Question about Hyundai Santa Fe

1 Answer

Starting problems my car it starts very heavy and after that sometime i rich on the second or four gear ane it stops .i have changed all it keeps of injection sistem (injectors ,fuel pomp, filterdiesel)also when it stops the chekc engine light is on and it stay on Some one it say that the problem it could be the EGR valve Ineed a advice what to do and how it looks the EGR valve

Posted by on

  • 2 more comments 
  • samaru78smr Jan 24, 2009

    it starts very heavy and it goes until the second or four gear demarage and it stops after 20,,30 seconds it start again with lamp chekc engine on and the problem it is repeting on and on .What i can do to fix the problem with this stops . at the service on the tester it apear the (p1181) code

  • samaru78smr Jan 27, 2009

    thanks but i have change the overpresure valve from the high presure line and its OK it is working better than before thanks anywai

  • Anonymous Mar 30, 2009

    I have 2003 Santa-fe and now I am having same problem. Any advise

  • yadayada
    yadayada May 11, 2010

    sorry but i don't really understand the question or what the SUV is doing..



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Hyundai Master
  • 78,267 Answers

U will need to replace the fuel pump and fuel filter to repair this issue.

Posted on Jan 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What's causing transmission problems?

You have a ground problem. Since it starts battery to engine ground is good. You need to check or add ground wires from the battery to the body, from the engine to body, and I put an extra ground wire from the transmission to the engine.

Jun 28, 2015 | 2008 Mitsubishi Raider

1 Answer

My 93 rm 250 started smoking heavy and loss power and is shooting oil in my air filter box

if a four cycle engine I would say either you have a lot of work ahead or engine replacement. The only way to find out is boroscope the cylinder to see for piston damage. or total teardown for rod damage. I think you blew it up.

Aug 02, 2012 | Suzuki Cars & Trucks

1 Answer

1995 Jeep Wrangler Auto Trans 1st to 2nd shift acts like it goes into neutral what could the problem be

When was the last time the transmission fluid and filter changed? I would have that serviced first. If it is an electronic transmission, the line pressure might also have to be reset.

Aug 15, 2017 | 1995 Jeep Wrangler

1 Answer

95 eagle vision esi slips out of gear at stops

there is a limp mode but I doubt if that is the problem
It indicates that the torque converter clutch servo/solenoid is faulty
run the fault codes to confirm if that is it or a faulty TCM
check wiring around the transmission

Apr 19, 2017 | 1995 Eagle Vision

2 Answers

What is the second drive gear for

The first one is over drive and the second is drive. It is best to just use overdrive when on the parkway and drive on slower back roads when there is hills and stop and go traffic. Overdrive is a higher gear.

Dec 09, 2011 | 1998 Ford Taurus

1 Answer

1996 Auto Jetta "jerking" into 1st and 2nd gears

have shop road test and scan possible solinoid

Apr 21, 2010 | 1996 Volkswagen Jetta

1 Answer

Epica 2006 automatic transmission problem

I'd check your motor mounts, sounds like the shifter is just misaligned, they're adjustale

Aug 11, 2009 | 2004 Chevrolet Aveo

2 Answers

4X4 will not transfer power to the front wheels

On the front axle is the axle actuator. It is a common problem for that model truck. It is not expensive and easy to change. It just screws into the axle, has 2 wires and all you need to change it is channel lock plires. Good Luck

May 09, 2009 | 1996 Chevrolet Blazer

2 Answers

Sometimes the car only has second gear, sometimes it has all gear

i had the same problem its most likley the tcu, transmisson control unit. its located under the carpet on the passinger side floor board.

Feb 21, 2009 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides