Question about 2000 Dodge Grand Caravan
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is on the firewall under the hood. It has 3 to 4 bolts holding on. Be careful when taking it out to see how the new one lines back up. Hope it helps.
Posted on Mar 30, 2009
SOURCE: I have a 1992 dodge shadow.but the windshield wipers isn't working.I checked the motor is well,the terminal voltage is 12V,how can I continu to repair the 1992 dodge shadow's windshield wipers?
You posting is slightly confusing but I gather your windshield wipers stopped working.
The repair method is as follows;
) Check the fuse.
) Check the wiper motor. Turn the wipers on and listen for the hum of the motor.
If you hear the hum then the linkage has probably come loose. You will have to take the covers off
to get to the linkage for the wiper. You can either repair the parts, get salvage yard parts or replace with new part$.
If you do not hear the motor hum then you should verify electricity is getting to the motor. A simple
voltmeter can be used. If the motor is bad you can replace it. Call some auto supply stores for after-market motors or call salvage yards for parts.
Posted on May 07, 2009
It's the body control module. I had the same thing happen with my caravan. It eventually evolved into the following problems no interior lights or chimes, no remote mirrors, dash lights and instrumentation goes out and ABS light comes on, no lighted vanity mirrors, blinking recirc & a/c buttons, no high beams. THe dealer said a BCM would be $700.00 with exchange otherwise w/o exchange 1200. I found one online - ebay. BE CAREFUl...if you don't have security on your vehicle DO NOT buy a unit that has the security feature..your vehicle will not run if you install this. match the part number off of your unit but also match the features.
Posted on Sep 06, 2009
There are no adjustments on the wipers. The arms come off to realign. Pop the wiper arm cap off with a very small flathead screwdriver theres a liitle opening slot to do this. Remove the nut. Pull wiper off straight, use pulley if needed. If the tenson is gone in the wiper arm replace. The springs go bad in the rear arm from dirt.
Posted on Jan 19, 2010
Probably is the Body Control Module if you have checked the fuses in the fuse box and none are blown and you have verified power is coming to the wiper and signal switch. One simple fix you can try with the battery disconnected it to unplug and then replug the wriring harness to the BCM that fixed a Chrysler T&C that had the same problem. I also include what someone else gave as advice.
The body control module is located under the dash, directly behind the junction block that contains all the fuses/relays/plugs. The way you could verify that the wiring up to the bcm (from the wiper control) is working, before you go to the expense of replacing it, would be to locate the black plug on the bottom of the bcm (if you look under the junction block/bcm assembly you should see a gray connector and a black connector protruding from the underside of the bcm) and pull that plug, which is the one closer to the cowl. I believe you will find a dark green/yellow wire on pin #7 (from the wiper control) of the plug and a black/light green wire on pin #10 (ground). You may probe those wires with straight pins inserted thru the insulation so as to contact the internal conductor, then replace the plug (but make sure the straight pins don' touch oneanother), turn on the ignition switch to 'run', and measure the voltage between the two pins, you should find that the voltage will change proportionately as you cycle the wiper control through the six different positions of intermittancy. If not, then there is something the matter with the wiper control or its wiring. If the voltage is changing proportionately, then the manual does say to replace the bcm as the solution for that problem.
Posted on May 25, 2010
Tips for a great answer:
Oct 14, 2016 | Dodge Cars & Trucks
Sep 09, 2011 | 1998 Dodge Grand Caravan
Sep 09, 2011 | 1998 Dodge Grand Caravan
Dec 02, 2009 | 2005 Dodge Caravan
Mar 28, 2009 | 2000 Dodge Caravan
Feb 07, 2009 | 2000 Dodge Caravan
Jan 25, 2009 | 2000 Jeep Grand Cherokee
Jan 20, 2009 | 1998 Dodge Grand Caravan
Dec 25, 2008 | 2001 Jeep Grand Cherokee
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: