Question about 2001 Pontiac Grand Am SE

1 Answer

Can't figure how to remove right rear door panel on 2001 Pontiac

Need exploded view of right rear door panel removal for 2001 Pontiac Bonneville. Can't get to inside to see why electric window won't work.

Posted by on

  • srenee777 Jan 28, 2009

    Dear Heapful, I got all the plastic holders unplugged and the top of panel off but the very center of the panel is very secured and there are no screws visable from the interior side of panel. I call myself an advanced shade tree mechanic. I don't mess with any computerized things but anything else it's a go. I'm thinking maybe go to the Library to see if I can get the GM Exploded view of a 2001 Pontiac Bonneville Right rear door. I tried O'rielys for a manual But Haynes sold out to Chilton and Chilton uses a completely different model car for illustration and the fron Dr. side door which is totally useless for my make and year. Thank you again very much and God Bless you all, Faryle

  • Anonymous Mar 21, 2014

    what is holding it on

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Pontiac Master
  • 443 Answers

These are bad about those Cable operated window devices .. If it is bad get on ebay and get one ordered its your best bet.. Just take a flat screwdriver and go around the bottom of the door panel and pop it loose and up the sides .. there might be a hidden screw or two in the middle around the handles.. good luck ..

Posted on Jan 25, 2009

  • Jerry Koski
    Jerry Koski Jan 28, 2009

    Are you sure there are no screws under or inside the door handle ? if not try lifting the panel upward to see if it sets in a pocket to hold it . also pull handle out tword you and look in there to see if a 10 mm bolt is behind there also. got to be a way to release it . sounds like you are in for changing out one of those cable operated window regulators ? Remember ebay when you buy one they are alot cheaper than GM for sure. Jerry

×

1 Suggested Answer

  • 840 Answers

SOURCE: Can't figure how to romove right rear door panel on 2001 Pontiac

rt rear door panel should be easy their may be screws in and around the trim panel check for little top covers take off and screws are underneath them. know when you pull the trim off its mounted by retainers so be careful pull at bottom and work your way to the top pull upward and then take off you should be able to see after that

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove speakers


need remove rear shelf trim panel .open trunk use flash light locate rear speakers then disconnect electrical connector from rear speaker then squeeze the two mounting tabs and push them up through their mounting holes then push up on the speakers to disengage remove them.

Jun 11, 2013 | Pontiac Bonneville Cars & Trucks

1 Answer

How to remove the radiator in a 2001 bonneville?


If it is in the way of fan shroud

Loosen & leave on bolt in & turn out of the way

Nov 24, 2012 | 2001 Pontiac Bonneville

1 Answer

How to remove a door panel on a 2002 pontiace bonneville


Here is the procedure for removing the rear door panel.
First you must remove the inside door handle bezel. (See 1st Picture). Next you must use some sort of clip removal tool to release the plastic retainers that the are on the outside edges of the door trim. (Look at the 2nd Picture). Now you must rock the door panel trim upwards, starting at the rear while lifting upwards to remove. (See 3rd Picture). Now disconnect the door trim panel wiring harness. Next you must remove the armrest pull cup retainers from the inside of the door panel trim. First use needle nose pliers to compress the 360 clip then pull the 360 clip out of the nylon nut on the door trim panel. (See 4th Picture). The installation is reverse of removal. I hope this helps.


9_11_2012_3_29_31_pm.jpg
9_11_2012_3_30_00_pm.jpg

9_11_2012_3_30_28_pm.jpg

9_11_2012_3_31_03_pm.jpg
9_11_2012_3_31_35_pm.jpg

Dennis Weid.

Sep 11, 2012 | 2002 Pontiac Bonneville

1 Answer

Where do you start to remove rear door panel on a 2001 pontiac bonneville?


You should first look at the underside of the arm rest...this needs to be removed before the panel...usually 2 phillips head screws...then gently pry the panel on the bottom...GM uses several push in plastic clips to hold the door panels in place...if yuou damage any of these...they are available at most parts stores in the "help section"...Hope this works for you:)

Dec 24, 2010 | 2001 Pontiac Bonneville

1 Answer

How to replace side mirror


Outside Mirrors REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable. NOTE: This procedure is for power mirrors. The procedure for a manual mirror is the same with the exception of the lack of electrical wiring.
  2. Remove the door trim panel, plastic fasteners from the sound insulator and water deflector, as required.
  3. Unfasten the retainer, then remove the mirror trim panel. Fig. 1: The outside mirror has a trim panel which is secured with a screw and a retaining clip 89630g19.jpg
    Fig. 2: Unfasten the retaining screw . . . 89630p19.jpg Fig. 3: . . . then remove the mirror finish panel. Note the panel retaining clip (see arrow) 89630p10.jpg
  4. Disconnect the wiring connector and remove the wiring from the door retaining tabs. Fig. 4: Exploded view of the outside mirror cable routing 89630g20.gif

  5. Remove the mirror retaining nuts/screws, then remove the mirror with insulator and wiring. Fig. 5: Pull the sound absorber filler pad out of the door 89630p11.jpg Fig. 6: Unfasten the side view mirror retaining nuts and bolts 89630p12.jpg Fig. 7: Exploded view of the outside mirror assembly mounting 89630g18.jpg
    To install:
  6. Refit the mirror with insulator and wiring into position.
  7. Install the mirror retaining nuts/screws.
  8. Route the wiring through the door retaining tabs and reconnect the electrical connector. Make certain the wiring harness does not interfere with the window glass operation.
  9. Install the water deflector, sound insulator and door trim panel, as required.
  10. Connect the negative battery cable. prev.gif next.gif

Nov 05, 2010 | 1997 Pontiac Bonneville

1 Answer

I need to install a heater core for a 2001 Pontiac bonneville I need instructions on how to remove and install it.


prev.gif next.gif HEATER CORE REMOVAL AND INSTALLATION 1997–01 Models BONNEVILLE AND LESABRE
  1. Disconnect the negative battery cable.
  2. Drain the cooling system into a clean container for reuse.
  3. Remove or disconnect the following:
    • Heater hoses from the heater core
    • Right sound insulator
    • All necessary electrical connectors and remove the instrument panel compartment
    • Temperature valve actuator
    • Electrical connector and remove the HVAC programmer
    • Heater core cover-to-heater assembly screws and the cover
    • Heater core-to-heater assembly screws and the heater core Fig. 1: View of the heater hoses and clamp positions — 1997–01 Bonneville and LeSabre 93111g71.gif
      Fig. 2: View of the heater core cover — 1997–01 Bonneville and LeSabre 93111g72.gif
    To install:
  4. Install or connect the following:
    • Heater core and the heater core-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
    • Heater core cover and the cover-to-heater assembly screws, then, tighten the screws to 12 inch lbs. (1.4 Nm)
    • HVAC programmer and connect the electrical connector
    • Temperature valve actuator
    • Instrument panel compartment and connect any necessary electrical connectors
    • Right sound insulator
    • Heater hoses to the heater core
  5. Refill the cooling system.
  6. Connect the negative battery cable.
  7. Operate the engine to normal operating temperatures; then, check the climate control operation and check for leaks.

Jul 01, 2010 | 2001 Pontiac Bonneville

2 Answers

How do you change a blend door actuator on a 2003 GMC Yukon. Need to know where it is located and how to get to it.


Locks & Lock Systems
Power Door Locks

Diagnosis & Testing
  1. Check the fuses for the door lock circuit. Verify there is 12 volts at the fuse terminal. If voltage is not present, check the wiring.
  2. Remove the door trim panel of the affected door.
  3. Unplug the connector to the door lock actuator. Connect a test lamp across the terminals of the harness.
  4. Verify that the light illuminates briefly in both the lock and unlock positions of the switch.
    1. If it does not, there may be an open/high resistance or a short to ground in the wiring. If the wiring is OK, the IP fuse block is faulty.
    2. If it does illuminate and the lock actuator still does not work, the actuator is faulty.
Removal & Installation
Door Lock Motor


c0c7766.jpg
Fig. Exploded view of the front door trim pane

63db39d.jpg

Fig. Exploded view of the rear door trim panel, long wheelbase models


1dc80d4.jpg
Fig. Exploded view of the rear door trim panel, short wheelbase models

df433be.jpg

Fig. Exploded view of the front door lock actuator
  1. Disconnect the battery ground cable.
  2. Disable the Supplemental Restraint System.
  3. Remove the door trim panel. Refer to the illustration for the mounting screw and lock tab locations. After detaching the hardware, carefully pull it away, then lift it off the door just far enough to detach the electrical connections from it.
  4. Carefully detach the water shield from the door; this will be reused upon installation.
  5. Disconnect the inside door lock rod from the handle retainer clip.
  6. Detach the door lock rod from the retainer clip.
  7. Remove the rubber plug to access the outside handle rod. Disengage it from the clip and disconnect the lock cylinder rod.
  8. Detach the electrical connector and remove the lock from the vehicle.
  9. Installation is the reverse of removal. When installing the lock, tighten the screws to 89 inch lbs. (10 Nm).

Door Lock Switch
  1. Remove the door trim panel.
  2. Remove the screw securing the switch assembly.
  3. Use a flat bladed tool to remove the switch panel bezel from the panel.
  4. Release the retaining tabs of the switch assembly using wide flat bladed tool.
  5. Remove the lock and window switch assembly from the door panel.

    0900c15280247ec7.jpg
    Fig. Remove the screw (2) securing the switch assembly (1) to the door panel
Hope helped with this (remember rated this help) Good luck.

Nov 05, 2009 | 2003 GMC Yukon

1 Answer

Replace driver side mirror on 2001 Nissan Quest


SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the upper speaker.
    1. Disconnect the electrical connector.
    1. Remove the bolts.
    1. Remove the speaker.
  1. Position the watershield aside.
  1. Remove the exterior rear view mirror access panel.
  1. Disconnect the exterior rear view mirror electrical connectors.
    • Release the wiring harness locator.
  1. Remove the exterior rear view mirror.
    • Remove the bolts.
    • Feed the wiring harness through the door opening.

Mar 31, 2009 | 2001 Nissan Quest

1 Answer

Inside door panel removal


u need a window crank remover tool get at ny parts store

Feb 25, 2009 | 2001 Pontiac Sunfire

1 Answer

Can't figure how to romove right rear door panel on 2001 Pontiac


rt rear door panel should be easy their may be screws in and around the trim panel check for little top covers take off and screws are underneath them. know when you pull the trim off its mounted by retainers so be careful pull at bottom and work your way to the top pull upward and then take off you should be able to see after that

Jan 25, 2009 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2001 Pontiac Grand Am SE Logo

687 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...