Question about Isuzu Pickup

Open Question

Have a problem with the central locking system on my isuzu kb280dt lx 2001 model the alarm system activates but the buttons will not lock and unlock .also when driving the buttons will not lock and when swiching off the ignition and removing the key the doors will not unlock.thanking you in advance for your kind assistance

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Central Locking to Ford Focus LX 2001

Problem with 2001 1.6 Focus which i was going to purchase for the wife, but problem with central locking! key fob totally dead even when i tried the reprogramming trick (key in ignition press button several times) and when locking/unlocking manually, central locking only working intermittently! Please help regards steve

Posted on May 30, 2009

  • 412 Answers

SOURCE: 2005 Chrysler Grand Voyager. Central locking

the body control module may need a software update..check with your local dealer

Posted on Jun 12, 2009

  • 3 Answers

SOURCE: 1999 Audi A3 1.8T Electric Windows and Central Locking Won't work

will your passenger door open with the key and is it just one side that your windows are not working or both. if its just one side it might be your regulator motor in the door thats not working if its both it might be your central locking pump usually in the boot. however if both of them are working fine it could be that your key needs reprogrammed however i think the 1st 2 are more likely to be the problem.

Posted on Jun 30, 2009

  • 149 Answers

SOURCE: land rover discovery central locking.

No, likely to be caused by the actuators in the lock mechanism failing usually causing the door to remain locked. The boor door can also fail this way, as do the front side doors. Replacement requires the whole lock unit to be replaced at a cost of roughly £60 a lock, and a hours work. Helps if you have small hands. Requires a full strip down of the door and you will need the lock unit, trim clips (a few quid) and a trim removal tool (tenner). You can bodge with a flat head screwdriver, but the tool does help prevent damage to the clips & trim panel.

Posted on Feb 22, 2010

  • 7 Answers

SOURCE: program ignition key to central locking on porsche 996 1998

Well, you can sometime catch the code again. Pt the key in the ignition and turn till the dash light come on (dont Start) then press and the Lock button while keeping the Lock button Pressed and turn the dash light off and put the key with the lock button Press for 10 second afterwards. If not successful first time try again. This should do it.

Posted on Feb 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just bought a x reg ford puma but the key fob does not work, bought a new battery and fitted it, needs re-programming but don't know how to do it.


Telephone: Fax: VAT Registration No.:
Infrared remote control
NOTE: Infrared emitter can be seen at front edge of key.
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system.
Programming
When
Key batteries completely discharged. Key batteries not replaced within 15 seconds. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Turn ignition switch to position I. Wait approximately 10 seconds. Ensure clock LED illuminates.
NOTE: LED illuminates for approximately 5 seconds.
Switch ignition OFF and remove key, while LED illuminated. Programming mode activated for approximately 20 seconds (LED illuminated). Proceed as follows: Point key at receiver (located near interior lamp). Press and hold unlock button Fig. 1 [1]. After approximately 1 second key LED will flash once [3]. Press lock button 3 times Fig. 1 [2]. Release unlock button Fig. 1 [1]. Continue to point key at receiver until LEDs in clock and key have flashed 5 times. Ensure LED remains illuminated. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode and extinguish clock LED: Switch ignition ON and OFF. Wait approximately 20 seconds.
NOTE: A maximum of 4 keys can be programmed. Fig. 1
Radio frequency remote control
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds.


Pressing tailgate release button twice within 3 seconds unlocks the tailgate - if fitted. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system. Interior lamp illuminates when disarming system.
Programming
When
Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Fasten seat belts and close all doors. From position I, turn ignition switch as follows: To position II. To position I. To position II. To position I. To position II. To position I. Programming mode activated for approximately 20 seconds. LED or fog lamps ON warning lamp illuminates (some models) or the system will emit an acoustic signal to indicate start of programming mode. Proceed as follows: Type 1: Press and hold unlock button Fig. 1 [1]. Type 2: Press unlock button Fig. 2 [2]. Ensure clock LED or fog lamps ON warning lamp flashes (some models) or wait for acoustic signal (indicates correct programming). Wait 2 seconds. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode: Switch ignition ON. Wait 20 seconds.
NOTE: A maximum of 4 keys can be programmed.

Aug 25, 2010 | Ford Focus Cars & Trucks

1 Answer

How do I program a new OEM key for my 2001 Daewoo Leganza so it locks and unlocks the doors?


hi this is how you do it
first off make sure the alarm system is off then put the key to be programed into the ignition turn ignition on then off within 5 seconds this is then in program mode press the lock or unlock button 3 times within 20 seconds and then the central locking should start working indicating the remote is now programed...hope this helps please vote thanks

May 22, 2010 | 2001 Daewoo Leganza

1 Answer

I have just charged the battery on my 1996 r reg audi a4 now central locking has disabled as has alarm system! any ideas


unlock the car with the key/hold over for 30 secs.
lock the car with the key/hold over 30 secs.
then press/hold down unlock button on remote.
you have just reset your alarm/central locking system
change remote batteries every 2 years...... both remotes....

May 08, 2010 | 1997 Audi A4

2 Answers

2002 bmw 530i key does not (remotely) unlock doors or trunk but they work fine manually.


Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button. Press lock button briefly 3 times within 10 seconds keeping unlock button depressed. Release unlock button. Some models: LED flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously.

Mar 09, 2010 | 2002 BMW 5 Series

1 Answer

Toyota avensis 1998 cdx key fob can't activate immobiliser


Not a solution just another problem...Lost my car fob key, have a replacement key no circuit. As I open door, sets off immobiliser like above for20 mins. I had someone look under the glove compartment but that got me no joy. How can I (non techy) resolve this so I can drive my baby home...Vreg Avensis1.8 model?
many thanks

Aug 31, 2009 | 1998 Toyota Avalon

1 Answer

Car alarm not activating central locking


It means that the remote is not passing the signal to the car . The alarm has triggered because the system has detected an illegal entry. Replace the remote batteries

Sep 10, 2008 | 2006 Mitsubishi Colt

2 Answers

Central Locking to Ford Focus LX 2001


Hi, sounds like a lose rod inside the door,you need to remove the door panel to check it,....

Aug 28, 2008 | 2001 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...