Question about Cars & Trucks

1 Answer

1993 izuzu rodeo code 54

It shoes code 54. when driving it starts to starve for gas or misc. turn key off and start again seems to run fine

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

AutoZone will usually diagnose codes for free in hopes of selling you the parts. Sounds like a fuel filter but could be a weak fuel pump. It is most likely an electric pump located inside the fuel tank.

Posted on Jan 17, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Car Stops running while driving

clean the EGR, carbon deposit builds up over time

Posted on Aug 27, 2008

  • 1 Answer

SOURCE: Stalling during driving

I have a 95 940 that was stalling, replaced fuel injection relay

Posted on Sep 08, 2008

  • 178 Answers

SOURCE: 1995 Isuzu Rodeo starting problem.

Hello first thing i would start with is check your idle screw it may be set to low if the choke linkage is sticking .first take your breather off so you can see the choke linkage look to see where the plate is positioned is it fully closed have somone try starting with out touching the gas pedal if it doesnt start slightly open the choke plate if it starts you need a choke adjustment check to see if its manuel linkage, vacuum operated,or electrical. if vacuum check lines for dry cracks or splits preventing choke operation if electrical you need to test the power wire at the choke also test for good ground if mechanical check adjustment screw for curb idle to see if its set to low.goodluck please rate

Posted on Oct 01, 2008

  • 16 Answers

SOURCE: Key stuck in the ignition of 2001 Izuzu Rodeo

I have had a similar issue with my 2004 Accender and my 1998 Chevrolet Lumina.

In my case both vehicles are automatics and for some reason the park sensor did not pick up that the shifter was moved to the park position. All I have had to do is to place my foot on the brake (for safety) then pull the shifter into gear and back to park a few times and it took and the key released.

Additionally, the steering wheel will not lock into place unless the car is fully in Park, this will also tell you that you might want to either check and replace the sensor or just work with the shifter a little till it works again.

Posted on Nov 16, 2008

stevenhurc
  • 450 Answers

SOURCE: !999 isuzu rodeo's key wont turn to start tyhe

try wiggling key around rapidly and up and down while trying to turn on
key and ignition barrel are worn and need replacing

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Grinding noise when starting '98 Izuzu Rodeo


Upload video please then i might have a better idea

Jul 15, 2013 | Cars & Trucks

1 Answer

My car seems to be starving for gas


Yes you may replace your fuel filter and check for the adjustment of the carburetor float level. Try also cleaning the whole carb specially the metering orifice and other small passages.

Oct 24, 2012 | 1987 Cadillac Brougham

1 Answer

I have a 93 K3500 with a 454. Truck was running fine, started no problem, ran great. Driving the other day, turn the corner and the engine quit. Cranked the engine, fired up for 2-3 seconds then quit, ...


Before starting the engine, the fuel pump should only run for a few seconds when the key is first turned, to pressurize the fuel system. Even though the pump appears to be running, you may either have not enough or too much pressure for the engine to keep running (fuel pump or pressure regulator). I think it may just be a coincidence the engine quit while turning a corner, but the gas in your tank may have been so low it sloshed away from what is likely a very old pump, starving it and causing it to failure.

Jul 03, 2017 | 1993 Chevrolet C1500

1 Answer

I have a 1996 izuzu rodeo, when i let the car sit over night i go to turn the car on and i get no 3 second prime out of the fuel pump, if i throw a spray of eather in her, it will start right up, and will...


Try and turn the ignition over ,and over,then stop,then try and start it,if it starts,then the fuel pump is loosing it`s prime,check the fuel pressure regulator.

Jan 26, 2010 | 1996 Isuzu Rodeo

2 Answers

Started missing while driving; then difficult to start then would not start . Seems to be getting no gass. All happened today. was running fine.


has the fuel filter been changed and can you hear the fuel pump in the gas tank come when the key is turned to the on position - should come on for 3 seconds to build press. for starting car

Sep 30, 2009 | 1993 Buick Roadmaster

1 Answer

Rodeo won't start after driving until it cools down


it's probably a fuel injection problem. the seals wear or get some little bit of junk in seal surface and are unable to completely close. it's not a problem as long as the engine is running, the seals let in a little more fuel and the computer adjusts for it. after you shut it off the leaky seals let the fuel into the cylinders and then if you try to start it up it is for all intents and purposes a flooded engine. if you don't try to start it again for a good while the fuel that leaked into the cylinders evaporates or runs down into your oil pan. anyway, it's not there and so your engine is not flooded and it starts like it's supposed to. obviously i haven't looked at your vehicle and that's just a guess but it's based on vehicles i have seen. hope that helps

Jun 03, 2009 | 1992 Isuzu Rodeo

1 Answer

CAN'T RESET ALARM SYSTEM ON A 1996 IZUZU RODEO


try turning the key to the on position (not start) then to off 5 times quickly. this may reset it. on the 5th time the power locks will lock then unlock quickly if done right.

Apr 23, 2009 | 2001 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...