Question about 1995 Chevrolet Blazer

1 Answer

On 1995 Chevy Blazer how do you change the back windshield fluid

Is the windshield fluid for the front control the windshield fluid for the back? If not how do you change it for the back wipers?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Yes, It is the Same. The front Reservoir Supplies Both the Front and the Rear.

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshield washer fluid is leaking in back on driver's side on 1999 Chevy Blazer


They run Inside , you need to replace the Rubber Line.. It is for the Rear Window Sprayer

Apr 10, 2013 | 1999 Chevrolet Blazer

1 Answer

I have transmission leak coming from the front of my 1995 chevy with a 4L60e, i already changed the pan gasket


if your shure that the pan is not leaking i would check the front seal on the transmisson. if its the front seal there should be fluid leaking from the flywheel cover.

May 18, 2012 | 1993 Chevrolet S-10 Blazer

1 Answer

95 chevy blazer 4x4, 4.3, v6, tranny fluid flows out top of fill tube. I have changed the filter and no I did not overfill it. Starts right up even when cold, but starts losing fluid right away (drove...


There should be a vent tube on your transmission. Check to make sure it is not plugged. Did it do it before you changed the fluid and filter? To properly check fluid level the vehicle needs to be running and warm and in park on a level surface. Just in case you didn't already know. IF your vent tube is open and fluid level is correct you must have internal problems.

Apr 22, 2011 | 1995 Chevrolet Blazer

2 Answers

The rear wiper on my '98 Blazer LS works fine, but the sprayer for the washer fluid doesn't spray. i checked back panel for resivuior figuring it mihgt just be empty but there isn't one. the front one is...


on my chevy blazer there are 2 pumps in the front resivior one goes to the rear wiper and the other goes to the windshield if you have 2 pumps one might be bad. there could also be something plugged in the hose. on my blazer the upper pump goes to the rear wiper. hope this helps.

Apr 19, 2011 | 1998 Chevrolet Blazer

1 Answer

How do I change wiper blades 2001 Chevy blazer


Open the cap at the end of the windshield wiper arm at the cowl of the Blazer. This will reveal the bolt that secures the wiper arm to the wiper linkage.
Unbolt the wiper arm using a 3/8-inch ratchet and socket. Place the bolt to the side, as you will reuse it later.
Pull the wiper arm up at the blade so that the blade of the wiper is pointing into the air. Then pull at the base of the arm, wiggling it slightly. It's a keyed gear, so it may take a little bit of workunderlined.png?1 to break it free, but with the right amount of wiggling, it will disengage.

Read more: How to Remove Chevy Blazer Windshield Wipers ' eHow.com http://www.ehow.com/how_6177302_remove-chevy-blazer-windshield-wipers.html#ixzz1B4pQJ39h
  • 3 Pull the wiper arm up at the blade so that the blade of the wiper is pointing into the air. Then pull at the base of the arm, wiggling it slightly. It's a keyed gear, so it may take a little bit of workunderlined.png?1 to break it free, but with the right amount of wiggling, it will disengage.

  • Read more: How to Remove Chevy Blazer Windshield Wipers ' eHow.com http://www.ehow.com/how_6177302_remove-chevy-blazer-windshield-wipers.html#ixzz1B4pJlPaV
  • 2 Unbolt the wiper arm using a 3/8-inch ratchet and socket. Place the bolt to the side, as you will reuse it later.
  • 3 Pull the wiper arm up at the blade so that the blade of the wiper is pointing into the air. Then pull at the base of the arm, wiggling it slightly. It's a keyed gear, so it may take a little bit of workunderlined.png?1 to break it free, but with the right amount of wiggling, it will disengage.

  • Read more: How to Remove Chevy Blazer Windshield Wipers ' eHow.com http://www.ehow.com/how_6177302_remove-chevy-blazer-windshield-wipers.html#ixzz1B4p1UYyB

  • 2 Unbolt the wiper arm using a 3/8-inch ratchet and socket. Place the bolt to the side, as you will reuse it later.
  • 3 Pull the wiper arm up at the blade so that the blade of the wiper is pointing into the air. Then pull at the base of the arm, wiggling it slightly. It's a keyed gear, so it may take a little bit of workunderlined.png?1 to break it free, but with the right amount of wiggling, it will disengage.

  • Read more: How to Remove Chevy Blazer Windshield Wipers ' eHow.com http://www.ehow.com/how_6177302_remove-chevy-blazer-windshield-wipers.html#ixzz1B4p1UYyB

    Jan 15, 2011 | 2001 Chevrolet Blazer

    2 Answers

    The windshield washer fluid isnt coming out for


    Yes there are two pumps located in the wiper fluid reservoir. If your in a bind, you can switch the plugs and small hose that go to them because they are both the same. The upper pump operates the back, and the lower pump operates the front. The back won't work until it gets replaced, but it beats driving backwards.

    Feb 25, 2010 | 1995 Ford Windstar

    1 Answer

    The front windshield washer fluid pump for me 2000 chevy blazer has stopped working. No sound when I press the spray button, just the wipers.


    Check the wire harness to the windshield washer pump. The pump is located in the washer fluid reservoir, if the wires are good. Chances are the washer pump needs to be replaced and you can pick up the new pump st Auto Zone or Parts Source and they will have the step by step instructions for you to get the job done with common tools. Good luck and keep me posted.

    Jan 18, 2010 | 2000 Chevrolet Blazer

    1 Answer

    Chassis & Motor VIN of Chevrolet Blazer 93


    it should be behind the front windshield when you look through the windshield outside on the drivers side

    Jun 30, 2009 | 1995 Chevrolet Blazer

    1 Answer

    Where do I put power steering fluid in a 1994 chevy blazer?


    on the front of the engine, where the fan/belt runs, there is a black tank with a round cap that unscrews off of it. make sure you use power steering fluid, and fill to correct level as indicated on dip stick which is below cap. levels vary depending on cold or hot.

    Dec 10, 2008 | 1995 Chevrolet Blazer

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    119 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    60960 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...