Question about 2010 Cadillac SRX
Call the nearest caddilac dealer they will tell u where it is for free
Posted on Jan 17, 2013
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: fuse box location
I have a '99 Deville. Had the same problem. In the glove box, there are two toggles for Traction Control and Valet. Toggle the Valet one and try the remote on your key or the buttons in your dash.
For mine, someone had engaged the Valet to "ON" and locked out the remote trunk and fuel door.
Posted on Oct 31, 2008
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
Posted on Jan 25, 2009
Directly under the engine. You'll see a large smooth portion under there that looks like the underside of a bath tub and on the lowest portion of that is a bolt. Thats your oil reservoir where you drain your oil. The filter should be located near that pointing toward the front of the vehicle. GM OEM filters are usually black but could be white and are almost always 3" filters so a filter wrench that fits a 3" filter will get it off without problem.
Posted on Nov 13, 2009
Testimonial: "Thanks forn the help! This info has been hard to find from other sources. Again thanks!"
First you have to take out the one and only screw in the rear hatch door - it's where the hand pull down is you use to close the hatch.
Then you have to pop all the plastic clips all the way around the plastic door panel, trying not to pull them out from the frame . If you do pull out the white plastic plugs from the frame you better make certain you take them off the plastic housing and insert them back into their frame holes - or you will never get the housing back on.
Once you have the housing loose disconnect the inside tail gate light wire to remove the whole thing. Then you have to remove 7 to 8 nuts from the back of entire License plate, back up bulb housing using a deep socket to get in there. Work it loose from the rear of the car and it will come out just enough to work on the lights.
This is tricky since the screw mounts don't give you much room to work with.
Once you have the license plate and back up bulb frame loose you will see the two housings for the license plate bulbs on top.
Slide out the license plate bulb lens and twist the bulb connection to remove the bulbs.
Replace both of them - you don't want to do this again in a month when the other one blows.
Once you take out the bulbs you might see that the housing is melted where the bulb wanted to burn through. Drill two small holes one is each end of the housing before I put everything back together to release some of the heat.
Reverse the whole process to put everything back together. It's not easy.
Make sure you insert the cables through the opening for the hatch handle or it will kink and not work properly.
The bulbs come in a two pack of cost $4.95 .
Posted on Nov 24, 2009
Tips for a great answer:
Mar 28, 2018 | Cars & Trucks
Sep 05, 2017 | Cadillac Cars & Trucks
Aug 10, 2017 | Cadillac Cars & Trucks
Jan 08, 2017 | 2010 Cadillac SRX
Dec 15, 2016 | 2010 Cadillac SRX
Jan 22, 2016 | 2010 Cadillac SRX
Feb 15, 2013 | Cars & Trucks
Jan 17, 2013 | 2010 Cadillac SRX
Dec 12, 2011 | 2005 Cadillac SRX
694 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: