Question about 1997 Chevrolet Lumina

Open Question

Location of o2 sensor on 97 chevy 3.1 lumina

Upstream o2 sensor on 3.1 chevy lumina

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 39 Answers

SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1

It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.

Posted on Feb 06, 2009

Ad
  • 2 Answers

SOURCE: 2002 chevy impala o2 location?

it is locared on the driver side on top of the transmision

Posted on Feb 27, 2009

c17hydro
  • 2984 Answers

SOURCE: firing order and camshaft sensor for a 96 chevy lumina 3.1 v6

Here is a diagram of your motor with the firing order:

704b0d7.gif

Posted on Mar 19, 2009

co7196
  • 3433 Answers

SOURCE: 93 chevy lumina crank sensor location

front of engine just about 11:00 over crank pullry

Posted on Jun 12, 2009

  • 4102 Answers

SOURCE: need location of O2 sensor on 97 blazer 4.3 bank 1 sensor 3

Hi the oxygen sensor is located in the exhaust it will either be just before or just after the catalytic converter it will be bolted into the exhaust and will have two wires coming off it that connect into the wiring loom near the engine.

Posted on Mar 26, 2010

Testimonial: "thank you very helpful info "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change upstream o2 sensor on 2008 chevy uplander 3.9l ?


  • 1 Warm up the engine for about four minutes to bring it to operating temperature. Then turn off the engine. This will avoid damage to the exhaust pipe threads if that sensor has seized to the pipe.
  • 2 Find the oxygen sensor or sensors you need to replace. The upstream sensor is located near the exhaust manifold and the downstream sensor on the back exhaust pipe, close to the catalytic converter.
  • 3 Disconnect the oxygen sensor electrical connector. Depending on your particular Chevy model, both sensors may be disconnected from the engine compartment.
  • 4 Lift the front of your Chevy model to reach the sensor you need to change, if necessary. Use a floor jack and two jack stands to support it.
  • 5 Remove the oxygen sensor using a box-end wrench or a ratchet and oxygen-sensor socket.


  • Read more : http://www.ehow.com/how_5159092_replace-oxygen-sensor-chevy.html

    Jul 23, 2014 | Chevrolet Chevy Cars & Trucks

    1 Answer

    Where is the up stream o2 sensor in the chevy venture?


    One of the easiest ways to locate the upstream sensor is to follow the exhaust line from the engine towards the catalytic converter. In most vehicles, the upstream sensor is close to the exhaust manifold compared to the catalytic converter.

    Apr 16, 2013 | 2007 GMC Yukon Denali

    1 Answer

    Trying to find where the oxygen sensor is on a 1993 chevy lumina 3.1


    Yes the o2 sensors are located on the exhaust manifold and down the exhaust its self.. 1993 there might be only 1 o2 sensor but could be 2.

    Feb 04, 2012 | 1993 Chevrolet Lumina

    2 Answers

    O2 SENSORS LOCATIONS


    The O2 sensors are located in the exhaust pipe just off the engine exhaust manifolds and before the Catalytic Converter. A V6 has 2 of them, one for each bank of cylinders, they are referred to as the "Bank 1 and Bank 2 Upstream sensors". There is also a sensor that looks like a O2 sensor it is located behind the Catalytic Converter, its job is to monitor the efficiency of the Catalytic Converter and signal you with a check engine light and a code P0420 if the Cat is not doing its job. Each sensor has its own set of fault codes if problems are sensed in the O2 levels in the exhaust (fuel control problems) and other problems like the heater circuit in the sensor is defective.

    Oct 01, 2011 | 1992 Chevrolet Lumina

    1 Answer

    I have a 97 Grand Prix Pontaic, I have code PO131 Bank 1...


    Hi,
    Upstream Oxygen sensor low voltage output bank1. Usually a bad o2 sensor. Bank 1 is cylinders 1-3-5 and upstream sensor usually on exhaust manifold. Replacement is recommended to clear the fault....Mike

    Jun 20, 2011 | 1997 Pontiac Grand Prix

    1 Answer

    Where are the o2 sensors located on exaust


    If you look in between the motor and the firewall you will see the upstream o2 sensor. If you crawl under the car and look behind the cat you will see the downstream O2 sensor.

    Jan 17, 2011 | 2001 Chevrolet Lumina

    2 Answers

    Bank 1 sensor 2 location on a 1996 chevy suburban


    zjlimited_210.jpg

    Fig. Fig. 3: Oxygen sensor-4.3L engines


    zjlimited_211.jpg


    Fig. Fig. 4: Oxygen sensor-5.0L and 5.7L engines





    zjlimited_212.jpg



    Fig. Fig. 5: Oxygen sensor-7.4L engines




    Oxygen sensors are always numbered like this:
    Bank 1 sensor 1
    Bank 2 sensor 1
    Bank 1 sensor 2
    Bank 2 sensor 2

    Some manufacturers use a kind of shorthand that reads different, but means the same thing:
    Sensor 1/1 or O2s 1/1
    Sensor 2/1 or O2s 2/1
    Sensor 1/2 or O2s 1/2
    Sensor 2/2 or O2s 2/2

    Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
    On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.

    Sensor 1 is always the upstream sensor (the one located BEFORE the catalytic converter)
    Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.

    Hope helps (remember to rate this).



    Dec 12, 2010 | Chevrolet Suburban Cars & Trucks

    3 Answers

    97 Chevy Lumina Completly Stops while driving


    When it stops, does it have spark? (crank sensor)

    Apr 10, 2009 | 1997 Chevrolet Lumina

    Not finding what you are looking for?
    1997 Chevrolet Lumina Logo

    Related Topics:

    185 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8518 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...