Question about 2006 Ford F-150

Open Question

Hazard lights and dash blinking

Dash and Hazard lights blinking. Won't stop even if car is turned off.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 99 Answers

SOURCE: car wont start

First clean all battery terminals ensure there is no corrotion, after cleaning them light coat with a dab of grease to protect from further corrosion.

Although the lights may work, the battery may not have enough power to kick the starter over.

Since you specified no noise, suggest you check the starter solenoid first. Ensure the battery is good and holding the charge.
5 years old, time for a new one. 3 years old, need to have it check for CCA (Cold Cranking Amps)

Ensure your alternator is working properly. May not be charging the battery.

Posted on Dec 08, 2008

  • 909 Answers

SOURCE: red light next to hazard light button blinks when

If it's a tiny red L.E.D. like a car alarm indicator, then it's to let you know the imobilizer is set, factory fitted and set to work from your key sensor(built into the ignition switch and key)

Posted on Jul 19, 2009

  • 126 Answers

SOURCE: short in the brake lights and turn signals, no

check and replace the multifunction switch

Posted on Oct 10, 2009

  • 389 Answers

SOURCE: 1992 Ford Ranger Turn signal/Hazard light issue

Can you just check to make sure the ignition key switch is not staying over to far and not backing off when you try to start it. I had a truck that did that and it messed up my turn signals until I brought the key switch back a little after starting it. Just a simple idea. Be kind with your rating for me. Raz

Posted on Apr 19, 2010

  • 5 Answers

SOURCE: 1996 Ford Windstar tail lights and dash lights stopped working

When you turn on the headlight switch ,be it park lights or headlights, it sends power to the multi switch on the steering column. Check that out too.Mine was just dirty contacts, everything works now.

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 2004 impala, the front right turn signal doesn't work, (only works with hazard lights). And the back right signal is fast. The signal "clicking" sound is non stop but on the other hand...


If the turn signal filament of the right front park/turn lamp is known to be OK and the hazard switch is in the normal position, the hazard switch or the turn signal/multi-function switch could be defective

Oct 16, 2012 | Cars & Trucks

2 Answers

My turn signals won't come on at all?


check the fuse if good then turn on the hazard lights if they work then you probably need a turn signal flasher which is a separate flasher unit then the hazard one.it usually looks like the hazard one so with the hazards on and locate it then you will know what the signal flasher looks like and you will also know not to change the wrong flasher unit.the signal flasher is often located at or near the under dash fuse panel or somewhere in the dash you don`t say what type of car your talking about.

Dec 12, 2011 | Cars & Trucks

1 Answer

73 super bettle, turn singles light up but don't


The Flasher is located:
- Hazard flasher: Front seating area, driver side, under dash, above kick panel, mounted on firewall
- Turn signal: Front seating area, driver side, under dash, above kick panel, mounted on firewall

Hope helps.

Sep 15, 2011 | Volkswagen Beetle Cars & Trucks

1 Answer

The signal lights stopped working then the hazard lights Why?


The hazard relay is dead - it controls both. It's built into the hazard button on the dash. Replace that and you'll be fixed.

Aug 12, 2011 | 2002 Chevrolet Malibu

3 Answers

Turn signals dont work on 1993 skylark. all bulbs are good. hazard lights blink fine. turnsignal dash light stays green and doesnt blink


There are 2 separate flasher relays. 1 for the turn signals and one for the hazards. I believe you have a bad flasher relay for the turn signals. The location of that is in the front seating area on the drivers side, under the dash on the drivers side of the steering column, mounted on support bracket. I provided a picture of what it should kind of look like although the picture I gave you is an aftermarket one so the color and such may be a little different but will look the same. Don't get it mixed up with the hazard relay which is located in the front seating area on the drivers side under the dash above the kick pane lmounted on top of the convenience. I am almost 100 percent sure the flasher and hazard relay are the same so if you want to just swap them out in order to have turn signals that should work. You won't have hazards however. I hope this helps you and good luck.


clifford224_215.jpg

May 07, 2011 | 1993 Buick Skylark

2 Answers

Where is signal flashing relay located on car? my signal light just stays on when turning left or right and does not flashr blink.


TURN SIGNAL/ HAZARD FLASHER MODULE IS BELOW LEFT SIDE OF DASH. IF THE HAZARD LIGHTS WORK YOU CAN LISTEN FOR THE CLICKING.

Jan 22, 2011 | 2002 Buick Century

1 Answer

Hazard light button pushed thru housing. Can't turn off hazard lights


REMOVE HAZARD FUSE IT WILL TURN OFF FLASHER UNTIL YOU FIX HAZARD BUTTON.
YOU GOING HAVE TO REMOVE SPEEDOMETER AND TACH CLUSTER TO GET TO HAZARD SWITCH.TURN OFF RADIO FIRST BEFORE REMOVING NEGATIVE BATTERY CABLE BECAUSE YOU WILL DISABLE AIRBAGS WHILE WORKING AROUND STEERING WHEEL AND DASH AREA. WAIT 20 MINUTES BEFORE WORKING AROUND DASH AREA AFTER DISCONNECTING NEGATIVE BATTERY CABLE.

Jan 13, 2011 | 1999 Oldsmobile Alero

Not finding what you are looking for?
2006 Ford F-150 Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...