Question about 1999 Nissan Altima

Open Question

WHERE IS TRUNK LIGHT LOCATED IN 1999 NISSAN ALTIMA GXE

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 275 Answers

SOURCE: 2002 Nissan sentra GXE trunk won't lock

when you pulled the trunk down on the firnature it could have set the latch without it being shut look inside where the latch is put your key in the trunk lock and turn it, using you finger or somethin smaller you should be able to pull the latch back out and the trunk should close

Posted on Nov 12, 2008

Ad
  • 1 Answer

SOURCE: 1999 nissan sentra gxe headlight problem

do you have the right light bulb? i own a 98 sentre and
it takes a 9004 bulb, but walmarts computer said to use 9007. That made the high beam censor stay on till i replaced it. if you look at the bulb you can tell if it is a dual or single beam bulb.!!!!

Posted on Mar 17, 2009

  • 1 Answer

SOURCE: 1999 nissan sentra gxe headlight problem

I switched one of the new bulbs with a working older bulb, and the problem went away. weird...

Posted on Apr 24, 2009

  • 77 Answers

SOURCE: after it rains water is in trunk Nissan Altima

When diagnosing a water leak, here's a handy tip. Check the accumulated water. If the water is dirty, look for leaks from the underside of the vehicle (floor, wheelwells, etc). If the accumulated water is clean, look for leaks from the topside of the vehicle (trunk seal, window seal, etc). To find where the water is coming from, shut yourself in the trunk with a flashlight and have an assistant run water over the trunk with a garden hose. You may have to remove some of the interior trunk trim to see exactly were the water is coming from, but chances are you'll find it. Also another common cause of water leaks are from impact damage, so check for collision damage repair. while your in there. -hope this helps.

Posted on Jan 28, 2010

ZJLimited
  • 17970 Answers

SOURCE: How do you remove a 1999 Nissan Altima starter?

Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation

  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse located in a 2007 Nissan Altima to unlock the trunk


2008 Altima2.5S Trunk wont open GRRRRRR - Nissan Forums : Nissan Forum

www.nissanclub.com/.../2007...nissan-altima.../298533-2008-altima2-5s-...
Dec 26, 2009 - 6 posts - ‎6 authors My trunk wont open from any of the buttons...the remote wont open it , the dash switch wont open it nor will the. ... Is there a fuse blown? ... 2007 Nissan Altima 3.5 SE CVT: 14.540 @ 96.530 MPH <----click here! ... When the cancel switch locatedinside the glove box is OFF, the trunk lid cannot be opened ... Trunk doesn't open
7 posts
Oct 17, 2012
How to disable trunk release in 2009 2.5S Altima?
15 posts
Jun 26, 2011
broken trunk release??
10 posts
Feb 24, 2009
Dead battery = Screwed !
15 posts
Aug 18, 2008
More results from www.nissanclub.com

Nov 03, 2015 | Nissan Cars & Trucks

1 Answer

Where is the fuel sensor and fuel pump located at on a 1999 Nissan Sentra GXE and how do I get to them


In the gas tank look in trunk under carpet some have an access lid so you can replace without removing tank.

Jul 18, 2014 | Cars & Trucks

1 Answer

How do I change the dash light bulb for 1999 Nissan Altima GXE?


You will have to remove the cluster. Remove the trim around the dash in front of the cluster, remove the bolts holding the cluster in, then you can access the rear to replace the burnt out bulb.

Jun 18, 2013 | Nissan Altima Cars & Trucks

1 Answer

Need wiring diagram for Nissan Altima GXE starting system


I am sorry but fixya has no wiring diagrams of any kind. You can obtain the factory diagrams for a small fee at this site www.alldatadiy.com

Jun 28, 2012 | 1999 Nissan Altima

1 Answer

2001 Nissan Altima GXE turn signals comes on then goes off.


possibly the wires are loose or shot mayb try and replacing them

Apr 26, 2010 | 2001 Nissan Altima

1 Answer

Where would I find sevice information for a 1999 Nissan Altima


google nissan altima resistance info you should be able to get more info than youll ever need.

Mar 27, 2010 | 2001 Nissan Altima

1 Answer

MOSTRAR MANUAL DEL AUTO NISSAN ALTIMA GXE AÑO


Visita autozone.com (registro gratuito), selecciona año, marca, modelo y motor para acceso gratis a la informacion deseada.

Suerte.

Feb 09, 2010 | 1994 Nissan Altima

1 Answer

1998 Altima GXE has a code of P1491. It was


Code P1491 is not the PVC Valve.It is the Vacuum Cut Valve Bypass Valve.
Which is located above and away from the egr canister under the driver side rear bumper it is round and have about 3 hoses connected to it. if it is from a check engine light that says look at vacume cut valve check the egr canisters purge valve some times they stick and throw the wrong code

Sep 01, 2009 | 1998 Nissan Altima

1 Answer

Tune-up


That all depends on the mileage, first tune is 100,000 miles, the very least you will need is spark plugs, fuel filter and air filter, use factory spark plugs, many brands available but the factory plugs work best.

Aug 05, 2008 | 1999 Nissan Altima

Not finding what you are looking for?
1999 Nissan Altima Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...