Question about Chevrolet Cars & Trucks

Open Question

93 chevy 4L60E will not shift in 3rd and 4th gear

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: 4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD

The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.

Posted on May 26, 2009

Ad
  • 37 Answers

SOURCE: 95 GMC Sierra 4L60E will not shift down to 1st or up to 4th.

no power stuck in 3rd gear electric shop unless youve burnt it up good luck...www.TransmissionGarage.com

Posted on Dec 30, 2009

  • 79 Answers

SOURCE: 4l60e no forward or reverse gears operating

It sounds like your torque converter or the pump is broken.

Posted on Jan 10, 2010

shark2th667
  • 343 Answers

SOURCE: my 93 chevy truck wont shift into 3rd gear. goes

I say band adjustment in transmission, have done by shop. might be just a vacuum hose or modulator, but I don't think so

Posted on Oct 03, 2010

  • 1 Answer

SOURCE: E40d trans will not shift into 3rd or 4th gear, only rev. 1+2

check or replace your thottle position sensor tps that trans needs to know where the throttle is to shift if it is bad it will do as you say wont shift to third
another telltale is it will act like it goes into lockup when shifting into reverse and stall the engine

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No 3rd and 4th after rebuid


Hello Cammie Parker,

Programmable Electronic Transmission Controller... 4160e

You didn't put down any particulars... make, model why it was rebuilt in the first place... (MILEAGE).

If it was a Professional job... Take it immediately back.

If you did it yourself... (oh well)...
make out a list of everything already done and
LOOK EVERYWHERE ELSE.

Not getting 3rd & 4th is not subtle... but if it was NOT FAILING like that before you started = WORK ERROR.

That'll give us a clue where to start...

Sep 10, 2016 | GMC Cars & Trucks

1 Answer

Wont shift to third gear


THE TV CABLE RUNS FROM INTAKE ATOP OF ENGINE TO THE TRANSMISSION HONESTLY I BELIEVE YOUR 3RD GEAR BANDS ARE WORN OUT (TV STANDS FOR THROTTLE VALVE)

Jun 24, 2013 | 1993 Chevrolet C1500

1 Answer

Put a 1996 4l60e into 97 truck.goes strait to 3rd gear unless man shift.no 4th


The transmission in this truck is electronically controlled through shift solenoids,it also has a number of sensors that the computer control module uses to determine proper times to shift and what is the appropriate gear, so you must have the computer scanned to see if any fault codes related to the transmission are in memory

Feb 09, 2012 | 1997 Chevrolet Suburban

5 Answers

1997 Chevy 4L60e Transmission Shift Problem


How many miles? Have you maintained, serviced trans in past or just waited for this day to wonder what happened?

Jan 04, 2010 | 1997 Chevrolet Suburban

1 Answer

92 chevy s10 4x4 4.3L manual transmission no 3rd gear


Hi:

Your transmission has 3 shift rails...
1st - 2nd
3rd -4th
5th- Reverse

If your 3rd gear doesn't work , you have an internal transmission problem, such as a syncronizer, or similar fail... There is not much you can fix, without removeing the transmission.

Nov 30, 2009 | 1992 Chevrolet S-10

1 Answer

4l60e trans. will not shift out of 3rdgear...


Have it scanned. Have the person who scans it pay particular attention to the Transmission temp sensor. If the Transmission temp sensor tells the ecm the transmission is cold, it won't shift to 4th. Also if it thinks the transmission is too hot it won't allow a 3-4 shift.

Apr 30, 2009 | 1994 Chevrolet C1500

2 Answers

95 GMC Sierra 4L60E will not shift down to 1st or up to 4th.


no power stuck in 3rd gear electric shop unless youve burnt it up good luck...www.TransmissionGarage.com

Jan 28, 2009 | 1995 GMC Sierra

1 Answer

4l60e no forward or reverse gears operating


It sounds like your torque converter or the pump is broken.

Jan 12, 2009 | 1993 GMC Sierra K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...