Question about 2006 Ford Ka Streetka
Will not open from inside door handle floppy Had out side pass side dun 6 months ago Now this Can you help !!!!!!!!
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.
Posted on Feb 18, 2009
The plastic door handle is broken.
You will need to get a replacement door handle.
Go to http://www.flickr.com/photos/gtppilot/sets...57607539089979/
This should help. It is a set of photographs and instructions to do the job of replacing the handle.
Posted on Apr 10, 2009
SOURCE: 2001 Ford Explorer Sport
Common problem on 2001 Ford Explores. The reason why your door handle doesn't unlock the door(can't be unlocked by remote either)is due to a broken spring located on the backside of the door handel INSIDE the door. True that your one(or two) of your small exterior springs on your door handle are broken(will cause your handle to flap) but this IS NOT YOUR PROBLEM. The door locks will work if there is a bit of tension holding the handle bracket up. I know it's hard to explain without pics. but here's the ONLY WAY TO FIX THIS. It's not that hard.......... Remove the door panel, only a few screws and a few more holding trim around exit handle then, pull out "snap in" clips on bottom. With a flashlight you'll see back side of door handle. To get to that area you'll have to remove one bolt holding a window frame. Do that(with window in up position) then slide down rail, out of your way. Now, get back to handle. With your light aimed at the backside of handle left slowly the door handle as normal, and you'll realize(while looking at the mechanism) that tension(pulling down of bracket) needs to occur in order for locks(manual and remote)to work properly. Trust me.....you'll figure it out. Once you do, get a spring(pen spring, 30 cent hardware store spring, any small spring!) and hook one end to bracket and the other end to ANYTHING(OUT OF THE WAY) below the door handle thus, causing SLIGHT tension. Try your locks...THEY WILL WORK! YEAH! Replace that one window frame bolt(try your window...just the make sure), replace door panel and your done. TOTAL COST: 30 cents or FREE(if you have a small spring) Ford dealers will charge $150 to $285! Yikes!
Posted on Jun 14, 2009
There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.
Posted on Nov 14, 2009
Tips for a great answer:
Jan 05, 2016 | 2001 Ford Explorer
Dec 28, 2013 | 2006 Ford Fusion
Dec 05, 2012 | 2006 Buick Rendezvous
Apr 29, 2012 | 1998 BMW 740i L
Sep 27, 2011 | 2000 Chevrolet Cavalier
Aug 20, 2011 | 2006 Mercedes-Benz ML-Class
Jul 11, 2011 | 2004 Volvo XC90
May 20, 2011 | 1995 Chevrolet K1500
Dec 18, 2010 | 2008 Ford Edge
496 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: