Question about Ford Five Hundred

1 Answer

Own a 2005 ford 500. recently had front and rear pads replaced at 93k miles. Several days later warning lights started on startup ABS etc. Several days later unable to start car, battery drained. Jumped started car and used it througout the day without problems. Following day, put key in ignition, all abs lights, repair logo etc were on. Also, radio, started without any help and cd player started initializing. Unable to start without jumper cables again. Mechanic says battery is draining but unable to id source. Can you help

Posted by on

  • Anonymous Mar 15, 2014

    car was hit in the front left and damaged now the battery is dead and when i try to jump start the car the alarm system is going sounding and the lights are flashing

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

Firstand foremost,this snota problem for a echanic tooodagnose. Ifurbatery isdrainng, u shouldcek to cifur charging system is functioningproperly. Ifur ABS lite iscoming on, probaly during dis-assemby, something went wrong witur sesors. check it out with someone knowledgeable and experienced

Posted on Jan 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

ABS ON,BRAKE RED L ON ALARM ON HARD PEDAL HOW CAN I FIND THE PROBLEM


VSC ABS and ! lights plus red (!) - Toyota Prius Forum ...

www.priusonline.com/...toyota-prius.../19804-vsc-abs-lights-plus-red.ht...

Jun 3, 2008 - 8 posts - ‎3 authors
If the accumulator fails, you will get a red brake warning light and the pump will now run continuosly until it burns out. ... hydraulic pressure to the brake system and "no"red warning lights. .... Fog Lights, PassGas, Toyota Prius General Discussion, 4, 10-13-2005 09:12 AM ... 11-13-2015 10:01 PM by Tim Lee.

Alarm with Brake Light, ABS, VSC and amber warning lights ' PriusChat

priuschat.com > ... > Gen 2 Prius Care, Maintenance and Troubleshooting
Jul 26, 2005 - Later that same day - I started getting an alarm - as soon... ... Gen 2 (2004-2009) Toyota Prius Forums > Gen 2 Prius Care, ... Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by NorthStar, Jul 26, 2005. ... I am getting the red BRAKE LIGHT, the amber waming symbol, ABS, and ... VSC, ABS, (!) and emergency brake light on
Feb 5, 2010
Brake, Brake warning, ABS, VSC appear
Oct 5, 2008
More results from priuschat.com

Nov 24, 2015 | 2005 Toyota Prius

1 Answer

How to reset brake lite on my 2005 X type jaguar?


which brake warning light is on? the xtype does not have pad wear sensors fitted. so i guess you mean the abs light or the handbrake light.more than likely its the abs light and the common problem is the reluctor rings on one or the other of the rear outer constant velocity joints corroded/ fell off get the fault codes out of the abs module to help.

Aug 22, 2015 | 2005 Jaguar X-Type

2 Answers

Abs light staying on


The ABS light comes on when there is a malfuntion in the ABS system, not when the brakes are low. On a Ford you more than likely have a dirty sensor or pick up ring on the back side of the rotor. And no you do not have to change the rear drum brakes when changing your front pads but they should be inspected.
Usually you will change 2-3 sets of front pads before the rears need to be changed.

Jun 22, 2014 | 2005 Ford F-150 SuperCab

1 Answer

Rear brakes not working proper. I have never liked the brakes on my 2500 chevy pickup. I bought the truck second hand. I have since replaced the front pads twice. The front pads were gone in 18,000...


e-brake pedal should go farther- is either out of adjustment or cable frozen- secondly sounds like only front brakes receiving enough pressure to "activate" properly- bleed all four brakes starting rear pass,then rear drive ,then front pass, then front drive- use plenty of fluid- bleed till fluid is clean without bubbles- will that long at first- this will insure not bubbles and no moisture- if a pro valve dies,you would have more problems- pedal would be really soft,would have both a brake light and abs warning lights

May 15, 2011 | 1995 Chevrolet Silverado 2500

1 Answer

Ive just bought my audi a4 S.E 1.8 petrol 1998.. with 164k...when i bought it the abs lightt was on and also the brake warning indicator light comes on and stays on flashing,and at the same time the abs...


as the mot only says the "brakes work"to a certain efficiency,(the tester does NOT check the depth/thickness of the pads),chances are your pads/discs are in need of replacement.the pads have sensors in them for wear depth, so when checking the pads,front AND rear the abs sensors can be cleaned,and if done by a seat/skoda/vw/audi dealer they can put it on the diagnostic computer to give you a definative answer (this is cheaper than guessing) I replace the pads myself but get the car "diagnosed"when any red light shows.

Jan 31, 2011 | Audi A4 Cars & Trucks

1 Answer

Recently had front & rear brakes replaced along with a new rear axle. Vehicle has 114,000 miles. The brakes shudder slightly with normal braking + some quivering of the steering wheel. With hard...


Its a good idea to turn your rotors if your putting on new pads so that you get a good seat.  The steering wheel vibration may be your new pads wearing in and trying to find a good seat.  Give it another 500 miles for break in period and if you still get the problem, then replace the pads with better ones and check to see if your rotors are not warped.  Your pads will never seat correctly if your rotors are warped and make sure you use plenty of that shim goop they give you in the package before putting on the pads.

Nov 19, 2009 | 1999 Ford Econoline

1 Answer

My 2006 F150 abs light would come on after driving it for a few miles. I changed the rear sensor and it still didn't correct the problem. I had the brake pads replaced and cleaned the front sensors. I...


It sounds like you might be having a problem with your Electronic control module. Are the only codes coming up just for the sensor? Have you recently cleaned your engine or driven in very wet weather? If so, water could have gotten into your connections at the modules and causing odd codes. I hope this helps. Jay

Apr 24, 2009 | Ford F-150 Cars & Trucks

2 Answers

2005 Dodge Durango Front Brake Squeal


Did you buy factory pads or get cheap aftermarket pads? If aftermarket did you get the ceramic? The cheap aftermarket ones tend to squeal pretty bad. Like the last comment on here, you should have your rotors turned whenever you change the pads.

Jan 13, 2009 | 2005 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

490 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63577 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...