Question about BMW X5 Series

Open Question

How to change my bmw x5 dashboard back to english

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: bmw x5 slow gear change

this is normal to some extent to try and warm up the tranny to opp temperature as soon as possible. make sure the vehicle had the latest software installed in the transmission as this could also cause a delayed shift when cold.

Posted on Feb 07, 2009

  • 1 Answer

SOURCE: bmw x5 2002 3d auto

How long did you charge the battery? If was completely dead a five minute jump won't do it. Let battery JUMP charge for at least 20 minutes and have other person helping you do the jump rev his engine while you start the beamer.

Posted on May 04, 2009

AnIdea
  • 33 Answers

SOURCE: bmw x5 auto 2002

Sounds like a faulty microswitch which is located on the boot lock mechanism, even though the boot might be locked, its still thinking its open and would need replacing. Unfortunately, I believe that this comes as one piece with the boot lock.

Another thing to be aware of one these is the wiring loom coming out from the body of the car and into the bootlid (on the right hand side boot lid when open) If you pull the rubber "tubing" off you'll gain access to the wiring. A common fault is for the wires to stress/break causing false contact. Hopefully one of these two problems should be your cause. Let me know how it goes!

Posted on May 26, 2009

  • 1348 Answers

SOURCE: 2003 x5 BMW altenator replacement, tools needed

by the time you buy the tools to do that job,it will be cheaper to pay someone.

Posted on Apr 14, 2010

  • 211 Answers

SOURCE: Frequent oil change problem in BMW X5

check the owner operater manuel , if a what frequency that lite is supposed to come on at could be you need to change the setting. if so those instuctions shoul be in that manuel

Posted on Jul 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Radio not working


you need to enter the code for the radio. its in safe mode.

Jan 14, 2014 | 2005 BMW X5

1 Answer

Dashboard lights not coming on and the radio not working


Sounds like a ground wire has been pulled loose under the dash. The ground wire on automotive is white and they are connected to the firewall with a small bolt(10mm head) and just need tightened up or reconnected. ALWAYS check the grounds first.

May 14, 2013 | 2003 BMW X5

1 Answer

My 2005 X5 4.40I this briefly displayed something like "Hillshare Program" on the dashboard this morning, next thing I know the car started drivinig slow and will not go to a higher gear. Running on h


You've a faulty EGR(Exhaust Gas Recirculation)valve problem. It has to do with emission control and you will not get enough power to achieve speed for trans shift higher when the EGR is bad. Replace the EGR and all will be well.

Jan 31, 2013 | 2005 BMW X5 4.4i

2 Answers

I have a 2003 BMW X5, how do I reset the service indicator?


Hi,

You can reset your service indicator, as follows:
  1. Get in the car, close the door, buckle the seatbelt.
  2. Push in the clutch pedal and hold it to the floor
  3. Press the left hand dash button (the one that resets your odometer) and hold it down
  4. Put the ignition key in the key slot, and turn it gently (very gently) until the dashboard lights come on - the key will not click - if it clicks you've gone too far and you have to start again. Hold the key in this position. In five seconds or so, the dash will display "SIA" and some other characters. Do not proceed until this happens.
  5. Release the dash button (and only the dashboard button) and then press and hold it again. In another 5 seconds or so the display should begin to flash "RESET?" Do not proceed until this happens.
  6. Release the dash button and push it again to confirm. You won't need to hold it - the display should change immediately and your service indicator will display five green LED's.
Hope this helps. Please remember to rate this answer. Many Thanks.

Jul 29, 2009 | 2005 BMW X5

1 Answer

Bmw x5 2002 3d auto


How long did you charge the battery? If was completely dead a five minute jump won't do it. Let battery JUMP charge for at least 20 minutes and have other person helping you do the jump rev his engine while you start the beamer.

May 04, 2009 | 1992 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...