Question about Toyota Auris

Open Question

Steering column clicking noise - Auris Toyota Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: Chevy Uplander 2007 Steering column noise

you need to take this vehicle to a gm dealer right away sounds like a rod thats loose in there ?please rate my response thank you very much

Posted on Feb 02, 2009

johnthejag
  • 286 Answers

SOURCE: clicking in steering column

Hi

Check the lower steering column universal joint coupling needle rollers !

Open the hood, and get someone to wiggle the steering wheel, and using a good torch, check the lower steering column joint, for any free play, or if you can hear or feel, the clicking, and check all the clamp bolts and nuts.

Good Luck!
A FixYa rating is appreciated ....Thank you !
John.

Posted on Feb 13, 2009

  • 166 Answers

SOURCE: 2003 grand cherokee steering column noise

check the universal joint on the bottom of the steering collum, put one hand ether side of it an twist see if there is any play in it you can also see if it is stiff/seized these will both cause a noise

Posted on Oct 01, 2009

  • 29 Answers

SOURCE: turn signal lights won't work,clicking noise from

Do you mean the actual signals on the body of the car? Or the indicators in the dash?

If the actual signals aren't working, it may be a bad flasher. I don't know how to even test the flasher, you could just replace it(or them) and see how it goes!

If it's your indicators in the dash, it would be probably an LED or a short causing no power to get to the LED.

Posted on Feb 03, 2010

  • 1779 Answers

SOURCE: I have a 1993 Honda Accord, when turning the

What you hear is most likely a front axle that needs to be replaced. This is caused by a tear in the axle boot behind the wheel, which allows contaminates (sand, grit, small debris, water) to enter, which results in failure of the bearings, and the 'clicking' noise you hear. Changing the axle is a big job. I would recommend you consult a manual to see what is involved, as it's quite extensive.
To confirm my diagnosis, jack up the car, support with safety stands to allow you to safely crawl under it to inspect the boots of both axles. I am quite sure you will find tears or splits. Evidence of grease around the area is also an indicator that the boot is damaged, and axle grease is escaping. Let me know if you have any other questions. Curt

Posted on Sep 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When turning right the steering has gone hard and it makes a click noise and indicators dont turn off on their own anymore.what can it be.


Most likely the multifunction switch in the steering column that your directions a connect to a arflashers and brake lights and all kinds of other functions Has Broken typically you need to remove the steering wheel and the surrounding components of the steering column to get to it

Mar 16, 2016 | Cars & Trucks

1 Answer

1994 Buick LeSabre has clicking noise in steering column when reversing.


Could it be coming from the dash??? That car might be old enough to have a speedo cable. Another thought, I know some Caddys that had an automatic park brake release. You had to put it in gear for the Park brake to release. Hope that helps.

Feb 25, 2016 | 1994 Buick LeSabre

1 Answer

Steering wheel column noise


Steering Wheels & Grinding Noises (with Pictures) ' eHow

www.ehow.com > Cars
The typical cause of grinding noises when turning the steering wheel is low power... Worn bearings inside the steering column may create a grinding noise, but .

Sep 12, 2015 | Cars & Trucks

1 Answer

1999 chevy lumina parking lights flashing and strange clicking noise coming from the dash near the steering column even when the car is turned off and the key is removed from the ignition. How do I stop...


Sounds like you turned on your emergency flashers somehow without knowing it. The button should be on your steering column. Otherwise, find the flasher control under the dash by following the clicking noise and unplug it. Then go buy a new flasher control.

Feb 28, 2014 | Chevrolet Lumina Cars & Trucks

1 Answer

I want to know if it is dangerous to drive with a squeeky clock spring in my van


Yes its risky. Dont drive with that noise from clock spring.Its indication of its failure.
I believe this is the "clockspring" -- the electrical cable inside the steering column that connects your steering-wheel-mounted electrical controls to the rest of the car. ("Controls" used be just the horn.) The cable wraps around the steering column so it can turn with the steering wheel. Sometimes it starts to rub and squeak.

For more troubleshooting on steering Squeak issues and steering column problems,click the link below and follow the troubleshooting details:-----
http://alltypesofpartsreplacing.blogspot.com/2012/10/steering-squeaks.html
----------
These details will help.
Thanks.

Oct 14, 2012 | 2007 Pontiac Montana

1 Answer

I have a freelander 05 td4 diesel When you turn the steering wheel I'm getting a clicking noise from steering Column Has anyone else had this problem ?


It really does not hurt anything but your ears. However, if the noise is annoying you, there is a replacement intermediate steering column shaft available from the dealer that is re-designed to fix this problem.

May 18, 2012 | 2005 Land Rover Freelander

1 Answer

I've had worsening problems with steering noise clicking and tension in the steering column when turning rt. or left. The steering column was replaced by Toyota (very expensive) and it has started again....


there was a service bulletin for a steering column clunking, but a clicking might be due to a torn cv boot located on your drive axles. If it is the cv boot then there is sometimes grease that leaks onto your front rims if enough gease leaks.

Oct 06, 2009 | 2002 Toyota Sienna

1 Answer

Steering wheel clicks on 1998 Subaru Legacy Outback wagon


steering column bearing sounds like a worn out steering column... jack the front wheels off the ground both sides relieve load on steering wheel to see if it lessens the amount of feel and noise, if it does it shoud be the column bearing, replace bearings or complete column,,, also try with the wheels off the ground and safely supported to manualy steer the wheels by hand and see if you feel in roughness or hear any noises,should some minor resistance but be smooth in it movement if everything suspension and steering component wise is in good working condition... please rate my help.. thanks...

Aug 05, 2009 | 1997 Subaru Outback

1 Answer

2007 ford focus clicking noise in steering column


This clicking noise that you said does it do it when you turn? If so your problem lies in your CVJoints. Constant velocity joints are attached to the steering mechanism. Try an experiment first. Get the vehicle at about 15 mph and do a small donut (controlled) parking lot would be easier for this and safer. Then turn the opposite direction. If the clicking noise is on both directions then you might as well replace both inner and outer CV joints for the right and left side. It might be your rack and pinion as well. The joints fail first before your rack and pinion so check that first. You may want to see the fluid level on the rack and pinion to see if that was the problem. Check the cheapest thing first. Let me know Gabe.

Jan 25, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...