Question about 1998 Jeep Grand Cherokee

1 Answer

What is the last step in replacing the rear brakes on a 1998 jeep grand cherokee? i have the new pads and rotors on, what comes next?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,674 Answers

Here's a link, check for your brake system & proper procedure steps.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800a9fe4

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear brake rotor noise


warp rotors tend to make noise at low or high speeds depending on the degree or how badly warped they are, if the brake pedal kick back when you apply the brake then you will have to get new rotors installed

Apr 25, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Squealing or clicking sound and then next day grinding sound louder when you take foot off accelerator clicking sounds from right side grinding underneath 2002 grand cherokee


Squealing usually indicates that the brakes are in need of replacement. There is a small piece of metal that as the brake pads wear comes in contact with the metal rotor. When the pads get close to being worn away the tab touches the rotor and it squeals. The tab can also click.
When the pads are worn away completely the metal backing comes in contact with the rotor and it grinds. Grinding is bad. It means the car's brakes are metal to metal. This will cause damage to the rotors resulting in an even more costly brake job.
You should have it taken care of ASAP.
I hope this helps.

Oct 16, 2009 | 2002 Jeep Grand Cherokee

3 Answers

2002 Jeep Grand Cherokee Laredo - whining noise driver's side


checked the wheel bearings and sometimes the clips will rub the rotors

Sep 08, 2009 | 2002 Jeep Grand Cherokee

1 Answer

Just replaced rotors and pads {front} and i hear a thump noise and steering wheel shimies a bit. 2002 jeep grand cherokee laredo


firstly make sure that the rotor and pad are the same with the former ones and secondly bleed the brake system to remove air fromthe syetem lastly check your wheel balancing. I hope this will help

Aug 11, 2009 | 2002 Jeep Grand Cherokee

2 Answers

1996 Jeep- rear rotors won't come off?


It's Hammer Time! Give it a few cracks with the hammer because it's froze on.

Jul 04, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Front rotors 1998 AWD jeep grand cherokee


All you have to do is jack the front end up off the ground, take the lug nuts off, pull the tire off, un bolt the caliper bolts off , take the caliper off , and rotors should come right out, do the opposite putting them back on . its simple.......

May 08, 2009 | 1998 Jeep Grand Cherokee

1 Answer

How do i get the pressure back on my abs brakes


you will need to bleed the brake before you get the pressure back in the pedal.. start with the right rear, left rear, right front and finally left front,, good luck keith...

Mar 21, 2009 | 1998 Jeep Grand Cherokee

3 Answers

When appling brakes on a 2000 Jeep Grand Cherokee, steeing wheel


New revised calipers. and have the new rotors machined right out of the box before installing

Dec 28, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...