Question about Oldsmobile Alero

Open Question

Timing marks for 2002 oldsmobile Alero

Timing chain jumped off I need to no how to put it back on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 32 Answers

SOURCE: how to change antifreeze in a 2002 oldsmobile alero

below radioator or side low should b plastic plug which u can unscrew & emty the fluid

Posted on Dec 18, 2008

landsend
  • 1066 Answers

SOURCE: Where to put the timing marks on a 96' nissan 2.4 liter

the timing chain tensioner is hydraulic and either out of adjustment or defective.  You need to remove the timing chain cover and reset the mechanical correlation between the crankshaft and the camshafts.  also the other ignition time marks are on the crankshaft harmonic balancer and the cam cover.  Do not crank the engine with the timing out of sequence or you'll destroy the engine.

Posted on Mar 25, 2009

  • 1596 Answers

SOURCE: Need timing marks for 2002 ford explorer 4.0




The Info I Have Is Extensive and Has Illistrations, I Need to Emali it to You As it is Very Large, This Is A Small Example Im @rejakwilson@aol.com

Special Tool(s)

  1. With the vehicle in neutral, position it on a hoist.
  2. Remove the intake manifold.
  3. Remove the fuel supply manifold.
  4. Remove the accessory drive belt.
  5. Remove the thermostat housing.
  6. Remove the roller followers.
  7. NOTE: You must retime the LH and RH camshafts when either camshaft is disturbed. Turn the crankshaft clockwise to position the number one cylinder at top dead center (TDC).
  8. NOTE: Late build pulley shown, early build pulley similar. NOTE: The special tool must be installed on the damper and should contact the engine block to position the engine at TDC.

Posted on Jul 24, 2009

  • 169 Answers

SOURCE: sometime my 2002 alero jumps into gear when I

Is the check eng light on go to parts store to find out code like poss unplugged air temp at air snorkal unplugged could cause this

Posted on Aug 30, 2009

  • 1 Answer

SOURCE: need timing marks for jeep liberty

necesito marcar jeep liberty 2002 3.7

Posted on Feb 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On 2002 ford explorer,4.6-v-8, when i was changing timing chain guides and adjusters the chains jumped teeth on the crankshaft. The manual says the left camshaft timing mark should be approx. @ 11:oo & the...


Look for some Youtube videos on this repair. If I remember correctly the links on this chain have different color metal for the spots that the cam tooth goes against. When each side is in the proper tooth the right and left colored links will be on the cam mark and the crank mark should be on the timing TDC mark. Sounds like the slack you describe is wrong and a tooth is off because the tensioner is allowing slack.. You need to slip a tooth one way or the other until the tensioner has room to be in a neutral position.

Mar 10, 2017 | 2002 Ford Explorer

1 Answer

My 2002 oldsmobile alero hesitates when i accel and the rpms jump


Failed Transmission-it is slipping

Time for a rebuild

Mar 20, 2013 | 2002 Oldsmobile Alero

1 Answer

How to set a timing chain on 2004 oldmobile alero


there will be a timing mark on the camshaft sprocket and crankshaft sprocket that you need to line up, i think that on the 3800 the timing marks have to be alligned to face eachother, but dont hold me to that.

Aug 09, 2011 | 2004 Oldsmobile Alero

1 Answer

What should it cost me to get timing belt and water pump change? 3.4L 2002 alero


3.4 engine is a chain motor. No timing belt or scheduled maintenance on the chain.Water pump is less than two hours labor plus cost of the pump.

Jan 22, 2011 | 2002 Oldsmobile Alero

1 Answer

Setting up timing chain for 1999 alero 2.4


TO REPLACE TIMING CHAIN YOU NEED EITHER HAYNES REPAIR MANUAL OR CHILTON REPAIR TO SEE PHOTOS OF TIMING MARKS ON TIMING CHAINS SPROCKETS AND CRANKSHAFT TIMING GEAR AND TIMING MARKS ON TIMING GEAR COVER NEAR CRANKSHAFT PULLEY.

Nov 15, 2010 | 1999 Oldsmobile Alero

1 Answer

Where are the timing marks on a 2001 Oldsmobile Alero?


Need to Know what SIZE Engine to give this Internal Technical Info to you. Externaly The Crank Sensor picks it up from Harmonic Ballancer and so there are NO EXTERNAL Marks Nor Does the Manufacturer Provide this Info
There is a 2.4L DOHC Engine and there is a PROCEDURE Rather than MARKS on the 2.4L and Requires you to Fallow EACH STEP EXACTLY and in a Very Long Texting . But On the> 3.4L Engine and INTERNALY on the 3.4L the Marks Alighn With #1 @ TDC CAM Mark is STRAIGHT DOWN and the CRANK MARK is SRTAIGHT UP < This is Internal marks on the 3.4L Engine
GM does not provide timing chain timing marks, or information to perform timing chain service without the special tools shown in the timing chain service procedure

Apr 08, 2010 | 2001 Oldsmobile Alero

1 Answer

Need to find timing mark on block


There no ignition timing marks control by computer, if your replace timing chain, the dot on cam gear at 6 o'clock and crank gear dot at 12 o'clock.

Dec 26, 2009 | 2002 Oldsmobile Alero

1 Answer

The water pump is leaking in my 2003 Oldsmobile alero


If your water pump is leaking, then it will have to be replaced. This is not a job for the beginner as you will have to rmove the timing chain cover, harmonic balancer and timing chain. If you tackle this job your self make sure you mark your valve gears, crank and replace the chain exactly the way you removed it or your timing will be off.

Dec 11, 2009 | 2003 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...