Question about 2006 Lincoln Mark LT

1 Answer

HOW MUCH OIL DO I PUT IN AFTER A CHANGE - 2006 Lincoln Mark LT

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 373 Answers

Oil change and filter will require 4 liters of oil . Then check the oil level . Hope this helps you

Posted on Jan 16, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Walmart changed oil and filter-but did not put in the right amount of oil-how much oil is needed


Always, always check the oil level after these places change your oil.!!!
Usually 4 Qts. or 5 with filter change.

Mar 25, 2014 | 1991 Toyota Camry

2 Answers

It is ok if we put sae 10W- 40 oil for honda oddysey 2004


u should always put in what the car calls for.

Jan 17, 2011 | 2004 Honda Odyssey

3 Answers

Do I need a mechnic for changing oil in my chevi


No. The oil is very easy to change. All you need is a filter wrench and a 15 mm. socket, and a drain pan. Get under the truck and the oil filter is right there and the drain plug is in the oil pan. Drain the oil first, then remove the oil filter with the filter wrench. Take your finger and dip it in the oil and put a film of oil on the new oil filter gasket. Then install the new oil filter. Once you install the new oil filter, put the drain plug back in. Then put 5 quarts of new oil in the oil fill.

Jan 11, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

How minny quarts of oil dose a 96 olds aurora hold


A typical automobile holds 4-5 quarts of oil.....Depends on the size of motor. If changing yourself, Drain out all oil, change filter, put oil plug back in. Put 3- 31/2 quarts back into car. put oil cap on and start car. Let run for 2-3 minutes then shut back off. Wait for a few. Pull out dipstick wipe, put back in then pull out a second time...Now you know how much you need to top off level.

Sep 21, 2010 | 1996 Oldsmobile Aurora

1 Answer

Oil light came on after oil change and new filter. garage said I should change the oil and another new filter. No good results. Oil light is still on, what now. Jeep liberty 2005


do not start vehicle ,drop the sump and clean it out with caustic ,also the oil pump pick up pipe ,then put the oil back in and start ,if ok then put half a litre of diesel into the oil and 3 good squirts of fairy liquid,then run engine for a week and change the oil again,use a cheap diesel /petrol oil from the supermarket ,not that fancy rip off synthetic long life ****.change oil every 6000 miles with a oil filter every third oil change

Apr 13, 2010 | 2002 Jeep Liberty

1 Answer

Just put some antifreeze in the oil tank by mistake


Take and drain all the oil out and if you have started it change the filter if you havent started it since adding antifreeze to the oil after draining all the oil out put the oil plug back in and fill with oil if you started it do change the oil filter and drain drain all the oil out and refill.

Dec 16, 2009 | 2005 Peugeot 405

2 Answers

Put wrong oil in chrysler 300 engine light came on i change oil to the right oil light still on


you may have sludged up the oil pump and now have too little pressure, get to a garage asap and get it checked before any engine damage occurs, if the light is on then the pressure is low and you risk a blown bottom end or worse.

Dec 06, 2009 | Chrysler 300C Cars & Trucks

1 Answer

After my oil change where 5w30 oil was put in engine, there is a tapping noise. i was told that i needed to replace the oil pump and rods because the wrong type of oil was used; it should have been 10w40...


you didnt state the mileage but I am assuming it s probably at least 100K or close to it. When you switch to a lower thickness oil some parts that are worn usually don't have any affect onthem but in this case it sounds like you are experiencing a valve lifter leak down. Provided that the 5w30 you put in was convemntional oil, just drain the thinner oil out and replace with the 10w 40 you normally put in. Also when you go to oil change places they will put the weight of oil that the manufacturer recomends in the vehicle unless you tell them otherwise so make sureyou tell them to put 10w 40 in when you change your oil. the tapping is a hydraulic part leaking down nothing more. swap the oil and the noise will go away, no need to replace the filter just the oil since it was just replaced.

Jun 12, 2009 | 1999 GMC Suburban

1 Answer

I do not know how to change the oil


Are you kidding,
1 Jack up your car
2 Find the oil plug on oil pan
3 loosen the plug- righty tighty lefty loosey
4 drain oil
5 put plug back in
6 put oil in engine

Apr 21, 2009 | 2005 Toyota Corolla

1 Answer

2004 jeep grand cherokee, 4.0, change oil without filter change,


Not sure why the question is even being asked, but you can change the oil yourself in about 15 minutes; simply jack the front end, put a pan under the oil drain plug, open the plug, let it drain, put the plug back in, and add new oil.

Take it to any outlet that changes oil (Wal-Mart, for example, charges about $18, some places charge as little as $15) and they'll include a new filter because otherwise you're running new oil through an old filter, which defeats the idea of the oil change. You can ask them not to put on a new filter, but you'll still pay the base price.

My question is, why would you not want a new filter if you're changing oil.

Let me know if this answers your question.

XMinusOne@gmail.com

Dec 10, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2006 Lincoln Mark LT Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...