Question about 2003 Ford Expedition

1 Answer

How do Iget to the headlight bulb on my 2003 Ford Expedition?

Posted by on

  • piratepat2 Jan 25, 2009

    Thankyou.I'll check it out.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Under the hood behind where the Headlight are, There are Screw on Panels that need to be Removed to access the Bulbs and Wiring Harnesses.

Posted on Jan 25, 2009

  • Travis Humphries
    Travis Humphries Jan 25, 2009

    No Problem! Happy to Help!



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Lowbeam headlights bulbs went out on my 2004 ford expedition

It's most likely shorting out because of a water issue caused by a crack or something abnormal in the headlight case. Have the fuses been blown at all? If so, then there could be a short to ground causing them to blow fast. Gotta do some digging on your end to figure out if there are bad wires or cracks letting moisture in

Apr 02, 2014 | 2004 Ford Expedition

1 Answer

My low beams will not work on 2002 ford expedition, but the high beams work?

There is either a dual filament bulb or seperate bulbs for your headlights. For this truck, i believe that it is the dual type, meaning that there are actually two bulbs in one glass. those filaments could have simply burned out. The most likely problem is the bulbs, replace the bulbs

Feb 01, 2012 | 2002 Ford Expedition

1 Answer

I need instruction on how to replace driver side low beam head lamp on my 2003 expedition.

You have one bolt in the top center of the headlight to loosen and then 2 on top to remove and one on the outer side on the bottom to rmeove. Pull the headlight out and unplug it. Then remove the boots and replace the blown bulbs.

Feb 27, 2010 | 2003 Ford Expedition

1 Answer

High beam trouble shooting 2003 expedition

could be the multifunction switch. there may also be a headlight relay for just the high beam. check the manual for its location

Feb 05, 2010 | 2003 Ford Expedition

2 Answers

How to replace the light bulb on exterior mirror 2003 ford expedition

The one with the turnsignal intergrated into it?

If so.....

Push the Mirror FORWARD, up close to the pivot poit there is a small torx head screw - unscrew that.
At the tapered end carefully pull/pry down. That end has a small metal spring clip that holds it up, be careful with it, if it snaps, you can NOT by a new one...

May 10, 2009 | 2003 Ford Expedition

1 Answer

Bulb replacement 2004 expedition

which bulb are you trying to change? the headlight assemblies are removed by pulling up on the two tabs that are located under the hood just behind the headlight. The turn signal lamp is attached to the headlight assembly with a screw.

Mar 20, 2009 | 2000 Ford Expedition

1 Answer

Headlight bulb replacement 2005 ford expedition

open the hood push the headlight housing retaining clips rearward and then pull upward on the clip to release the headlight housing and pull the housing out and away from car to access the bulb retaining ring located on the back side rotate the bulb retaining ring counterclockwise and pull the bulb socket assembly out of the housing and when installing the new bulb do not touch the bulb surface if you do wipe with rubbing alcohol

Jan 07, 2009 | 2000 Ford Expedition

1 Answer

Headlight bulb replacement

it should come out of the back of the housing just turn it one way or the other and pull it out or there is a keeper holding it in

Nov 01, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5622 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides