Question about 2001 Nissan Sentra

Open Question

P0157 Nissan Sentra 2001 error code - 2001 Nissan Sentra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 705 Answers

SOURCE: 2001 Nissan Sentra Block Heater

You can't find one, because it doesn't have one.

Posted on Dec 17, 2008

cj2176
  • 520 Answers

SOURCE: Where is the blower resistor on a 2001 Nissan Sentra?

Its actually not that bad to change. If you open the glove box and remove the screws then the screws along the bottom of the glove box at the bottom of the dash the box will slide out. Remember to disconnect the light if it has one. Now you will be able to see the underside of the dash. You can see a large black box that has wires and vacuum lines all over. You need to locate a small flat plate with two screws and a plug in the middle. Disconnect the plug and remove the screws. The resistor will come straight out. The back side will look like small coiled up springs of different sizes. Install in reverse.Hope this helps. Good luck. Please re-post with updates. Thanks cj2176.

Posted on Jul 13, 2009

pal03246
  • 705 Answers

SOURCE: Nissan Sentra 2001 gxe with code p0420

You will need a new catalytic convertor assembly. Yours is below treshold efficiency in other words its "no good".If you have it replaced, ask the garage/dealer to give you the old one back. Its worth some cash if its full. It doesn't matter thet it failed. They are going after the mesh inside of it and that is worth some $$$$. May not be much , but better than nothing.

Posted on Jul 26, 2009

glamarre82
  • 140 Answers

SOURCE: Idle Air Control System

Replace the idle air control valve and see if you still get the same error code.

Posted on Jul 28, 2009

  • 67 Answers

SOURCE: 2001 nissan sentra xe p1320, p1140 codes car

Distributer Signal Output is code p1320........Intake Valve Timing Control Position Sensor Bank1 is code p1140...

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Nissan Sentra displaying an air bag code 20. This code is displayed on my genesis computer diagnostic machine. Any suggestions?


I suggest you take it to a dealer , a qualified tech should resolve this problem, DO NOT attempt to fix, if air bag is sending a code it could deploy and seriously injure you or your passenger. hopefully its an easy fix, but right now it could be dangerous !!!!!!

Feb 21, 2013 | 2001 Nissan Sentra

1 Answer

My 2001 nissan sentra se 2.0 idles up and down and i have a era code P0740


Trouble Code: P0740

A/T TCC Solenoid Circuit Malfunction

Possible Causes:


TCC solenoid control circuit open or shorted to groundTCC solenoid control circuit shorted to system power (B+)TCC solenoid is damaged or has failedPCM has failed

Jan 27, 2013 | 2001 Nissan Sentra

1 Answer

CODE P1320 ON 2001 NISSAN SENTRA


check engine light on means some fault codes stored in your engine control module.
use this tool clear the fault code p1320.

Jun 04, 2012 | 2001 Nissan Sentra

1 Answer

Getting code po133.po155,po161on 2001 nissan sentra . Please help


A code P0155 may mean that one or more of the following has happened:
  • O2 Heater element resistance is high
  • Internal short or open in the heater element
  • O2 heater circuit wiring high resistance
  • open or short to ground in the wiring harness

Mar 08, 2011 | 2001 Nissan Sentra

1 Answer

Had bad ignition coil replaced in Nissan Sentra 2001. Error code 300 and 335 were prevalent. After replacement had Camshaft Sensor replaced, still get error code 335. Thinking maybe one more ignition coil...


please have a test performed to confirm the integrity of your head gasket. this era of these cars were prone to failure, causing coolant to leak into the cylinder thus a misfire. it is typically most noticeable on a cold start, and can cause long cranking times, as well as a rough idle when first started. good luck!

Jul 07, 2010 | 2001 Nissan Sentra

2 Answers

2001 sentra no communication with scan tool


Take a few minutes to make sure you dont have a blown fuse....Run through them with your test light...

Nov 17, 2009 | 2001 Nissan Sentra

2 Answers

2001 nissan sentra xe p1320, p1140 codes car intermittenly looses power, when started in the morning while cold car runs fine until operating temp.


Distributer Signal Output is code p1320........Intake Valve Timing Control Position Sensor Bank1 is code p1140...

Oct 19, 2009 | 2000 Nissan Maxima

1 Answer

Idle Air Control System


Replace the idle air control valve and see if you still get the same error code.

Jul 27, 2009 | 2004 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Sentra Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...