Question about 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

I'm looking for the location of the blinker flasher on a 2003 F350 7.3 L. I found the one for the hazards.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

If im not mistaken it should be in a fuse panel right under the steering wheel. if it is it is like a cylinder fuse. Thats what it is on my Bronco II. hoped that helped

Posted on Jan 17, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Turn Signal Flasher location in 93 Mustang GT

The flasher is a small round plastic cylinder (unless replaced with a metal one) behind the left edge of the glove box that will look similar to the one in the fuse panel. The first step is to squeeze gently both sides of the open glove box and let it swing downward. It will be snapped into a metal horizontal brace just to the left of the glovebox opening by a small tab and have two wires attached. The number more than likely will be a #552 although I have seen a factory one with a Warner #224

Posted on May 13, 2009

  • 234 Answers

SOURCE: No turn signals or emergency blinkers

Sounds like a multifunction switch, work the emergency flasher button up and down a few times, then attempt to work the turn signals if the signals work then you will need a multifunction switch.

Posted on Aug 29, 2009

  • 4369 Answers

SOURCE: where is the turn signal\hazard flasher located?

it's in the auxiliary relay box behind the glove box.

13350 is base part number on flasher

Posted on Feb 03, 2010

Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."

sscullys
  • 984 Answers

SOURCE: Where is the turn signal relay, hazard relay, and

It is not the flasher if the hazards work, it is 1 flasher for both turn signals and the hazard lamps. It is in a relay block ( along with the blower motor relay ) under the dash, about in line with the steering wheel column ).

Try tilting the steering wheel all the way up, and test again.

The other quick test is to cycle the hazard switch a few times, to see if it cleans the contacts for the turn signal on the MFS,

Posted on Apr 03, 2010

  • 4977 Answers

SOURCE: My blinkers are not working.I

are you sure you replaced the signal flasher and not the hazard flasher as they look the same.put the hazards on and check to see if it was the one you replaced.if it is then you need to located the signal flasher and replace it.if you still have the old one you replaced you can use it.

Posted on May 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Looking for the relay on my car


http://techinfo.honda.com/rjanisis/pubs/OM/AH/BTX0707OM/enu/TX0707OM.pdf

so, i'm assuming you don't have hazard lights flashing when you push the button?

and you already checked the 15 Amp fuse on the under-hood fusebox driver side? as seen on page 440 of your owners manual?

and this odd rectangular shaped flasher unit is above the inner fuse box by the parking brake pedal as discussed in your other same question:


Where is the hazard blinker relay located

Apr 11, 2015 | 2007 Acura MDX

1 Answer

Location of flasher on a 2006 ford e350 ecoline wheelchair van


Under the steering column on driver side by the fuse box you will see a round metal or plastic button like device when you turn the blinker on should make the blinking sound once? Keep turning it on and off until you locate the flasher? Note: there are two flashers one is hazard and the other is turn signal! Make sure your hazard flasher blinks after you unplug the turn flasher so you know you have the right one located?

Mar 29, 2014 | 2003 Ford Crown Victoria

1 Answer

My blinkers are not working.I replaced fuses and flasher.My hazard lights work but my blinkers still dont.What else could I check.


are you sure you replaced the signal flasher and not the hazard flasher as they look the same.put the hazards on and check to see if it was the one you replaced.if it is then you need to located the signal flasher and replace it.if you still have the old one you replaced you can use it.

May 01, 2011 | 1997 Ford Thunderbird LX

1 Answer

The blinkers only work some of the time. All bulbs are good and the emergency flashers work. I found the flasher for the blinkers, but if it is bad, will the blinkers work some of the time and other times...


you need a signal flasher to correct the problem.flashers will act this way some times when they have an internal problem with the bi-metallic strip that actually completes the circuit and makes the clicking sound.make sure you have found the signal flasher and not the hazard flasher as they look the same.with the hazard flashers on you can see what the signal flasher will look like and it is in the fuse panel.

Mar 25, 2011 | 1987 Ford Taurus

3 Answers

My 2003 chevy impala turn signals won't blink. the lights come on but won't blink. I have checked the fuse. it looked fine.


Hi,

Your problem is your blinker or flasher, it is located under dash, behind the instrument panel right above the steering column. Cost is no more than $10.

If helpful, click below, GOOD LUCK

Apr 15, 2010 | 2003 Chevrolet Impala

2 Answers

Blinker and hazard light problems


Replace the flasher relay. Sorry I cannot tell you where it is. Buy a new one so you will know what you are looking for.

Mar 02, 2010 | 2004 Saturn VUE

1 Answer

TURN SIGNAL, BRAKE & HAZARD LIGHTS


No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:
  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Jul 09, 2009 | 1999 GMC Denali

1 Answer

Need location signal flaher and front lighter fuse,;2002 explorer


check fuse #21 first. 5 amp.

flasher relay in fuse panel on dash


May 21, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
2003 Ford F350 Super Duty DRW SuperCab Logo

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...