Question about 2000 Toyota Avalon
Does bezel pry off? I can't hear the motor so figure it has to be motor or switch. fuse is ok
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: sunroof will not close
If you hear motor hum than it's probably a bad rail part. I have the same plastic rail part and both sides broke. Can't find a replacement anywhere.
Posted on Aug 10, 2009
you have to loosen the mounting bolts on the fuse panel and on the bottom side the fuse is held in by 2 8 millimeter bolts.
Posted on Nov 17, 2009
Testimonial: "Very helpful and exactly right. Saved my neighbor a towing charge to the dealer. His car is back up and running. Thank you!!! "
There are several fuse blocks. They are located in the engine
compartment, behind the right side kick panel, under the instrument
panel or behind the left side kick panel.
If any light or electrical component in the vehicle does not work, its fuse may be blown. To determine the fuse that is the source of the problem, look on the lid of the fuse box as it will give the name and the circuit serviced by each fuse. To inspect a suspected blown fuse, pull the fuse straight out with the pull-out tool and look at the fuse carefully. If the thin wire that bridges the fuse terminals is broken, the fuse is bad and must be replaced. On a good fuse, the wire will be intact.
Sometimes it is difficult to make an accurate determination. If this is the case, try replacing the fuse with one that you know is good. If the fuse blows repeatedly, then this suggests that a short circuit lies somewhere in the electrical system and you should have the system checked.
Fig. Once the cover is removed from the fuse box, you can identify each fuse and relay
Fig. All circuit breakers and fuses pull out quick easily
When installing a new fuse, use one with the same amperage rating as the one being replaced. To install the a new fuse, first turn off all the electrical components and the ignition switch. Always use the fuse pull-out tool and install the fuse straight. Twisting of the fuse could cause the terminals to separate too much which may result in a bad connection. It may be a good idea to purchase some extra fuses and put them in the box in case of an emergency.
Fig. Relays can be removed by pulling them from the block
I hope helps with this (remember rated this help) Good luck.
Posted on Dec 28, 2009
Tips for a great answer:
Nov 10, 2012 | 1994 Toyota Camry
Jun 14, 2012 | Toyota Avalon Cars & Trucks
Jun 01, 2012 | 2000 Buick Park Avenue
Nov 13, 2009 | 1998 Toyota Avalon
May 23, 2009 | 2001 Toyota Avalon
Jan 04, 2009 | 2000 Toyota Avalon
99 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: