET the engine oil on your chevy 02.

The first one ..
Turn the key to RUN position. Engine OFF.
Them FULLY PRESS and REALESE the ACCELERATOR PEDAL
For 3 times between 5 seconds and wait until the Change OIL start blinking and goes OFF.

Now the System is reset.

The second step is.

2-- This procedure need the RADIO, if you have an aftermarket
Radio you don't be able to do.
Turn the ignition switch to ON position,
turn OFF the RADIO,
Press and hold the Tune disp, button for 5 seconds or until
Settings is displayed,
Press the seek ptype or seek pscan up and dow to scroll the main menu,
Scroll until the OIL LIFE appear on display
Press the 1prev or 2next to scroll the sub menu, RESET will be displayed , Press the TUNE disp buttom to reset,
A chime will be heard to verify the new settings and done
Will be displayed for one second.
Press the TUNE DISP to exit from the program,
A chime will be heard to verify the exit.

I hope this help on your question.
Thank you for use fixya...

Sep 24, 2008 | 2002 Chevrolet Silverado 1500HD

Not finding what you are looking for?
1998 Dodge Intrepid Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...