Question about 1999 Ford Expedition

1 Answer

I changed the thermostat on my 1999 ford expedition and still no heat

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Check to make sure your lower thermostat housing is not leaking. if so it will need replaced.

Posted on Jan 18, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: 1999 Ford Windstar 3.8 no heat

If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.

Posted on Mar 01, 2009

  • 645 Answers

SOURCE: 1997 ford expedition has no heat. blower works

Under the middle of the dash is a part called a blend door actuator it is located between the floor board and the heater housing. It control the door that opens and closes allowing heat to exchange.These go out all the time.

Posted on Feb 09, 2010

  • 18 Answers

SOURCE: how to change rear air suspension on 1999 ford

Change the air suspension to a non air conversion system from Strutmasters. Their kit will save you lots of money and time. Check them out!

Posted on Jul 13, 2010

  • 1 Answer

SOURCE: The 4WD will not disengage on my 1999 ford expedition

hey well i have similar problem on my 2000 awd, it seems to get stuck on 4 all the time. when i turn it grinds and thumps like heck. anybody knows how to go about this prob?

Posted on Dec 29, 2010

  • 1 Answer

SOURCE: 1999 ford Expedition caliper removal

IT IS RUSTED ON GO TO YOUTUBE AND SEARCH
"Remove Rusted Brake Rotors"

Posted on Jan 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed the thermostat on my suv and still the heat is lukewarm.


manifold heat control valve may be only partially open..

Dec 18, 2013 | 1999 Ford Expedition

1 Answer

No heat already changed the thermostat


Check vacuum hoses. There's one between engine and firewall at the passanger side that operates ur heater. This little creature dries up due heat expossure and cracks causing a vacuum leak that will trigger ur check engine light as well..

Jan 17, 2013 | Ford Cars & Trucks

1 Answer

99 expedition not enough water pressure to circulate water???


Sounds like your water pump is not doing it's job or your thermostat is not fully opening,here's a link to replace both.Here's the thermostat link.

Dec 02, 2012 | 1999 Ford Expedition

1 Answer

1999 ford expedition I am getting almost no heat in front or back. I have flushed out heatercore. I have change thermostat. When the engine is at 2.5 to 3,000 RPMs I get heat. No heat when it is idling....


Try the heater controles.There is a possibilaty with this expedition that the heater doors are not opening properly.When motor is at low RPM the vacum the motor pulls is low to.This vacum is what controls the doors and vent.You can pull vacum lines on and off ONE at a time and listen for the doors to open.There is also a good possibilaty the vent door contol switch at the dash could be bad.You would need a vacum gauge to test it though.

Dec 15, 2010 | 1999 Ford Expedition

1 Answer

Blowing but not heating


Not sure where you live - if in colder regions - have you changed from a summer to a winter thermostat?

Nov 23, 2010 | 1999 Ford Expedition

1 Answer

Vehicle is running hot and no heat


check for leaks check your rad for leaks check your heater core for any leaks check all hoses clamps for any leaks change your thermostat it my be faulty old and sticking.

Aug 31, 2010 | 1999 Ford Expedition

1 Answer

Ac works but when I turn temperture up no heat 1999 expidition


try changing the thermostat if that doesn't help check for air in the cooling system

Dec 13, 2009 | 1999 Ford Expedition

1 Answer

Raditor over heating


change the thermostat first unless the radiator is leaking all the time. thermostat is located at the end of the upper radiator hose at the engine. do that first.

Aug 07, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
1999 Ford Expedition Logo

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...