Question about Cars & Trucks

Open Question

Define engine code p20b9

2011 ford f-350 6.7 deisel clear code comes right back on

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 113 Answers

SOURCE: ford dtc po1000

try unhooking ur battery for 30 min

Posted on Jun 16, 2008

SOURCE: ford focus 1.8 turbo deisel 1999.

do not understand you what you mean. assuming your car was ok before you changed f/filter you need to bleed the fuel system of air. esiest to do would be to loosen fuel line at the injectors and have assistant crank the engine while you observe for clear fuel leak without any air bubbles from fuel line.tighten fuel lines and start engine. might have to repeat a few times. good luck.

Posted on Aug 05, 2008

  • 1 Answer

SOURCE: 2002 F-350 7.3 liter deisel engine heater

There should be a small wire harness on the inside of the driver side tow hook under the bumper. The chord is very short and has a cap over the plug. Just reach in and you'll find a black cable about 1/2" thick. There's another wire tapped into it that has the plug end.

Posted on Jan 09, 2009

  • 2 Answers

SOURCE: 2008 f350 ford deisel 6.4 engine error code #2455

particulate filter sensor high circut sensor needs to be replaced

Posted on Apr 20, 2010

  • 1 Answer

SOURCE: 07 lexus rx 350 with check engine light code p0304

Hi, did you ever get an answer? I have the same issue. Thanks.

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Don't have any compression the motor of a 7.3 deisel


Broken timing chain or timing gear. I assume the engine is cranking. Could be broken camshaft.

Absolutely trashed rings, holes in pistons. would give you blow-by

Mar 26, 2014 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

2005 ford f350 - engine cuts out


deisel injector driver scan it look for multiple injector codes

May 14, 2010 | 2005 Ford F 350 Super Duty

1 Answer

2008 f350 ford deisel 6.4 engine error code #2455 what is it?


particulate filter sensor high circut sensor needs to be replaced

Apr 20, 2010 | 2008 Ford F-350

1 Answer

07 lexus rx 350 with check engine light code p0304


Hi, did you ever get an answer? I have the same issue. Thanks.

Mar 23, 2010 | 2007 Lexus RX 350 FWD

1 Answer

2000 F-350, 7.3 "P0603 Engine Code"


The P0603 is is a KAM alive code. It could of come on because the battery was disconnected or there is a bad connection or defective battery.
Clear codes, do a wiggle test and recheck for codes.
I guess I would of liked to of known if there were any other codes back when you had the issue with the truck being sluggish issue and unresponsive throttle pedal. It may have been do to an active code that was stored and then after it was cleared then the throttle worked again. Let me know if there is anything else you can add or how you are making out.

Mar 21, 2010 | 2000 Ford F350 Super Duty Super Cab

1 Answer

2002 F-350 7.3 liter deisel engine heater


There should be a small wire harness on the inside of the driver side tow hook under the bumper. The chord is very short and has a cap over the plug. Just reach in and you'll find a black cable about 1/2" thick. There's another wire tapped into it that has the plug end.

Dec 14, 2008 | 2002 Ford F350 Super Duty DRW Reg. Cab

1 Answer

Help


right where the fuel filter is there is a primer you break the breather nut close back then prime(pump)break you will get air and deisel frouthy like bubble do this till deisel (fuel)comes clear,.,or start engine and break #1 injector line you wil see frouth lock back proceed to do remaining 3 injectors till frouth is out you will find engine dying every time you break injector,so lock off and continue with rest till it idle good

Sep 10, 2008 | 2002 Mitsubishi Montero

1 Answer

Ford focus 1.8 turbo deisel 1999.


do not understand you what you mean. assuming your car was ok before you changed f/filter you need to bleed the fuel system of air. esiest to do would be to loosen fuel line at the injectors and have assistant crank the engine while you observe for clear fuel leak without any air bubbles from fuel line.tighten fuel lines and start engine. might have to repeat a few times. good luck.

Jul 03, 2008 | 2000 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

799 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...