Question about Ford Aerostar

2 Answers

95 aerostar van the heater motor sometimes does not work at all. Is there a resistor for these? or do I just change the blower motor out? and where is the blower motor located?

Posted by on

  • yadayada
    yadayada May 11, 2010

    this would be the blower motor not the speed dropping resistor.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

The motor is on the passenger side firewall and is held in by 3 screws.you have to unplug the motor pull the screws and put the new motor in the same way

Posted on Jan 24, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,114 Answers

It is in the heater box!!! passenger side?

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

We have a 1990 Ford aerostar minivan and the blower motor isn't working. I don't know where the resistor is or where the blower motor is located. Anyone know?


Blower motor is in dashboard. Problem could be with motor windings, bearings, fuse, relay, and switch. Check them all out.

Nov 13, 2015 | Ford Cars & Trucks

1 Answer

Heater blower faulty and unrepairable. What other nissan uses same blower heater?


IS IT THE BLOWER MOTOR OR THE CLIMATE CONTROL UNIT ..ALSO THERE IS A IN LINE BLOWER MOTOR RESISTOR THAT BOLTS IN TO THE LOWER DUCTS WHEN THOSE GOT OUT IT CAN ALSO CAUSE THE BLOWER MOTOR NOT TO WORK....HOWEVER IF ITS THE BLOWER MOTOR ANY FROM 95-99 NISSAN MAXIMA WILL WORK ALSO I THINK THE 95-99 NISSAN QUEST WILL WORK..CLIMATE CONTROL WILL WORK FROM OTHER MAXI'S AS LONG AS IT'S THE SAME TYPE(ELECTRONIC OR DIAL TYPE)

Dec 25, 2010 | 1995 Nissan Maxima

1 Answer

Fuse diagram for a 98' E-150 van specifically for heater fan


owner manual will tell you fuse layout. If you have only high speed, you have a bad resister. 4 wires.

Resistor —Heater Blower Motor Switch Removal
  1. Remove the battery (10655) ; refer to Section 414-01 .
  1. Remove the battery tray.
    1. Remove the screws.
    1. Remove the battery tray.
  1. Disconnect the heater blower motor switch resistor connector.
  1. Remove the heater blower motor switch resistor (18591).
    1. Remove the two screws.
    1. Remove the heater blower motor switch resistor.
---------------------------------

0f120f5.gif

Feb 26, 2010 | 1998 Ford Econoline

3 Answers

Blower only works on high


your resistor is faulty. replace it.it is located right on your blower motor which is on the front passenger side under your dash.You cant miss it.

Feb 06, 2010 | 1993 Ford Econoline

1 Answer

1996 town & country van front heater blower


you will need to start by checking fuse,then power to motor,then blower motor resistor

Jan 29, 2010 | 2005 Chrysler Town & Country

1 Answer

Heater not working on setting 3


The blower motor resistor is bad, when you have the fan on high the fan motor (or blower motor) gets full voltage. When you have the switch on any other setting it gets reduced voltage via the "Blower Motor Resistor". That part is usually fairly close to fan motor in the duct work and is held in place with a couple screws and has a plug in going to with several wires. Sometimes that plug in gets melted to the resistor and the plug (or pig tail) has to be replaced too. This should be a fairly simple fix depending on the location of the resistor. The parts should be less than $100.00

Dec 26, 2009 | 2001 Ford Escort ZX2

1 Answer

How to fix 1999 lincoln TC heater/AC fan speed. Speed is intermittent or not blowing at all. Fan sometimes blows at full speed then may start to turn on and off. Sometimes it does not blow at all.


You have a problem with the resistors on your blower motor. 95% of AC/Heater blower motors are located under the glove box in the passanger foot well. When you remove the motor you should see a resistor plate. Resistors are not servicable and will need to be replaced. This is a relatively cheap part, that you can replace yourself if your handy, if not take it to your local tech.

Nov 13, 2009 | 1999 Lincoln Town Car

2 Answers

Blower doesnt work on 1990 ford van e-150. I


most likely the blower motor! but could be the blower motor resistor! does it work on high setting? if so it is the blower resistor if not most likely the blower itself!

Sep 18, 2009 | 1990 Ford F150

2 Answers

1998 Astro Van Heater AC Blower only works on medium & Low


Yes, in high it bypasses the resistor and uses a high blower relay. But I think on 1998 Astro the High relay and the resistor are built together. It should be mounted in the blower box real close to the blower motor.

Mar 09, 2009 | 1998 Chevrolet Astro

1 Answer

94 gms safari van heater blower not working


This van has a resistor under hood for the blower motor and is the blower motor getting power to it

Jan 17, 2009 | 1989 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...