Question about Chrysler Sebring

Open Question

Where chrysler sebring alternator fuse located on my 2004 car

No dash lights on when trying to start up

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
defadad
  • 351 Answers

SOURCE: where is the starter located on the 2004 chrysler

look around the bottom of the motor at the rear of the block on both sides. it should have a thick battery cable attached to it and a couple of smaller wires attached to it, one on the solenoid and one one the same terminal as the thick battery cable
hope this helps you

Posted on May 14, 2009

Ad
  • 1 Answer

SOURCE: Where is the crankshaft position sensor located?

the crankshaft position senor on the 2.2L is located on the rear right side of the engine block

Posted on Jul 07, 2009

  • 41 Answers

SOURCE: I can't locate the fuel filter on my 2004 chrysler

I would check if it is in the gas tank on that model. you can go to your local parts store and they should be able to inform you of this.

Posted on Jul 12, 2009

01fordeb
  • 1033 Answers

SOURCE: oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

Posted on Jan 03, 2010

sandman357
  • 236 Answers

SOURCE: 2004 chrysler sebring idle speed is too slow. HOw

why do you want your rpms higher while idling? you don't want them high because your gas bill will reflect that. slow shouldn't matter but if it's dying while on idle it could either be your mass air flow sensor or your fuel filter being clogged

Posted on Mar 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2001 chrysler sebring lxi 2.7 I try to start it It won't come on when i put the key to start lights radio come on but car won't start I hear a click noise when I try to turn it on


check fuses battery and connections---try boosting the car if starts have battery and alternator tested the battery sounds like it has enough power to turn on lights and dash but not enough to start vehicle

Sep 16, 2016 | 2001 Chrysler Sebring LXi

1 Answer

Where do I fine the tail light fuse box on 2010 Chrysler Sebring sedan


There is no separate fuse box for the tail lights. The fuse is located in the main fuse panel located under the dash on the drivers side of the car.

Apr 25, 2015 | 2010 Chrysler Sebring

1 Answer

Car won't start


When you turn the key to on, not start, the warning lights and gauges on the dash should all be on. If not, it may be a problem with the ignition switch. Check the maxi fuses under the hood if the switch is not getting power to it. If it is getting power, it could be a bad switch-the electrical portion, not the key cylinder.
If the security light is on, it may be an immobilizer fault-the security has immobilized the start circuit.

Jan 23, 2014 | 2004 Chrysler Sebring

1 Answer

Hi, I just changed my alternator in my 2004 Chrysler Sebring and now my electronic locks, interior lights and radio do not work. I notice that another person on this site was having the same issues...


Sounds as though you have blown a fuse check yourhandbook for fuse location and which fuse covers the three items replace any blown fuses with the same value ie:15 amp with 15 amp 20with 20 and so on

Dec 16, 2017 | 2004 Chrysler Sebring

1 Answer

I have a 2004 sebring that i bought new. the instrument cluster lights dont work, i checked interior fuses number 7 and 11 that relate to the instrument cluster illumination. they seem to be fine.


If the fuses are good there should be a dial that adjusts the brightness of the dash panel.If this dial doesn't work then the bulbs for the dash panel might be blown out.

Mar 13, 2011 | 2004 Chrysler Sebring

1 Answer

2002 chrysler sebring 2.7 v6 elictrical problem???


Sounds like a charging system issue. Just because the alternator itself tested fine doesn't mean it's getting power to the car and battery. Charge the battery and start the car (with everything connected normally, including alternator). While car is idling, disconnect the battery (negative post wI'll do). If car dies, there's a problem with the alternator wiring/harness. Once the vehicle is running, the alternator should provide plenty of power. Check voltage at battery (from alternator) and should be around 14V. Check alternator fuse.
Could be the voltage regulator in the alternator going out, which would need a new alternator.

May 01, 2017 | 2002 Chrysler Sebring

1 Answer

I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING


me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...

May 30, 2009 | 2004 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...