Question about Cars & Trucks
Need to get 12 volt power to the trailer.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
it will be labled cigarette lighter it should be red in color and be a 10 amp fuse. there is a fuse block on the drivers sider under the dash near the emergency brake / hood release. please rate this...thanks
Posted on Sep 23, 2008
You are correct. There is a fuse in the underhood fuse/relay compartment that powers up the pin. It is one of the larger fuses and should be labeled as "AUX". Also check that the power wire is connected to the AUX bolt terminal. They shipped from the factory disconnected and the cable was zip-tied to something below the fuse box.
Posted on Aug 26, 2009
Testimonial: "I knew there had to be something needed done, I'll check in the morning under the fuse panel for a wire to terminate and see what happens. sounds log"
I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...
Posted on Oct 01, 2009
Hi, the power terminal to the 7 way , is not hooked up from the factory. In order to hook this up, you must locate 2 wires under the hood. The 1st wire, is between the driver fender, and the fuse box. This wire is red , and taped up. Grab hold od this wire, and pull it out of the tape. It has an eyelet on the end of it. The next wire is below the steering column, same scenario, red wire, with an eyelet, pull this out of the tape, route both wires to the front of the fuse box (underhood), take the cover off of the fuse box, you will find 2 silver threaded dtuds on the front of the fuse panel. 1 larger than the other.route these 2 wires to these two studs, and secure with 2 metric nuts. You will have to get these. does not matter which wires go where, as both studs are battery power, and are both fused. the wires will only go on 1 way anyway. after the nuts are tightened, reinstall the cover, and you will have power at the 7 way. Good luck...
Posted on Sep 23, 2010
Tips for a great answer:
Aug 31, 2017 | Cars & Trucks
Aug 09, 2016 | Cars & Trucks
Nov 08, 2015 | Cars & Trucks
Jul 08, 2015 | Cars & Trucks
May 16, 2015 | Cars & Trucks
Apr 03, 2015 | Cars & Trucks
Mar 03, 2015 | Cars & Trucks
Mar 14, 2013 | Cars & Trucks
May 15, 2012 | 2005 Chevrolet Suburban
Aug 26, 2009 | 2005 Chevrolet Silverado
69 people viewed this question
Usually answered in minutes!