Question about 1998 Kia Sephia

1 Answer

Po336 crankshaft position sensor A range / performance

I have done smog check last week it failed. it says comprhensive visual inspection : pass. Functoinal check: fail Emission test:Pass. it is mentioned that this vehicle failed the OBD system check because the malfunction indicator light was on, or not working. OBD Fault CODES: P0440 EVAP Ctrl System Malfunction P0134 02 Sensor CKT Inactive(Bank! sensor1) p0336 Crankshaft Position Sensor A range/ performance. so they said i have to repair all these to pass the test . i just wanted to know the approx. cost to repair all these. if it cost more i dont want it to repair at all .

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 14,333 Answers

Trouble Code: P0134

HO2S-11 (Bank 1 Sensor 1) No Activity Detected

Trouble Code Conditions: Engine started, engine running in closed loop at a speed over 3 mph for more than 2 minutes, and the PCM detected the HO2S signal stroke rationality was more than the threshold value (0.250 volt) during the Heated Oxygen Sensor Monitor test.

Possible Causes:


HO2S signal circuit is open or shorted to ground.HO2S has deteriorated, is contaminated or has failed.PCM has failed.YOUR HO2S SENSOR IS BAD,IT COST 80.00,USE EXACT FIT PART.EASY TO REMOVE,DISCONNECT ELECTRICAL CONNECTOR,GET WRENCH AND REMOVE.5 MINUTES TO DO.Trouble Code: P0336

Crankshaft Position Sensor Performance

Trouble Code Conditions: Engine running and the PCM detected the number of CKP sensor signals counted (between the reference mark gap). did not equal the Actual number of available teeth (i.e., the CKP signals. were out or the normal window" of operation with the CMP sensor. signals okay).

Possible Causes:


CKP sensor signal circuit connections loose (intermittent fault).CKP sensor wiring harness has a connection fault (intermittent).CKP to Target Wheel "air gap" is incorrect.CKP sensor is damaged or has failed.Must remove to see.Trouble Code: P0440

EVAP System Malfunction

Trouble Code Conditions: Engine started, ECT sensor signal less than158?F at startup, IAT sensor signal more than 9.5?F, system voltage over 10.0 volts engine runtime 15-20 minutes at cruise speed, then returned to idle speed, VSS indicating 0 mph, load value 2.2 ms, canister load factor less than 4.0, fuel tank pressure less than 0.5" Hg, then after the Idle Control system and Fuel Trim had stabilized, the PCM detected a fuel vapor leak (as small as 0.040") in the EVAP system during the EVAP Leak Test.

Possible Causes:


Fuel filler cap damaged, cross-threaded or loosely installed.Small hoses or cuts present in the EVAP vapor hoses/lines.EVAP purge valve is damaged or has failed.Here you are the symptons.

Posted on Jan 17, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

arauzvictor1
  • 466 Answers

SOURCE: knock sensor replacement

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Posted on Mar 19, 2010

elstretchie
  • 140 Answers

SOURCE: just had diagnostic check as engine light is on.

G'day mate well lets start with the O2 (oxygen )censor , it is in the exhaust and does clog up give a spiked reading ( on a graph or multimeter ) instead of a smooth transition like a wave flowing,this will tell all the other censors that the fuel flow/mixture/quality is bad , the rest try to compensate by raising the mixture changing timming etc, get the O2 censor done 1st then go from there, it should calm down once this is done,

Posted on Mar 30, 2010

  • 1 Answer

SOURCE: check engine light on kia sorento

believe me..i had this problem before with my sorento 06. send to garage many time but the problem kept coming after 2 weeks.. but i found my self that whenever ESC light is on ,engine became sluggish. what will you do is to use a cruise control until you reach home. after that..at front passenger side, next to door, open the side cover,,you will see a bunch of cable inside..with your engine on and press the pedal lightly..pull that cables with your hand...and you will found your engine revs.

Posted on Feb 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 kia sedona won't pass emissions the codes are p0320 p0431. Help please


code p 0320 refers to crankshaft position(CKP) sensor /engine speed ( RPM) sensor ---circuit malfunction===causes --wiring---CKP/RPM sensor---ECM
code p 04310 refers to warm up catalytic converter, bank 2--efficiency below threshold===causes ---cat converter---wiring---HO2S 2
As it is not passing the smog test I would be replacing the HO2S sensor ( manifold or before the cat on bank 2 of the engine ) or more likely a failed cat converter
you may have had the P 0320 code for a long time and have not noticed a drop in performance but as cat converters have a lot to do with smog control , that is the area I would advise checking first

Jan 16, 2016 | Kia Cars & Trucks

1 Answer

I have a nissan primer with falt code po336 p


code p 0336 refers to crankshaft position sensor(CKP)--range / performance problem===causes insecure sensor / rotor --air gap incorrect ---wiring-- CKP sensor

Oct 22, 2015 | Nissan Cars & Trucks

1 Answer

I have 4 codes that came up on my 2005Chevy impala, PO 128,PO336,PO38,and PO 386can anyone tell what these are?


P0038 - HO2S Heater Control Circuit High Bank 1 Sensor 2
P0128 - Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature)
P0336 - Crankshaft Position Sensor Circuit A Range/Performance
P0386 - CKP Sensor B Circuit Performance.
your most likely need to replace the crankshaft sensor and probably will take care of the 0336 and 0338 codes.
you then need to check your coolant level, if low fill and look for leaks, if not low, most likely replacing the thermostat will correct other two codes

Oct 17, 2015 | Cars & Trucks

1 Answer

Code p0336 2005 chevrolet aveo


CODE PO336 - CRANKSHAFT POSITION SENSOR RANGE PERFORMANCE CONDITIONS.

Jun 09, 2011 | 2005 Chevrolet Aveo

1 Answer

Codes


I punched in code po336 for a bing search,
and it says that it could be
PO336
Crankshaft Position Sensor Signal Range / Performance
But it may be for another car.

What was your engine size and submodel? My reference on the Internet didn't have fault codes for your vehicle.

Jul 07, 2010 | 1997 Buick Skylark

3 Answers

What does code p1391 mean when failing an emissions test


intermittent loss of crankshaft or camshaft position sensor.

Oct 14, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Failed inspection due to codes P0336 and P0442


PO336 IS THE CRANKSHAFT POSITION SENSOR WHICH SHOULD BE THE ANSWER TO PASSING INSPECTION SINCE IT IS A PERFORMANCE ISSUE. IT IS RESPONSIBLE FOR FUEL INJECTION AND SPARK PULSE. REPLACING IT SHOULD HELP TO REDUCE EMISSIONS. AND THE SECOND CODE IS AN EVAP LEAK,SMALL. HOPE THIS HELPS. LET ME KNOW. BEST OF LUCK

Apr 29, 2009 | 1996 Oldsmobile Ninety Eight

Not finding what you are looking for?
1998 Kia Sephia Logo

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...