Question about 2006 Jeep Commander

1 Answer

My 2006 Jeep Commander Rear passneger window rolls up but wont roll down

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

It means that your window switch is bad and it is not making contact to roll it down or it is so corroded that the electricity can't travel through the pin to the window motor for going down

Posted on Jan 16, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

greg_margo
  • 1959 Answers

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

  1. Raise and safely support the vehicle.
  2. Remove the rear wheel.
  3. Siphon a small amount of brake fluid from the master cylinder reservoir.
  4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
  5. Remove the caliper slide bolts.
  6. Remove the caliper from the anchor.

    WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
  7. Remove the brake pads from the caliper.
To install:
  1. Install the brake pads onto the caliper.
  2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
  3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
  4. Install the rear wheel.
  5. Lower the vehicle.
  6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
  7. Refill the brake fluid reservoir to the proper level.

Posted on May 17, 2009

twistedfreak
  • 1 Answer

SOURCE: 1994 jeep grand cherokee power window problem

try replacing the master switch it maybe malfunctioning due to wear.or may have shorted out by getting wet or something.since it is the primary control for all windows and power door locks.

Posted on Dec 22, 2008

  • 90 Answers

SOURCE: Jeep Grand Cherokee rear window won't roll up

new window regulator is real solution

Posted on Jun 05, 2009

  • 1 Answer

SOURCE: right window will not roll down..

I have had to fix three out of four windows in the past month.of my 2004 jeep grand cherokee. I went from a semi cold environment to a really hot environment. I was told by Jeep, after the third time of course, that the wires had more play in the hot environment and had shorted out because jeep did not put correct housing over the wires next to the door. If you have the same problem put electrical tape around your working electric windows so it does not happen to your good windows.

Posted on Jul 24, 2009

  • 1 Answer

SOURCE: the passenger rear window won't roll up or down

I have the exact same problem on a Jeep Grand Cherokee 2004. The rear passenger window rolls down only from the rear passenger window and won't go up or down from the front. It has to be in the wiring because the problem was intermittent initially and a new window motor does the exact same thing. If you figured it out or have the wiring diagram please let me know.

Posted on Sep 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 jeep commander the back right window won't roll up or down with the drivers door switch and won't go up with the passenger switch but will go down


car drives perfectly, as do all other electrics?
fuses good
scan it is next.
can fix 2005+ GC lacking tools, like this.
the book is free.
wk
read that yet?
RTM ,.read first how it works,,, its not like you think,,,?

http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Feb 13, 2017 | 2006 Jeep Commander

1 Answer

My back window wont roll up at all


if there is a pause from when the motor starts to when the window moves it is a worn or faulty window regulator, the motor not starting when you press the up on the switch could be a bad switch, if you have a meter check for voltage at the switch when you press up.

Oct 11, 2012 | 2006 Pontiac Grand Prix

1 Answer

The rear driver window will roll down but not up


My 2005 dodge stratus drivers window did the same thing. I had to replace the window regulator, fairly expensive at dealer so I got one through a local salvage yard

Aug 18, 2010 | 2006 Jeep Grand Cherokee

1 Answer

2004 JGC driver window wont go up or down


just renew the mechanism the cable has broke and it comes in one unit

Jul 22, 2010 | 2004 Jeep Grand Cherokee

2 Answers

The passenger rear window won't roll up or down from the drivers controle it clicks in the passenger front door. it will roll down in the passenger rear door but not up. the window modulator rolls up and...


I have the exact same problem on a Jeep Grand Cherokee 2004. The rear passenger window rolls down only from the rear passenger window and won't go up or down from the front. It has to be in the wiring because the problem was intermittent initially and a new window motor does the exact same thing. If you figured it out or have the wiring diagram please let me know.

Apr 22, 2010 | 2004 Jeep Grand Cherokee

2 Answers

1994 jeep grand cherokee power window problem


most of the time it is wires in the drivers door that break in the loom

Feb 20, 2009 | 1994 Jeep Cherokee

1 Answer

1994 jeep grand cherokee power window problem


try replacing the master switch it maybe malfunctioning due to wear.or may have shorted out by getting wet or something.since it is the primary control for all windows and power door locks.

Dec 05, 2008 | 1994 Jeep Cherokee

Not finding what you are looking for?
2006 Jeep Commander Logo

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...