Question about 2002 Isuzu Rodeo

Open Question

My 2002 rodeo is having idle/stalling problems and the engine revs high then drops. i changed the egr and put in a new air filter. any ideas?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stevenhurc
  • 450 Answers

SOURCE: engine light was on and engine idles rough.

these O2 sensors are cat convertor check sensors. id be checking cat convertors and hopefully you should try replacing if not all ready is the front bank 2, O2 sensor
if you have scanner can you see fuel trims in data display to confirm high fuel trim only on bank 2 either +-5 or more indicates problem and if bank 2 sensor 2 has fixed high 700mv reading cat no good(warm idling)

Posted on Jul 10, 2009

  • 52 Answers

SOURCE: motor idling to high in my 1999 rodeo . changed

It sounds like it might be your throttle position sensor. Is your check engine lite on?

Posted on Aug 05, 2009

  • 2 Answers

SOURCE: 991 Isuzu 2.6l petrol runninf problem!

I realise you have probably solved this problem by now so sorry for the late news mate . Had a similar prob and it turned out to be an alternator malfunction . I replace the brushes and off she went . These things send voltage from the alt . to a fuel pump relay or whatever so the pump wont run if the eng isn't (or the alt isn't outputting any voltage.) . Hope you already had it sorted . But I hope this helps if not . Cheers Simon .

Posted on Aug 15, 2009

honeymokey
  • 3113 Answers

SOURCE: how to fix high idle

Sounds like a vacuumn leak.

Posted on Sep 28, 2009

  • 1 Answer

SOURCE: I have a 2000 Isuzu Rodeo, V6. The car stalls at

it's the EGR valve and can be fixed by anyone. It involves disconnecting the battery, remove electrical connection, and removing 2 screws and cleaning the surface area well and replacing it as well as the gasket. A new EGR valve runs around $120 and trust me you can fix this and save hundreds!

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the engine revs drop too low and sometimes stalling when I engage any gear?


This can be either an engine management issue (bad idle air control) or a transmission issue if an automatic trans (torque converter lock up problem). Idle air control can often be cleaned so = cheap fix. Trans problem not so easy.

May 27, 2016 | Cars & Trucks

2 Answers

2002 rodeo, starts and when put on gear stalls


Automatic transmission ??
Check engine lamp illuminated ??
Cold engine idle speed ??
Warm engine idle speed ??
IAC (Idle air control) system operation ??

May 28, 2015 | 2002 Isuzu Rodeo

1 Answer

1999 isuzu rodeo LS: Revs high sometimes then revs low to the point it stalls. goes back and forth , won't maintain a level idle. I have to press the gas pedal so it won't stall, so either im stalling at a...


Do you have a check engine light? Which engine? My 1996 Trooper with a 3.2 D.O.H.C. is awful for plugging up the E.G.R. I have cleaned it several times! Good Luck!

Mar 21, 2010 | 1999 Isuzu Rodeo

4 Answers

My 2003 rodeo sometimes will idle erradicly and stall is this a computer issue or just dirty petrol


I have reviewed your problem and have the fallowing for you to aces.
I have had 2- Rodeo's first was a 4 cylinder, and the one I am driving now is a 4 wheel drive 6 cylinder.
Both have given me problems with engine stalling and rough idling.
I have also found problems with the check engine light.

Things I have found to cure problems.
First, after 75 or 80K, you will need to change and service several things.
(1) EGR sensor, this unit sits to the rear left side of engine and will greatly contribute to poor idling and a computer, check engine light from time to time. This unit cost about $95.00 and autozone will warranty for life. The unit is easy to remove and replace, it has 2- bolts and a 4 or 6 wire plastic connector on it top.
(2) You fuel filter, this unit is located under the drivers side door and is also easy to remove and replace. Cost about $15.00.
(3) Last, fuel pump, now my last Rodeo had bad fuel and I had to replace the pump and that is a job and a half.
The fuel pump is located in the fuel tank and the tank will have to be dropped, to replace it.
I was able to pick up a used pump at a local junk yard, because of the price and availability. You may have to buy from dealer.
Hope this information has been of good help to you.
Have fun. P.S. My first Rodeo blew up after 227K and the one I am driving now has over 140K.
Please rate....

Nov 09, 2009 | 2003 Isuzu Rodeo

1 Answer

I have a peugeot 306 1.4 v reg. when at idle ,the revs are about 1100. when i accelerate the revs at first drop and for a **** second and you think the engine is going to stall but all of a sudden the revs...


check ur air flow take the air filter top off and take the air filter out then try it a few time if ok put new air filter in if not check the carb

Sep 24, 2009 | 1991 Peugeot 405

3 Answers

94 altima stalling


check the vacuum line and map sensor

Jul 16, 2009 | 1994 Nissan Altima

3 Answers

2002 GMC Yukon, erratic idle(hi-low) when cold. 125K miles.


i now for a fact that it is the egr valve . carbon balls in side you have to take it of and clean them out

Nov 17, 2008 | 2002 GMC Yukon Denali

3 Answers

1998 Rodeo TF Series 2WD 5-speed manual


vacuum leak......bad tps.......bad mass airflow meter system........any of those are suspect...... also check for bad ground at battery to be sure all is not computer freak out from bad readings ...good luck

Oct 24, 2008 | 1998 Isuzu Rodeo

1 Answer

1998 Holden Rodeo TR series 5-speed manual 2WD


run the fault codes
look for ambient temp sensor or baro sensor problems

Jun 30, 2017 | 1992 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...