Question about Acura RL

Open Question

Dash lights stay on after car is turned off on 1996 acura rl

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 580 Answers

SOURCE: Heater/Cooling problems on 2000 Acura RL

Check the fuse for your blower motor if it is OK the Blower Motor may be bad or you may have a loose wire to or from the it have it checked if fuse is good

Posted on Jul 09, 2009

Ad
  • 4 Answers

SOURCE: 2000 Acura RL and 2000 Acura Integra GS ABS light on

The SRS computer needs to be reset, if you dont have a repair manual i would first suggest finding one for each car. The basic principal is that you jumper the diagnostic plug (under the glove box in the RL). The next step I believe is that you must depress the TCS button, then while holding it down you turn the key to on, continue to hold the TCS button for 15 sec and then let off. The check engine light should then blink really quick a few times and that means its reset. Im reciting this from memory so dont quote me on it. I have done it before for the RL but not the integra, id really suggest finding a repair manual though.

Posted on Sep 19, 2009

  • 97 Answers

SOURCE: How to remove factory radio acura rl 99

the best and safest way to remove this radio is with the special tools that Acura made specifically for removing the radio. Any radio store or best buy can easily remove it for you. I hope this helps please rate this and thank you.

Posted on Mar 05, 2010

  • 2 Answers

SOURCE: Trying to remove back seat in acura RL

THIS IS REAL SIMPLE I HAVE DONE THE SAME THING TO INSTALL THE IPOD INTERFACE MANY TIMES.. STEP 1 MOVE BOTH FRONT SEATS ALL THE WAY UP TO ALLOW U TO HAVE SPACE STEP 2 LOOK UNDER THE SEATS AT THE BASE AND U WILL SEE 2 BUTTON STYLE CLIPPS 1 ON EACH SIDE OF THE SEAT, PLACE YOUR FINGERS ON THE SIDE OF THE BUTTON AND PULL IT TOWARDS YOU,AND AT THE SAME TIME LIFT THE SEAT.. REPEAT THAT STEP FOR BOTH SIDES AND THE SEAT FLIPS RIGHT OUT

Posted on Apr 19, 2010

  • 22 Answers

SOURCE: 97 Acura 3.5 RL-dome lights, bose stereo won't turn on

Are you sure no fuse was blown? there are more than 1 fuse box (in engine and under dashboard).

Posted on Sep 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why are the taillights on my 1996 Acura RL still on after I turned off my car?


very common at the top of the brake pedal arm where the brake light switch plunger touches,there is a small metal angle there should be a small rubber stopper. what you are going to see is a hole ? IF so you can this little part from honda, or in a pinch a small nut and bolt threw the hole and adj.the brake light switch. either way you need a flash light and your going to be on your back in a tight space hope this helps ! let me know

Aug 31, 2012 | 1996 Acura RL

1 Answer

Car starts and runs for a while then shuts off while running. What could be wrong?


Some fault code or check engine light there? Scanned the computer to know if some is stored.

I suggest to check fuel system (injectors, fuel pump pressure, etc), also air intake sensors and ECT (temperature) sensor.

Keep us updated.

Feb 16, 2012 | 1996 Acura RL

1 Answer

How do you turn your maintenance light off on a 1996 acura rl 3.5


Turn your ignition off.
Press and hold both your "select" and "reset" buttons by your instrument cluster.
While holding in both buttons, turn the key to the "on" position but do not start.
After 10 seconds the light should flash and go out.
Done.

Oct 07, 2010 | 1996 Acura RL

1 Answer

96 acura rl will run about 5 seconds then cuts off but will restart and cuts off


I had similar problem with my 97. Cuts off then on high way. I replaced the main relay, which controls the fuel pumper, under the dash of driver side. and the problem was gone.

Aug 08, 2010 | 1996 Acura RL

1 Answer

1996 acura enginelight comes on i smelled emission 1996 RL


you need to have the engine codes pulled in the us auto zone and advance do it for free.this is the only way to know what is happening.

Jan 14, 2010 | 1996 Acura RL

2 Answers

98 Acura RL Mentainance Light will not reset.


WITH THE MILAGE RESET BUTTON ON DASH PUSHED IN TURN KEY ON CONTINUEING TO HOLD BUTTON IN UNTIL LIGHT SHUTS OFF RELEASE BUTTON.(ABOUT 5-10SEC)

Jun 20, 2009 | 1994 Buick Regal Gran Sport

1 Answer

How do i turn off the maintenence required light on 1998 acura rl


the odometer trip setter, find it on the dash hold it in,then turn the key to the on position it will flash and then go out .it takes about ten seconds.

Mar 07, 2009 | 1998 Acura RL

2 Answers

1996 Acura RL connector to test check engine light


its underneath the ash tray just pull it out

Jan 29, 2009 | 1997 Acura CL

1 Answer

Navigation system


I have a 1997 Acura 3.5 RL and my remote unlock doors button dont work cause of the battary so I change the battary and it still dont work then I found out that I need a code to reset the remote also when I put the battary in the red light just stay on do anyone know about this

Oct 20, 2008 | 1996 Acura RL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...