Question about 2005 Volkswagen Sharan 1.9

Open Question

2004 vw jetta 1.8t reset brake pad light - 2005 Volkswagen Sharan 1.9

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ewashmidas
  • 362 Answers

SOURCE: I replaced the front pads on a VW JETTA 2.5 and

As the brake pads wear, the brake pad wear sensor contained in the brake pad contacts the brake rotor. This causes the sensor to fail. When a pad wear sensor fails it opens the ground circuit of the pad wear warning light system causing the pad wear warning light to illuminate. Perform normal brake service to correct this condition and be sure to replace the brake pads with pads containing wear sensors. Once the brake pads and wear sensors are replaced, reset the brake pad warning system by turning the ignition switch to the "on" position. As long as continuity to ground exists through all the brake pad wear sensors the system should reset and the pad warning light in the dash will go out. If the pad warning light does not go out, a check of the pad warning circuit for an open circuit condition or poor ground must be performed.

Posted on Mar 03, 2009

Ad
  • 11 Answers

SOURCE: 2006 vw jetta tdi service engine light reset

With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.

Posted on May 30, 2009

  • 51 Answers

SOURCE: 2004 VW Jetta engine compartment fuze box location

one is located over the battery, the other is located in the side of the dash.

First panel:
If you pop your hood the battery will be on your right sid in the front of the engine bay. There is a small rectangular piece on top of the battery with a lot of heavy guage red wires going to it. That is the engine bay fuse box.

Second panel:
if you open your driver side car door it's under neath a panel located inbetween the door and the dash board.

Posted on Jun 03, 2009

pippall
  • 1486 Answers

SOURCE: reset computer on 2004 Touareg

Drive the car at about 10 mph then if there is no fault the light will go out.Failing that remove the baterry wires and leave off for an hout then replace.That should cllear the code.Make sure you have the radio code before you disconect the baterry.Hope that was helpfull.Good luck.

Posted on Jul 28, 2009

BRADLEYFRANC
  • 104 Answers

SOURCE: 2000 VW Jetta E-Brake Light indicator beeps when brake is off

check the brake fluid level in resevoir,cuold be low,or emergencybrake light switch could be faulty.

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a brake light switch from a 2004 polo 1.9tdi


While this is for a VW Jetta I'm guessing it's much the same for the Pollo. Don't be put off by the little girl. 1999 to 2005 VW Jetta Brake Light Switch Replacement by Howstuffinmycarwork...

Nov 08, 2014 | 2005 Volkswagen Polo 1.9

2 Answers

2004 Jetta 1.8T - doing brakes and hear there is a concern about a sensor and wire for the ABS. Is there any concerns or is it just a pigtail connection to disconnect and then work on the...


The ABS wire is well away from your brake caliper. If your vehicle has brake pad warning wires, these may need to be replaced with the pads. They sometimes come with the pad set. Hope this helps...

Mar 04, 2011 | 2004 Volkswagen Jetta

1 Answer

On my 2004 Jetta 1,8T the brakes are starting to get hard. Taking s little more pressure on the brake pedal to stop the car. What could be causing this??? Thanks


The most likely cause is loss of power assistance to the braking system which means you will need to apply increased brake pressure to compensate for the loss of assistance.

The problem will be with the brake servo assist. It is possible there is a leak in the brake servo assist system, which reduces the vacuum, so you are not getting sufficient mechanical assistance when applying the brakes.

It is unwise to be driving the car with this condition. If you lose all power assistance to the brakes, which could easily occur with this fault, the pedal will become very hard, you will need to apply very high pedal pressure and the vehicle will be very difficult to stop. You need to take the car to a VW dealer for service or to a competent brake specialist in your area to inspect the system and rectify the fault.

VW did a recall on some earlier year models for a leaking brake servo and I understand the problem was a faulty vacuum hose which would fail and leak. I am not aware of any recall for this item on later models like your 2004 vehicle.

All the best.

Dec 03, 2010 | 1997 Volkswagen Jetta

2 Answers

My vw jetta vr6 1999 theabs light still on.the break pad and rottor was new.


abs light is on because there is a fault recorded in the abs system. a scan tool will be needed to get the recorded fault from the on board computor. It has nothing to do with the brake pads. It is usually an electrical problem.

Nov 13, 2010 | 1999 Volkswagen New Jetta

1 Answer

I have a 2004 vw jetta, replaced the front and rear brakes and now, I have no brakes at all. Could you help.


This sounds like a fluid issue. Be replacing brakes, do you mean the pads, or the slave units (calipers)? you will need to bleed the brakes.

May 30, 2010 | 1997 Volkswagen Jetta

1 Answer

2004 Jetta: How do i change the front disc brakes?...


i changed 04 vw jeta rotors and pads now i dont have break pressure

May 17, 2010 | 2004 Volkswagen Jetta

1 Answer

Grenn light in the center of the tach, looks like


Light is an automatic shift lock indicator.

Jan 14, 2010 | 2004 Volkswagen Jetta

1 Answer

2004 VW Jetta-no brake lights.


Hope this helps....please don't forget to rate:

2a6c24a.gif

Too small to read....not a big deal. I looked for it too and can't find where it says for brakes but try the #11 fuse/relay.

Jul 29, 2009 | 2004 Volkswagen Jetta

2 Answers

I replaced the front pads on a VW JETTA 2.5 and the check pads light is on. How can I reset the check pads light?


As the brake pads wear, the brake pad wear sensor contained in the brake pad contacts the brake rotor. This causes the sensor to fail. When a pad wear sensor fails it opens the ground circuit of the pad wear warning light system causing the pad wear warning light to illuminate. Perform normal brake service to correct this condition and be sure to replace the brake pads with pads containing wear sensors. Once the brake pads and wear sensors are replaced, reset the brake pad warning system by turning the ignition switch to the "on" position. As long as continuity to ground exists through all the brake pad wear sensors the system should reset and the pad warning light in the dash will go out. If the pad warning light does not go out, a check of the pad warning circuit for an open circuit condition or poor ground must be performed.

Mar 03, 2009 | 2005 Volkswagen Jetta

Not finding what you are looking for?
2005 Volkswagen Sharan 1.9 Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...