Question about 1995 Lexus ES 300
On some cars the airial for your radio are built into the rear window.
Posted on Jan 17, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
1. I presume your button on the dash (which opens the trunk) is not working. You could take that button out of the dash panel and manually activate the circuit by using the wires themselves.
2. If the "valet" key doesn't fit the trunk lock, see if the keys are visible through the center back seat access 'hole', make a wire hook attached to a broom handle, etc. and try to catch the ring the key is on. If the view is blocked by other things you can't move, figure out at way to move things in the trunk so you can get something to reach the key(s). Do you have other metal keys on the same keyring? If so, use a magnet to grab the whole set.
3. Have you considered taking out the rear seat? Do the bottom seat cushion first, then the back.
4. By now you have hopefully already gotten your keys back out of the trunk, but if not I hope one of these suggestions works. MW
Posted on May 12, 2009
I had check engine light and TRAC OFF. OBD-II MIL code was P1133 which is Air Fuel Ratio Sensor Response Malfunction and scanned by AutoZone. After disconnecting the battery for 10-15 minutes, the lights went off. I cleaned the gas cap and tightened it firmly. For the last 400 miles, the lights have not come back. When scanning using Snap-on one, no code was detected. I think gas cap was the reason for the lights.
Posted on Dec 31, 2009
"To get access to the 3rd brake light:
- Place each hand against both sides of the plastic housing, and firmly grasp and pull the housing towards you. It might not budge at first, but it should move once you get a good grip on it.
- Pull the housing out just enough so that you can see the brake light bulb and stick your hand underneath. Ignore the speaker wires.
- Pull out the old bulb from the socket (it plugs in/out). Wear rubber gloves when handling the new bulb, and put the new one into the socket.
- Reverse the steps here to put the 3rd brake light back into place. Test out your brake light, and you're done" quoted from lexusk8 @ clublexus.com (great forum)
Posted on Jan 23, 2010
Tips for a great answer:
Sep 01, 2013 | 1995 Lexus ES 300
Oct 29, 2017 | 1995 Lexus ES 300
Feb 28, 2012 | 1995 Lexus ES 300
Nov 21, 2010 | 1995 Lexus ES 300
Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat and let me know if you have questions.
Sep 25, 2010 | 1995 Lexus ES 300
May 06, 2009 | 1995 Lexus ES 300
Dec 20, 2008 | 1995 Lexus ES 300
Jul 25, 2014 | 1995 Lexus ES 300
75 people viewed this question
Usually answered in minutes!