Question about 2010 Kia Forte

Open Question

Anti pollution warning message on dash - 2010 Kia Forte

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anti pollution fault, Citreon Dispatch/ immobilises the engine?


Disconnect batt a min....see if it clears. May need it hookd to a scanner to tell issue. Emmisions can effect motor and computr

Nov 17, 2015 | Cars & Trucks

1 Answer

Anti pollution system light came on when changed the alternator


Have someone read the codes. check for any damaged vacuum hoses or electrical connectors left unplugged

Apr 02, 2014 | 2009 Citroen C4 1.6i

1 Answer

Error Message "Anti Pollution System Faulty"


you need to take it to an a.s.e. certified mechanic and do an evap leakdown test to find out where the leak is in the evap system of your vehicle. replace the gas cap and see if the problem goes away as it is often the problem with this trouble code.

Dec 15, 2013 | 2006 Citroen C4 1.6i

1 Answer

I recently replaced the engine on my Citroen c4 2005 model, now the warning lights stay on, the engine overheat, abs and anti pollution warning lights stay on.


The problem for engine overheating rise due to insufficient refrigerant. Try recharging the refrigerant tank with fresh refrigerant and water. If the refrigerant in the tank is of poor quality then also engine overheat.

The reason for ABS light to come may be due to air in the brake fluid line. Try brake bleeding to remove the air bubbles. Also the faulty brake actuator line may cause the problem. Check for actuators on each wheel.

Pollution warning light comes on if the exhaust system not works properly. Check for faulty Oxygen sensor or faulty catalytic convertor.

Jul 10, 2013 | Cars & Trucks

1 Answer

Anti pollution fault and engine management light on - peugeot 308


car keeps on slowing down, when iam driving and changing gears.

Feb 19, 2013 | Peugeot 308 Cars & Trucks

1 Answer

Anti pollution fault


anti pollution fault with fault codes poo87 poo93 i changed fuel filter, so far all ok.

Jan 15, 2013 | 2009 Citroen Berlingo 1.9d

1 Answer

Citroen c-crosser anti pollution warning light


We had this with our grand picasso all the warning lights on then car went into limp mode replaced two lambda sensor as this is what citroen thought it was in the end coolant sensor was leaking up wire back to ecu making all kinds of lights come on as it malfunctioned in the end new ecu cost over thousand pounds.

Jul 01, 2012 | 2008 Citroen C-Crosser HDi

3 Answers

Anti pollution light comes on once car has been driven for twenty mins or so


I had a problem with "Unblock diesel filter and Anti-pollution fault". After reading a few answers for this I decided to take car into the mountains for a good workout. Usually my trips are short and often therefore the exhaust was not getting hot enough to burn off the diesel residue in the Particle filter. In 40 mins of 3,5000 revs mainly in 3rd gear nothing showed up on the computer. Think this problem is sometimes caused by the engine not getting hot enough for long enough.

Apr 04, 2012 | Cars & Trucks

2 Answers

Anti pollution system fault light is on.


If the Anti pollution warning light is coming on the possible causes are endless. If the car is driving ok then that is a good sign, but please remember that modern management systems can mask problems quite well. The safest advice is to get it looked at and see what fault codes are appearing and then a diagnosis can begin, as leaving it is not going to be a good thing, it can go from a minor problem to more serious issues. At least the light is not flashing, which usually means an emission compliance problem and even more serious, but even so I would advise protecting your vehicle by getting it checked out as soon as possible to avoid potential damage.
----------
A fault in the ignition can cause an engine misfire and unburnt fuel gets into the exhaust causing the anti-pollution light to be triggered.

Check the ignition system for signs of damp or loose connections.------- I suggest get the car scanned at autozone service center.Its absolutely free to get car scanned.This will show the problem if you receive the error code.-------- Thanks.Helpmech.

Jul 08, 2011 | 2006 Renault Le Car

Not finding what you are looking for?
2010 Kia Forte Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...