Question about 1990 Geo Prizm

1 Answer

Oil pressure light comes on 1990 geo prizem

Oil light comes on at idel change oil did not help drove car for 2 to 3 days now light dose not come on any one else have this hapen to them

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

Sounds like the oil pressure sending unit is on it's way out. I hope this helps. Take care and God Bless.

Posted on Jan 25, 2009

  • Bryon Agin Jan 27, 2009

    Was it the oil pressure sending unit? I'm still here if you need me.

    Bryon

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When pressing on the gas, sometimes I hear a noise like a hot rod taking off. its not a knocking noise but more like a vroom vroom noise. I was told it was the bearings ing the motor.


could be oil pump its self,dode oil pressure go up when throttle is applied,or dose it have a seperate oil chain thats worn,all the best.

Nov 16, 2015 | Cars & Trucks

1 Answer

Why dose my truck my truckturn over but has no oil presure just installed high presher oil pump


No oil pressure after hop replacement .the 6.0l has 2 supply tubes 1 for each head .also each oil rail has a dummy plug.all of which can cause a no oil pressure event.when u installed the hpp their is a fitting on the back of the pump .if that fittings o- ring was not replaced with factory o-ring it will blow out .no pressure .the truck will start if u have pressure.even if gauge is not working.so at this point u have an internal oil leak

Aug 29, 2014 | 2006 Ford F 350 Super Duty

1 Answer

I have a 2004 Dodge Durango and my oil light comes on and goes off.We have the oil changed like we should.The other day the engine light come on and today it when off after we drove it for 30 mins.


Possible causes of the oil light coming on are -
low oil pressure
dirt in the passage behind the oil pressure switch
a faulty oil pressure switch.
Most people either replace the switch or have the oil pressure checked with a mechanical gauge.

Apr 09, 2013 | 2004 Dodge Durango

1 Answer

Engine oil light on at idel goes off when driving comes on at stops


Check oil level on dipstick. Check for loose connection on oil pressure sender unit. Have the oil pressure checked using a master gauge.

Mar 28, 2013 | 2004 Dodge Stratus

1 Answer

Geo storm alternator light comes on while ideling


belt slippping.
bad alt (reg)
battery has issues. even corroded bat lugs.

Dec 15, 2012 | 1990 Geo Storm

1 Answer

Oil pressure light comes on when ideling


Trish-if the engine is warm and/or the car has been driven, you should check the oil level after it has been shut down and sits for 5 minutes. If the level is good (within one quart of being full), you need to at the very least change the oil and try to go with a higher viscosity oil. For instance, if you are using 5w-30, get 10w-40 instead. You do not mention how long it has been since you had the oiol changed, what car/year/engine, and this information should be updated so that you can be assisted more thoroughly. If the light is on 'steady' (not flickering) and the engine seems quiet and smooth, it could be a disconnected sender unit or a defective sender unit-get back here if you can and try providing more information.

Nov 09, 2011 | Cars & Trucks

3 Answers

Have a 1990 Z71 4wd that with loud engine knock.


I'd consider some fresh, clean oil & filter change first of all, if it hasn't been done . drive it for a while providing it isn't too bad, & see if it goes away, if not get back to us.

May 18, 2009 | 1990 Chevrolet C1500

1 Answer

Oil light stays on, clicking noise when i push the gas!


is it low on oil? if so it could be an internal oil leak (wouldn't be able to see) or external but you didn't say anything about that... if level is good replave the oil pressure sensor

Mar 16, 2009 | Hyundai Motor 2004 Accent

1 Answer

Oil plug came out didn't realize no oil pressure t


the oil is there to cool and lubricate the crank ( bottom end) and the cam shaft and valves (top end) the most likely out come is that you have (cooked) the engine, check to see if when you try to start dose the engine turn? if it dose then it could be the oil temp switch will need to be replaced. if the engine DOSENT turn then you have most probably welded the pistons to the block. seized the crank shaft or warped the head (head gasket) i hope this helps

Dec 01, 2008 | 2003 Ford F250 Super Duty Crew Cab

Not finding what you are looking for?
1990 Geo Prizm Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...