Question about 2000 Mitsubishi Montero Sport

1 Answer

What are signs fuel pump for 2000 Mitsubishi Montero are going out?

2000 Montero is turning off while both idling & driving.Had trouble starting it. Could the fuel pump be going out?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Could be cam shaft sensor or timing belt

Posted on Jan 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 137 Answers

SOURCE: 2000 Mitsubishi Montero 4 wheel drive indicator light flashes

get oil changed in gearbox and the switch on the box

Posted on Jul 08, 2009

  • 393 Answers

SOURCE: 2000 Montero limited steering column noise / squeaking

try spraying some armor all where wheel meets the column covers

Posted on Dec 18, 2008

johnny5846
  • 379 Answers

SOURCE: 2000 MITSUBISHI MONTERO BATTERY CHANGE

manufacturer does not provide a specific computer relearn procedure for obtaining proper driveability . if the battery was disconnected or replaced , driving the vehicle will enable the computer to preform a relearn procedure for obtaining proper driveability , driveability may differ from what you are used to until computer has fully completed the relearn procedure . cheers

Posted on Jan 09, 2009

mjvgamer
  • 7 Answers

SOURCE: how to change the fuel pump on a 1994 Mitsubishi Montero LS 3L V6

just for you REMOVAL & INSTALLATION
See Figures 1 and 2
WARNING In almost every case, replacing the Mitsubishi electric fuel pump requires removal of the fuel tank. Please refer to the fuel tank removal and installation procedure at the end of this section.

  1. Lift or move aside the carpet in the rear cargo area.
  2. Remove the oval cover plate from the access hole.
  3. Disconnect the fuel pump harness connector at the rear of the fuel tank.
  4. Start the engine, allowing it to run until it runs out of fuel. This relieves pressure within the fuel system.
  5. Turn the ignition switch OFF and disconnect the negative battery cable.
  6. Remove the fuel filler cap.
  7. Drain the fuel from the fuel tank into suitable container(s), each with an airtight lid.
  8. Carefully, and using two wrenches on the fittings, disconnect the high pressure fuel line and the main fuel line from the pump. Remove the high pressure fuel hose at the body-side main pipe connection, unfasten the pump-side connection. Wrap each joint in a rag before loosening; some pressure may remain within the system.
  9. Remove the fuel pump retaining nuts and carefully remove the pump from the tank.
The fuel pump may still contain liquid fuel. Drain it into a suitable container with an airtight lid before performing any tests or inspections.
To install:
  1. Carefully install the pump into the tank and install the 6 retaining nuts onto the studs. Tighten the nuts evenly and in a crisscross pattern to 12 ft. lbs. (16 Nm).
  2. Reinstall the high pressure and supply line to the pump.
WARNING Take great care when connecting the threaded high pressure lines. Start the threads by hand, then, while holding the hose side to keep it from turning, tighten the flare nut to 27 ft. lbs. (37 Nm).
  1. Connect the pump wiring harness.
  2. Connect the negative battery cable. Turn the ignition key to ON but do not start the engine. You should hear the pump running. Allow it to run for about 10 seconds to build line pressure, then start the engine.
  3. After the engine has run smoothly for a minute or two, shut the ignition off and check the work area for any trace of leakage. Attend to any fuel leaks immediately, remembering that the system has repressurized and must be handled safely.
  4. Reinstall the cover on the access hole and replace the carpet in the cargo area.
0900c152800547c3.jpgFig. 1: Components of the fuel pump and fuel tank 0900c152800547c4.jpgFig. 2: Components of the fuel pump-all models similarTESTING
When diagnosing engine problems, particularly a "no start" condition, the fuel pump function should be checked. Because of the difficulty in reaching the fuel pump connections, Mitsubishi automobiles have a conveniently located test connector under the hood. V6 Monteros have the connector taped to a wiring harness inside the right front kick panel, near the ECM and relays.
This connector bypasses all of the controls in the system (ignition switch, pump relay, etc.) and sends voltage directly to the pump. When power is applied to the pump you should be able to hear it running, although the in-tank pumps require you remove the fuel filler cap and listen at the filler.
To use the test connector, make certain the ignition is OFF. Great damage may be caused if the system is tested with the key on. Locate the test connector in the engine compartment (on later Monteros it is located under the right-hand side of the dashboard)-it is generally on a short lead out of a wiring harness and looks like a plug that isn't connected to anything. Once found, use a jumper wire to connect the test terminal to the positive battery terminal. Listen for the fuel pump; if it runs, you know the pump motor is good. While the pump is running, gently squeeze one of the fuel lines and confirm that the pump is delivering fuel pressure. If it does not run, the pump itself is most likely defective OR the connector to the pump is faulty.
When the pump is removed from the tank, it may be checked by applying battery voltage (+) to the connector and grounding the housing. Only run the pump for one or two seconds during this test; the pump can be damaged by running without liquid.
CAUTION Make certain the pump has been drained of residual fuel and is free of fuel vapors. Connecting and removing the test leads will cause sparks which can ignite any vapor in the area.

Posted on Jan 18, 2009

  • 85 Answers

SOURCE: my 2000 mitsubishi galant es went dead, motor will turn over but

do you have spark? How do you know if your timing belt is good? sometimes it doesnt break just shed the teeth which could be missing under the crankshaft. The best way to check is to have two people. have one try to start the car and see if the camshaft is actually spinning. The crankshaft will always turn but if the teeth are gone on timing belt this would cause the belt to stay in one position not moving the camshaft. so if you can remove the upper timing belt cover and do this quick inspection with someone that will tell you for sure. if it does look like it is spinning then by hand turn engine very slowly with plug coil wires removed. and make sure teeth are all there. It couldve jumped timing. (valve timing)

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Mitsubishi Montero won't start. Replaced the starter and fuel pump and filter.


Does vehicle engine turn over. If yes, then pay attention to fuel system. Check for good power and ground at fuel pump connector. If no power check fuel pump fuse, relay and for open wires (power, ground) to fuel pump.

Feb 07, 2016 | 2002 Mitsubishi Montero Sport

1 Answer

Have a 1989 dodge raider with the 3.0l v6 that dies when I turn on the lights it has a new battery and alternator what could the issue be?


1989 raider / montero wont start need help please ' Mitsubishi 4x4 ...

www.4x4wire.com/forums/showflat.php?Number=1128085
Nov 20, 2008 - I have a 1989 dodge raider / montero the thing wont start. ... If it doeslight off, I'd suspect a fuel pump problem. Regards, Eric W. '89 Dodge Raider -- 3.0L V6, MT, SWB ... It sounds like a bad ECM if it's the V6. ... Also the truck was weird i started it up ran it for a moment and it died first thing i assumed it was ... 89' Gen I Montero rough idle/misfire and stall problems ...
Jun 28, 2011
Really rough idling and shakes ' Mitsubishi 4x4 & SUV Tech ...
Dec 20, 2010
1990 montero fuel pump fuse ' Mitsubishi 4x4 & SUV Tech ...
Jul 15, 2008
Raider won't start in this artic weather ' Mitsubishi 4x4 & SUV ...
Feb 5, 2007
More results from www.4x4wire.com

1989 Dodge Raider - Fixya

www.fixya.com/cars/t1360572-1989_dodge_raider
Jan 28, 2009 - 1989 Dodge Raider A few weeks ago, I was driving home when all of a ... I'll go back an hour or so later and it will start, warm up then die. ... I have replaced the plugs, wires, distributor, brain, basically .... If you are getting power to anything else (such as the interior light) .... 1989 Dodge Raider 3.0 L V6 EFI.

Dec 28, 2015 | Dodge Cars & Trucks

1 Answer

1990 mitsubishi montero fuel pump relay is at


1991 Mitsubishi Montero fuel pump check terminal - YouTube

? 1:57
www.youtube.com/watch?v=ZrmcQHcW_1U
Jul 6, 2011 - Uploaded by jasonX223
Here is a 1991 Mitsubishi Montero. ... The fuel pump has voltage in the start position,. ... 1991 Mitsubishi Montero fuel pump check terminal .... Fuel Pump Electrical Test - Relay and Fuse check - Advance Auto Parts - Duration: ...

Oct 07, 2015 | Mitsubishi Cars & Trucks

1 Answer

Fuel pump pressure


And what was the question related to this
http://www.bing.com/videos/search?q=2000+Mitsubishi+Montero+Sport++Fuel+pump+pressure&FORM=HDRSC3

http://www.bing.com/videos/search?q=2000+Mitsubishi+Montero+Sport++Fuel+pump+pressure&FORM=HDRSC3

May 11, 2015 | 2000 Mitsubishi Montero Sport

1 Answer

I have a 2002 montero sport 2wd v6 automatic, it jerks when I go up hills and excelerate down the highway, it also idles a little rough. The service engine light was going on and off and now its just on...


Have a scan done at autozone or O'reilleys to get the diagnostic trouble codes read, and go from there. Anytime the light comes on when running, the computer has set a trouble code. It will direct you to the problem.
Have the fuel pressure tested to see if it is the fuel pump. If fuel pressure is correct, it may be your catalytic converter. But get the codes first-they should point you in the right direction.

Apr 25, 2013 | 2002 Mitsubishi Montero Sport

1 Answer

Ignition


Check your fuel filter and fuel pump.

Nov 05, 2012 | 2000 Mitsubishi Montero Sport

1 Answer

Need location of a fuel temperature sensor,code po181...How do I fix the problem?


fuel temp sensor is on the side of the in tank fuel pump

May 21, 2012 | Cars & Trucks

1 Answer

2000 Mitsubishi montero sport limited keeps dying while driving


my monterosport 2001 runs great till you come to a stop sign the rpms drop and it dies start it back up revs itself and rpms drop and it dies. we can start it up rev it and it clearsup and idles but later on when you come to a stop it dies again we have cleaned the egr valave and still same thing could the tps be the problem or what?

Apr 24, 2012 | 2001 Mitsubishi Montero Sport 4WD

1 Answer

How to replace fuel filter on 2000 mitsubishi montero. 6 cyl, 4 wheel drive


unscrew the old filtre from housing and fill new one with clean fuel refit and prime pump top of filtre untill it feels stiff to push then start car normally iam presuming its a diesol you have

Apr 04, 2010 | 2000 Mitsubishi Montero

Not finding what you are looking for?
2000 Mitsubishi Montero Sport Logo

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...