Question about Cars & Trucks

Open Question

Es62 everspring sensor light stays on al the time started after power was out briefly

After power outage the motion sensor light remained on all the time day and night

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: airbag light remains on all the time and beeping...

Sticky relay perhaps, but regardless, have it checked, you really don't want that going off for no reason, and you do want it working properly in case of accident. At least have it properly diagnosed & decide from there.

Posted on Dec 12, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Honda CRV 2005. Tail light remain on when I switch off engine


the brake lights and rear lights will be on different circuits, the left and right sides should also be on different circuits. They should not stay on, and certainly not al together simultaneously. You need the services of a proficient auto electrician, not a mechanic though.
Good Luck

May 28, 2015 | 2005 Honda CR-V

1 Answer

Motion sensor light


Some lights have the ability to be controlled on manual or automatic depending on the number of times that the switch for the light is switched on and off.You may need to kill the power then allow it to go thru its warm up routine again(When it tests itself prior to operation.when initially powered up)Sometimes tripping the breaker and then turning back the power on can remedy the problem.

If the light is controlled by a photocell(a device that stops it switching on until its dark) then it could be that which is faulty as they tend to stay powered up when they fail so people can still see in the dark.

Jan 18, 2012 | Cars & Trucks

1 Answer

My volvo s80 check eng, light is on and the code is p0011 and (cam shaft postion sensor) the the abs and all other lights keep going on and off every time i start the car i need some help please help


Hi there,

Firstly, when starting the car, ALL warning lights should illuminate briefly - this is a self test to ensure these systems are working ok. When the Engine Check light remains illuminated, then a fault has been detected.

Code P0011 can be triggered by the following issues: Improper camshaft timing, wiring problems, continuous oil flow to the VCT piston chamber, faulty timing valve solenoid.

Due to the possible causes above, only an authorised Volvo service agent will have the correct scanning/diagnostic tool to identify where the problem lies.

I recommend you have the service agent carry out a further diagnostic...



Regards,


Aug 28, 2011 | 1999 Volvo S80

1 Answer

95 jimmy will start briefly if brake cleaner sprayed into sensor in middle of the engine block, but will not stay started and does not seem to be betting power in that area. Which sensor is that? we have...


If you have an engine light on, i suggest you hook up a scanner. If not, try the MAF. Mass air flow. That's exactly what they do when it is faulty. I would suggest going to an auto wrecker and getting one, just in case that isn't the problem. It's the sensor in the tube that runs from the air filter to the intake.

Aug 19, 2011 | 1995 GMC Jimmy

1 Answer

1990 Regal Coupe 3.1 engine. Low Coolant Light Stays Lit


This is a COMMON Problem that GM had with the Level Sensor Curciut, And they Never Correctly Addressed it. I Have on ocations Replaced the Sensor and that Corrected the Problem, BUT Other times the Light STAYS ON No matter What, I have tracked the Wires and all I Have Ever Found was the Plug Being FAULTY. So if A NEW Coolant LEVEL SENSOR Does NOT Turn off the Light, try Replacing the PLUG Itself.

Aug 26, 2009 | 1999 Buick Regal

1 Answer

Air Bag light stays on after engine starts.


Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

Jan 28, 2009 | 2004 Volkswagen New Beetle Convertible

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...