Question about 2006 Mercury Mariner
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
Posted on Feb 22, 2009
You Will Need A 13-14 mm Wrench for Caliper Bolts .A Large Flathead Screwdriver to Spred open Caliper/Shoes to Remove Caliper from Rotor,
After rhis you Can use a LARGE "C" Clamp to CLOSE Caliper Piston.
Posted on Nov 06, 2009
I have a 2006 Ford Explorer and I just found my keyless entry module. The module was behind the lower plastic panel on the passenger side rear panel right below the seat belt height adjuster. Not the panel with the seatbelt adjuster but the one below it. No tools were needed and it took me all of 5 minutes. Just pop off the front of the panel closest to the door and pull it back. Use a light and you can see the large 5 digit code on top of the module. Thanks very much to the people that contribute to this forum....Cheers
This is really where it is!
Posted on Nov 12, 2009
there are two types of displays heres both.hope this helps.for base instrument cluster.
1) press and release trip/reset button until setup menu hold reset displayed
2)press & hold trip/reset untilreset for sys check or sys check hold reset is displayed
3)release trip/reset button
4)press and release trip to scroll until hold reset if new oil is displayed
5)press and hold resetuntil oil life set to 100% and let button go you are done.
if you have a message center dash display then do this one. 1)push and release setup button until you see press reset to begin (2)press& release reset button until hold resetif new oil is displayed.(3)press and hold reset for 2secondsuntiloil set to 100%. done. hope this helps.
Posted on Jan 27, 2010
Open the liftgate and remove the 2 screws holding the lamp. Now grab the lamp and pull straight back to dislodge the spring clips. Then twist the sockets to remove the bulbs.
Posted on Mar 17, 2010
Tips for a great answer:
Oct 10, 2013 | 2008 Mercury Mariner
Jul 15, 2012 | 2006 Mercury Mariner
Sep 13, 2011 | Mercury Mariner Cars & Trucks
Feb 05, 2011 | 2006 Mercury Mariner
Jan 08, 2011 | 2006 Mercury Mariner
Jan 01, 2011 | 2006 Mercury Mariner
Mar 15, 2010 | 2006 Mercury Mariner
Jun 06, 2009 | 2006 Mercury Mariner
32 people viewed this question
Usually answered in minutes!