Question about 2003 Jeep Liberty

Open Question

Is jeep 2002 and 2003 transmission (line pressure sensor) the same ?

Won't shift gears..have forward and reverse,park..

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Transmission wont shift into reverse

By the grayish color, fluid being thick, and metal shavings, the clutches are pretty much worn out. It's time to either rebuilding your transmission or just installing a good used one. The fluid normally should be a reddish color. The gray is from the actual clutch material going away.

Posted on Aug 17, 2008

Ad
  • 6982 Answers

SOURCE: Transmission -1997 Grand Cherokee laredo 4x4

Sounds like the lockup torque converter has failed. Repair requires trans removal and possible rebuild if converter has contaminated unit. Have a trans shop verify!!

Posted on Jan 21, 2009

  • 1 Answer

SOURCE: Transmission problem

I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid?

Posted on Mar 07, 2009

  • 6982 Answers

SOURCE: TRANSMISSION

sounds like either a bad speed sensor or controller. shift points are too high, should be at 2000 or slightly less. if fluid is good and clean and shifts do not flair, check those control units. Not sure about calibrate...could mean out of calibration...Id ask
another tech about that. (i don't know everything!)

Posted on Mar 12, 2009

csmock132
  • 4669 Answers

SOURCE: 2004 Jeep Wrangler - Clunking Noise when shifting out of Park

It could be lash in the differential which is normal, but it could also be a loose u-joint in the driveshaft. Check the rear driveshaft u-joints.

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why the transmissiom won' engage in any gear


Transmission won't engage Drive or Reverse - EricTheCarGuy

www.ericthecarguy.com/.../53999-transmission-won-t-engage-drive-or-r...
This transmission shifted smooth and strong through all gears until today when it stopped all of ... Any idea on where we should start tackling this issue? .... Also, make sure that the pressure tester is not leaking or you will run the tranny dry(use ...

Gear shifter goes from park to drive with no effect. Won't ...


Nov 26, 2015 | Cars & Trucks

2 Answers

How do i trouble shoot automatic transmission that shifts from park to reverse with the gear shift but the car will not move?


Sounds like the shift cable is off the transmission under the hood. Raise the hood and check to see if the cable is moving the linkage going into the transmission when the shift lever is moved in the car. Be sure to have park brake on.

Sep 26, 2014 | 2001 Daewoo Leganza

1 Answer

F250 1998 light duty won't shift out of park


For car not changing gears and not shifting out of park mode ,it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========


NO REVERSE ON TRANSMISSION
http://alltypesofpartsreplacing.blogspot.com/2012/12/no-reverse-on-transmission.html
-------------

Transmission fluid leak, transmission gears slip,
http://alltypesofpartsreplacing.blogspot.com/2012/12/transmission-fluid-leak-transmission.html
----------


These will help.

Thanks.

Dec 06, 2012 | 1998 Ford F250 SuperCab

1 Answer

Shifter is erratic. wont start in park. drives forward when shifted to reverse, sometimes drives forward when in park. sometimes reverse is neutral (which is good so it will start!!!) what is going on???


It sounds like the linkage at the transmission has come loose. Have someone get inside and move the shift lever from gear to gear so you can see where the linkage is on your transmission. You'll have to climb under ypou truck to see this, on the drivers side. check to see that all the bolts are tight. Your switch that allows you truck to start in Park or Neutral is located there.

Oct 25, 2012 | Dodge Ram Pickup 1500 Cars & Trucks

1 Answer

Transmission Fluid Pressure Sensor/Switch


I had a similar problem in my Mazda truck before. There is a pressure switch on the side of my truck's automatic gear box. The switch is connected to the engine vacuum system. When the switch leaks, the vacuum sucked the transmission oil through the vacuum line to the engine over time. Have you checked your transmission oil level? If the oil level is low, that's probably the reason. I was still able to drive back home by adding sufficient amount of transmission oil.

Good luck.

Stephen

Aug 07, 2012 | Chrysler PT Cruiser Cars & Trucks

2 Answers

I have a 2004 Jeep Wrangler 4 cyl. The CEL came on. Had no power for a little bit. Went to autozone and it pulled code P0870. Any suggestions.


po 870 refers to transmission fluid pressure- check fluid level of trans while parked with engine running and the jeep level.- if level is ok- might be time to have filter and fluid changed

Sep 15, 2011 | 2004 Jeep Wrangler

1 Answer

1996 Jeep Grand Cherokee. Transmission problems. when the gear selector is in reverse, it doesn't engage in reverse. When you go to neutral, it drives forward but doesn't shift through the...


Put the vehicle in Park, disconnect the shifter from the shift lever on the trans, adjust the linkage or cable so the connection is clearly a slip in/on connection and tighten things back up. Hopefully this will solve your non-reverse. As for all the gunk and metal shavings, friend, you better have another tranny standing by in your garage when this one stops working completely.

Jun 09, 2017 | Jeep Grand Cherokee Cars & Trucks

1 Answer

The gear shift is locked in place and will not shift into reverse. The vehicle has a shift release button on the console to the right of the shifter. When depressed the button unlocks the shifter and the...


It has a brake-transaxle shift interlock. You should just push the brake in to shift, but if you have done that, and it still won't shift, with foot on the brake, push the shifter all the way into park. Sometimes they don't always go into park all the way. Also if you park on a hill, it puts pressure on the btsi, so you cant shift it. Have someone push the vehicle back, just enough to take the pressure off and it should shift. I had this happen to me with my Grand Am.

Apr 17, 2011 | Pontiac Grand Prix Cars & Trucks

2 Answers

The jeep always acts like its in gear it will move forward in nutral and will not go in reverse


They locking nut has come loose on the shift control arm on the side of the transmission, you need to put it in park and adjust it so the arm is all the way forward and the shift lever is all the way into the Park position, this should get rid of the car moving when the shifter lever is not in reverse.

Jul 19, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Jeep Liberty Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...